- 您現在的位置：買賣IC網 > PDF目錄10226 > SP3220EUEY-L/TR (Exar Corporation)IC DVR/RCVR RS232 ESD 16TSSOP PDF資料下載
參數資料
| 型號： | SP3220EUEY-L/TR |
| 廠商： | Exar Corporation |
| 文件頁數： | 4/21頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DVR/RCVR RS232 ESD 16TSSOP |
| 標準包裝： | 2,500 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 1/1 |
| 規程： | RS232 |
| 電源電壓： | 3 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 帶卷 (TR) |
| 其它名稱： | SP3220EUEY-L/TR-ND |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁
12
Exar Corporation 48720 Kato Road, Fremont CA, 94538 510-668-7017 www.exar.com
SP3220E_EB_EU_101_060311
DESCRIPTION
Charge Pump Design Guidelines
The charge pump operates with 0.1F ca-
pacitors for 3.3V operation. For other supply
voltages, see the table for required capacitor
values. Do not use values smaller than those
listed. Increasing the capacitor values (e.g.,
by doubling in value) reduces ripple on the
transmitter outputs and may slightly reduce
power consumption. C2, C3, and C4 may be
increased without changing C1’s value.
Minimum recommended charge pump
capacitor value
Input Voltage
Vcc
Charge pump
capacitor value for
SP3220E/EB/EU
3.0V to 3.6V
C1 - C4 = 0.1F
3.0V to 5.5V
C1 - C4 = 0.22F
Thechargepumposcillatortypicallyoperates
at greater than 250kHz allowing the pump to
run efficiently with small 0.1μF capacitors.
Efficientoperationdependsonrapidlycharg-
ing and discharging C1 and C2, therefore
capacitors should be mounted close to the
IC and have low ESR (equivalent series
resistance).
Low cost surface mount ceramic capacitors
(such as are widely used for power-supply
decoupling) are ideal for use on the charge
pump. However the charge pumps are de-
signed to be able to function properly with a
wide range of capacitor styles and values.
If polarized capacitors are used the positive
and negative terminals should be connected
as shown in the Typical Operating Circuit.
Voltage potential across any of the capaci-
tors will never exceed 2 x VCC. Therefore
capacitors with working voltages as low as
6.3V rating may be used with a 3.0V VCC
supply. The reference terminal of the V+
capacitor may be connected either to VCC
or ground, but if connected to ground a
minimum 10V working voltage is required.
Higher working voltages and/or capacitance
values may be advised if operating at higher
VCC or to provide greater stability as the
capacitors age.
Underlightlyloadedconditionstheintelligent
pump oscillator maximizes efficiency by
running only as needed to maintain V+ and
V-. Since interface transceivers often spend
much of their time at idle this power-efficient
innovation can greatly reduce total power
consumption. This improvement is made
possiblebytheindependentphasesequence
of the Exar charge-pump design.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-212-IU-F3 | CONVERTER MOD DC/DC 15V 200W |
| VE-212-IU-F4 | CONVERTER MOD DC/DC 15V 200W |
| MIC2550AYTS TR | IC USB TRANSCEIVER 14-TSSOP |
| VE-212-IU-F2 | CONVERTER MOD DC/DC 15V 200W |
| MS3106E28-7P | CONN PLUG 2POS STRAIGHT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP3220EY | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:+3.0V to +5.5V RS-232 Driver/Receiver Pair |
| SP3220U | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:High Speed +3.0V to +5.5V RS-232 Driver/Receiver Pair |
| SP3220UCA | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:High Speed +3.0V to +5.5V RS-232 Driver/Receiver Pair |
| SP3220UCT | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:High Speed +3.0V to +5.5V RS-232 Driver/Receiver Pair |
| SP3220UCY | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:High Speed +3.0V to +5.5V RS-232 Driver/Receiver Pair |
發布緊急采購，3分鐘左右您將得到回復。