- 您現在的位置：買賣IC網 > PDF目錄10997 > SI3210M-FT (Silicon Laboratories Inc)IC SLIC/CODEC PROG 1CH 38TSSOP PDF資料下載
參數資料
| 型號： | SI3210M-FT |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 87/148頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SLIC/CODEC PROG 1CH 38TSSOP |
| 標準包裝： | 50 |
| 系列： | ProSLIC® |
| 功能： | 用戶線路接口概念（SLIC），CODEC |
| 接口： | PCM，SPI |
| 電路數： | 1 |
| 電源電壓： | 3.3V，5V |
| 電流 - 電源： | 88mA |
| 功率（瓦特）： | 700mW |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 38-TFSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 38-TSSOP |
| 包裝： | 管件 |
| 包括： | BORSCHT 功能，DTMF 生成和解碼，F(xiàn)SK 生成，脈沖測量生成，語音回送測試模式 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁當前第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁
Si3210/Si3211
Rev. 1.61
43
Not
Recommended
fo
r N
ew
D
esi
gn
s
Figure 21. Tone Generator Timing Diagram
2.3.4. Enhanced FSK Waveform Generation
Silicon revisions C and higher support enhanced FSK
generation capabilities, which can be enabled by setting
FSKEN = 1 (direct Register 108, bit 6) and REN = 1
(direct Register 32, bit 6). In this mode, the user can
define mark (1) and space (0) attributes once during
initialization by defining indirect registers 99–104. The
user need only indicate 0-to-1 and 1-to-0 transitions in
the information stream. By writing to FSKDAT (direct
Register 52), this mode applies a 24 kHz sample rate to
tone generator 1 to give additional resolution to timers
and frequency generation. “AN32: Si321x Frequency
Shift
Keying
(FSK)
Modulation”
gives
detailed
instructions on how to implement FSK in this mode.
Additionally, sample source code is available from
Silicon Laboratories upon request.
2.3.5. Tone Generator Interrupts
Both the active and inactive timers can generate their
own interrupt to signal “on/off” transitions to the
software. The timer interrupts for tone generator 1 can
be individually enabled by setting the O1AE and O1IE
bits (direct Register 21, bits 0 and 1, respectively).
Timer interrupts for tone generator two are O2AE and
O2IE (direct Register 21, bits 2 and 3, respectively). A
pending interrupt for each of the timers is determined by
reading the O1AP, O1IP, O2AP, and O2IP bits in the
Interrupt Status 1 register (direct Register 18, bits 0
through 3, respectively).
2.4. Ringing Generation
The ProSLIC provides fully-programmable internal
balanced ringing with or without a dc offset to ring a
wide variety of terminal devices. All parameters
associated with ringing (ringing frequency, waveform,
amplitude, dc offset, and ringing cadence) are software-
programmable. Both sinusoidal and trapezoidal ringing
waveforms are supported, and the trapezoidal crest
factor is programmable. Ringing signals of up to 88 V
peak or more can be generated, enabling the ProSLIC
to drive a 5 REN (1380
+ 40 F) ringer load across
loop lengths of 2000 feet (160
) or more.
2.4.1. Ringing Architecture
The ringing generator architecture is nearly identical to
that of the tone generator. The sinusoidal ringing
waveform is generated using an internal two-pole
resonance
oscillator
circuit
with
programmable
frequency and amplitude. However, since ringing
frequencies are very low compared to the audio band
signaling
frequencies,
the
ringing
waveform
is
generated at a rate of 1 kHz instead of 8 kHz.
The ringing generator has two timers that function the
same as the tone generator timers. They allow on/off
cadence settings of up to 8 seconds on and 8 seconds
off. In addition to controlling ringing cadence, these
timers control the transition into and out of the ringing
state. Table 30 summarizes the list of registers used for
ringing generation.
Note: Tone generator 2 should not be enabled concurrently
with the ringing generator due to resource sharing
within the hardware.
...
0,1
...
0,1
...
..., OAT1
..., OIT1
0,1
...
0,1
...
O1E
Tone
G en. 1
Signal
O utput
相關PDF資料 |
PDF描述 |
|---|---|
| VI-2NZ-IV-S | CONVERTER MOD DC/DC 2V 60W |
| VI-2NK-IX-S | CONVERTER MOD DC/DC 40V 75W |
| SI3210-FTR | IC SLIC/CODEC PROGRAMMBL 38TSSOP |
| VI-2NJ-IX-S | CONVERTER MOD DC/DC 36V 75W |
| VI-2NH-IY-B1 | CONVERTER MOD DC/DC 52V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI3210M-FTR | 功能描述:電信線路管理 IC 1-Ch SLIC/Codec DTMF Decoder dcdc convrtr RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| SI3210M-GT | 功能描述:IC SLIC/CODEC PROG 1CH 38TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 電信 系列:ProSLIC® 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
| SI3210M-KT | 功能描述:電信線路管理 IC Single-Channel SLIC/Codec with DTMF decoder and MOSFET/transformer dc-dc converter RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| SI3210M-KTR | 功能描述:射頻無線雜項 Sgl Ch SLIC/Codec w/ MOSFET Decoder RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel |
| SI3210MPPQ1-EVB | 功能描述:音頻 IC 開發工具 Si3210M QFN Eval Board RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
發布緊急采購，3分鐘左右您將得到回復。