參數資料
型號: SI2404-D-GT
廠商: Silicon Laboratories Inc
文件頁數: 19/60頁
文件大小: 0K
描述: IC ISOMODEM GLOBAL DAA 24TSSOP
標準包裝: 62
系列: *
Si2457/34/15/04
26
Rev. 1.3
+ESA Options
+ESA = A
+ESA = A,B
+ESA = A,B,C
+ESA = A,B,C,E
+ESA = A,B,C,E,F
+ESA = A,B,C,E,F,
G
Synchronous access mode control options
A
Specifies action taken if an underrun condition occurs during transparent sub-mode.
0
Modem transmits 8-bit SYN sequences on idle.
B
Specifies action taken if an underrun condition occurs after a flag during framed sub-
mode
0 Modem transmits 8-bit HDLC flags on idle.
C
Specifies action taken if an underrun or overrun condition occurs after a non-flag during
framed sub-mode.
0
Modem transmits abort on underrun in middle of frame.
1
Modem transmits flag on underrun in middle of frame and notifies host of underrun
or overrun.
D
Specifies V.34 half duplex operation.
This parameter should not be used.
E
Specifies CRC polynomial used while in framed sub-mode.
0 CRC generation checking disable.
1 16-bit CRC generation and checking is performed by the modem.
F
Specifies NRZI encoding and decoding.
0
NRZI encoding and decoding disabled.
G
Specifies SYN.
255
+FCLASS = X
Class 1 Mode Enable for V.29 fast connect.
X
Mode
0Off
1
Enables support for Class 1 mode for use in the V.29 fast connect mode.
+FRM = X
Class 1 Receive Carrier for V.29 fast connect.
X
Mode
2
Transmit V.21 (980 Hz) tone for longer than 100 ms, then send answer tone
(2100/2225 Hz) for 200 ms.
95
V.29 short synchronous.
96
V.29 full synchronous.
+FTM = X
Class 1 Transmit Carrier for V.29 fast connect.
X
Mode
2
Transmit V.21 (980 Hz) tone.
53
Same as &T4, but transmit V.29 7200 bps. Data pattern set by S40 register. AT +
FCLASS = 0 must be sent to restore the ISOmodem to normal operation after
test.
54
Same as &T4, but transmit V.29 9600 bps. Data pattern set by S40 register. AT +
FCLASS = 0 must be sent to restore the ISOmodem to normal operation after test.
95
V.29 short synchronous.
96
V.29 full synchronous.
Table 8. Basic AT Command Set (Command Defaults in Bold) (Continued)
Command
Action
相關PDF資料
PDF描述
PIC16C66/JW IC MCU OTP 8KX14 PWM 28CDIP
DS5000-32-16+ IC MPU 32KB 16MHZ 40-DIP
DS5000-32-16 IC MPU 32KB 16MHZ 40-DIP
DS2250-64-16# IC MCU 64KB 16MHZ 40-SIMM
DS2250T-32-16 IC MICROCNTRLR 32X8 16MHZ 40SIMM
相關代理商/技術參數
參數描述
SI2404-D-GTR 制造商:Silicon Laboratories Inc 功能描述:2400 BPS ISOMODEM WITH ERROR CORRECTION SYSTEM-SIDE - - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC ISOMODEM GLOBAL DAA 24TSSOP 制造商:Silicon Laboratories Inc 功能描述:2401 bps ISOmodem Error Correction
Si2404FS08-EVB 功能描述:網絡開發工具 16-pin Si2404+Si3008 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
Si2404FS10-EVB 功能描述:網絡開發工具 16-pin Si2404+Si3010 ISO modem Eval Board RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
SI2404-FT 功能描述:電信線路管理 IC CONTACT SILICON LABS FOR AVAILABILITY RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
Si2404FT08-EVB 功能描述:網絡開發工具 24-pin Si2404+Si3008 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V