- 您現在的位置：買賣IC網 > PDF目錄8718 > SL2309ZI-1T (Silicon Laboratories Inc)IC BUFFER 140MHZ 9CH3.3V 16TSSOP PDF資料下載
參數資料
| 型號： | SL2309ZI-1T |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 11/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC BUFFER 140MHZ 9CH3.3V 16TSSOP |
| 標準包裝： | 2,500 |
| 系列： | EProClock® |
| 類型： | * |
| PLL： | 帶旁路 |
| 輸入： | 時鐘 |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:9 |
| 差分 - 輸入:輸出： | 無/無 |
| 頻率 - 最大： | 140MHz |
| 除法器/乘法器： | 無/無 |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | * |
| 封裝/外殼： | * |
| 供應商設備封裝： | * |
| 包裝： | * |
Rev 1.3, July 31, 2007
Page 8 of 12
SL2309
External Components & Design Considerations
Typical Application Schematic
SL2309
CL
0.1
μF
0.1
μF
CLKIN
CLKOUT
CLKA1
CLKB4
GND
S1
S2
VDD
1
4
13
9
8
5
12
11
2
16
VDD
Comments and Recommendations
Decoupling Capacitor:
A decoupling capacitor of 0.1μF must be used between VDD and VSS pins. Place the capacitor s
on the component side of the PCB as close to the VDD pins as possible. The PCB trace to the VDD pin and to the GND
via should be kept as short as possible. Do not use vias between the decoupling capacitor and the VDD pin.
Series Termination Resistor: A series termination resistor is recommended if the distance between the output clocks and
the load is over 1 inch. The nominal impedance of the clock outputs is given on the page 4. Place the series termination
resistors as close to the clock outputs as possible.
Zero Delay and Skew Control: All outputs and CLKIN pins should be loaded with the same load to achieve “Zero Delay”
between the CLKIN and the outputs. The CLKOUT pin is connected to CLKIN internally on-chip for feedback to PLL, and
sees an additional 2 pF load with respect to Bank A and B clocks. For applications requiring zero input/output delay, the
load at the all output pins including the CLKOUT pin must be the same. If any delay adjustment is required, the
capacitance at the CLKOUT pin could be increased or decreased to increase or decrease the delay between Bank A and
B clocks and CLKIN.
For minimum pin-to-pin skew, the external load at all the Bank A and B clocks must be the same.
相關PDF資料 |
PDF描述 |
|---|---|
| AD5662BRJ-1REEL7 | IC DAC 16BIT BUFF V-OUT SOT23-8 |
| SL2309SI-1HT | IC BUFFER 140MHZ 9CH 3.3V 16SOIC |
| SL23EP09SI-1 | IC BUFFER 220MHZ 9CH 3.3V 16SOIC |
| AD5321BRTZ-REEL7 | IC DAC 12BIT 2WIRE I2C SOT23-6 |
| SL23EP09ZI-1T | IC BUFFER 220MHZ 9CH3.3V 16TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SL231-06-1-281 | 制造商:U.S. TERMINALS 功能描述: |
| SL231-3-1-281 | 制造商:SHUR-LOK 功能描述: |
| SL232K-001 | 功能描述:ADAPTER SGL SRL 250KBPS 2.4GHZ RoHS:是 類別:RF/IF 和 RFID >> RF 接收器、發射器及收發器的成品裝置 系列:彈簧扣環 標準包裝:5 系列:MultiModem® iCell 功能:收發器，HSPA，調制解調器 調制或協議:GPRS，GSM，EDGE 頻率:850MHz，900MHz，1.8GHz，1.9GHz 應用:- 接口:RS-232，USB 靈敏度:- 功率 - 輸出:- 數據傳輸率 - 最大:7.2 Mbps 特點:- 電源電壓:9 V ~ 32 V，USB 其它名稱:881-1125 |
| SL2334-06A5 | 制造商: 功能描述: 制造商:undefined 功能描述: |
| SL2334-08A3 | 制造商:SHUR-LOK 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。