參數資料
型號： SP3243E
英文描述： Intelligent +3.0V to +5.5V RS-232 Transceivers(智能+3.0V 至 +5.5V RS-232收發器（3發5收）)
中文描述： 智能3.0V至5.5V的RS - 232收發器（智能3.0V至5.5V的RS - 232接口收發器（3發5收））
文件頁數： 17/24頁
文件大?。?/td> 235K
代理商： SP3243E
17
SP3223EDS/20
SP3223E +3.0V to +5.5V RS-232 Transceivers
Copyright 2000 Sipex Corporation
Auto-Online Circuitry
The
SP3223E
and
SP3243E
devices have a
patent pending
Auto-Online
circuitry on board
that saves power in applications such as laptop
computers, palmtop (PDA) computers, and other
portable systems.
The
SP3223E
and
SP3243E
devices incorporate
an
Auto-Online
circuit that automatically
enables itself when the external transmitters are
enabled and the cable is connected. Conversely,
the
Auto-Online
circuit also disables most of the
internal circuitry when the device is not being
used and goes into a standby mode where the
device typically draws 1
μ
A. This function can
also be externally controlled by the ONLINE
pin. When this pin is tied to a logic LOW, the
Auto-Online
function is active. Once active, the
device is enabled until there is no activity on the
receiver inputs. The receiver input typically sees
at least
±
3V, which are generated from the
transmitters at the other end of the cable with a
±
5V minimum. When the external transmitters
are disabled or the cable is disconnected, the
receiver inputs will be pulled down by their
internal 5k
resistors to ground. When this
occurs over a period of time, the internal
transmitters will be disabled and the device goes
into a shutdown or standy mode. When ONLINE
is HIGH, the
Auto-Online
mode is disabled.
The
Auto-Online
circuit has two stages:
1) Inactive Detection
2) Accumulated Delay
The first stage, shown in
Figure 23
, detects an
inactive input. A logic HIGH is asserted on
R
INACT if the cable is disconnected or the
external transmitters are disabled. Otherwise,
R
INACT will be at a logic LOW. This circuit
is duplicated for each of the other receivers.
The second stage of the
Auto-Online
circuitry,
shown in
Figure 24
, processes all the receiver's
R
INACT signals with an accumulated delay
that disables the device to a 1
μ
A supply current.
The STATUS pin goes to a logic LOW when the
cable is disconnected, the external transmitters
are disabled, or the SHUTDOWN pin is
invoked. The typical accumulated delay is
around 20
μ
s.
When the
SP3223E
and
SP3243E
drivers or
internal charge pump are disabled, the supply
current is reduced to 1
μ
A. This can commonly
occur in hand-held or portable applications where
the RS-232 cable is disconnected or the RS-232
drivers of the connected peripheral are turned off.
The
Auto-Online
mode can be disabled by the
SHUTDOWN pin. If this pin is a logic LOW,
the
Auto-Online
function will not operate
regardless of the logic state of the ONLINE pin.
Table 3
summarizes the logic of the
Auto-Online
operating modes. The truth table logic of the
SP3223E
and
SP3243E
driver and receiver
outputs can be found in
Table 2.
The STATUS pin outputs a logic LOW signal
if the device is shutdown. This pin goes to a
logic HIGH when the external transmitters are
enabled and the cable is connected.
When the
SP3223E
and
SP3243E
devices
are shut down, the charge pumps are turned off.
V+ charge pump output decays to V
, the
V- output decays to GND. The decay time will
depend on the size of capacitors used for the
charge pump. Once in shutdown, the time
required to exit the shut down state and have
valid V+ and V- levels is typically 200
μ
s.
For easy programming, the STATUS can be
used to indicate DTR or a Ring Indicator signal.
Tying ONLINE and SHUTDOWN together
will bypass the
Auto-Online
circuitry so this
connection acts like a shutdown input pin.
相關PDF資料
PDF描述
SP3483 3.3V Low Power Slew Rate Limited Half-Duplex RS-485/RS-422 Transceiver(3.3V,低功耗，轉換速率限制，半雙工RS-485/RS-422收發器)
SP3483CN +3.3V Low Power Slew Rate Limited Half-Duplex RS-485 Transceiver
SP3483CP +3.3V Low Power Slew Rate Limited Half-Duplex RS-485 Transceiver
SP3483EN +3.3V Low Power Slew Rate Limited Half-Duplex RS-485 Transceiver
SP3483EP +3.3V Low Power Slew Rate Limited Half-Duplex RS-485 Transceiver
相關代理商/技術參數
參數描述
SP3243EA 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Intelligent +3.0V to +5.5V RS-232 Transceivers
SP3243EB 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Intelligent +3.0V to +5.5V RS-232 Transceivers
SP3243EBCA 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述:
SP3243EBCA/TR 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Intelligent +3.0V to +5.5V RS-232 Transceivers
SP3243EBCA-L 功能描述:RS-232接口集成電路 RS232 250 kbps 3Tx temp 0C to 70C RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*