- 您現在的位置：買賣IC網 > PDF目錄382500 > SG6105A (Fairchild Semiconductor Corporation) Power Supply Supervisor + Regulator + PWM PDF資料下載
參數資料
| 型號： | SG6105A |
| 廠商： | Fairchild Semiconductor Corporation |
| 英文描述： | Power Supply Supervisor + Regulator + PWM |
| 中文描述： | 監穩壓電源的PWM |
| 文件頁數： | 13/18頁 |
| 文件大?。?/td> | 597K |
| 代理商： | SG6105A |
Product Specification
Power Supply Supervisor + Regulator + PWM
SG6105A
System General Corp.
Version 1.0.1 (IAO33.0072.B0)
- 13 -
www.sg.com.tw www.fairchildsemi.com
September 25, 2007
Example of Using SG6105A for the ATX
Power Supply
Protection against over-voltage, short-circuit, and fault
conditions is mandatory in PC power supplies. These
protection circuits can be realized by using many discrete
components and comparators, which occupy a lot of PCB
space and add to assembling costs. This single chip
controller IC provides complete protection circuits, shunt
regulators, and PWM control function with fewer
components. SG6105A is an ideal controller IC for PC
switching mode power supplies.
The features and benefits of this device are:
Over-voltage and under-voltage protection for 3.3V,
5V, and 12V without external divider
Over-power protection
UV protection for –12V and/or –5V
Power-down warning for power-good signal
Power-good signal and power-fail lockup
Remote on/off control
Delay time for PSON and PS-off signal
Two shunt regulators for 3.3V and 5V-standby
regulation
Complete pulse width modulation (PWM) control
circuitry
On-chip oscillator
Programmable soft-start
Maximum 93% duty cycle
Few external components
More reliable system
Little space on PCB
Easy trouble-shooting and implementation
FEATURE DESCRIPTIONS
Over-voltage protection can be implemented
without any additional components. Over-voltage
sense levels for 3.3V, 5V, 12V, are 4.1V, 6.1V,
14.5V, respectively.
Over-current
and/or short-circuit protection can also
be achieved using over-power protection, in which
the OPP pin is connected to the current transformer
(driver transformer).
The power-good signal is asserted to indicate the
3.3V, 5V, and 12V is above the under-voltage
threshold level. PG pin goes high when the above
condition is reached. A 2K pull-up resistor may
connect to 5V.
The V
CC
can be supplied from the 5V-standby.
When the V
CC
voltage is higher than 7V, besides
the shunt regulator, the circuit is shutdown and reset.
No extra power supply is needed.
Two internal high-precision 431 shunt regulators are
built-in to provide stable reference voltages.
Complete PWM control circuitry, including the
error amplifier for push-pull or half-bridge
operation.
Supervisory Circuit Operation
The PC generates the remote ON/OFF logic
(PSON), which is “Low” for power supply on and “High”
to switch off the power supply. The remote ON/OFF is
connected to PSON input.
APPLICATION GUIDES
Introduction
The application guide shows the key features of SG6105A
and illustrates how to design in an ATX switching mode
power supply (SMPS). SG6105A is suitable for
half-bridge, push-pull topology and incorporates with a
four-channel supervisor, including 5V-standby. The PWM
section of SG6105A comprises a built-in 65kHz oscillator
and high-immunity circuits, which protect the system
from noise interference and provide more noise margins
for improper PCB layout. SG6105A has OVP and UVP
for 12V, 5V, and 3.3V. NVP is used for negative voltage
protection, such as –12V and/or –5V. The UVAC (AC
fails detection) is applied to detect AC line condition.
Two built-in internal precision TL431 shunt regulators
can be used for 3.3V or 5V auxiliary standby power.
AC Fails Detection
Through a resistor divider, UVAC is connected to the
secondary power transformer for detecting the AC line
condition. Once the voltage of UVAC is lower than 0.7V
for a period of time, such as 200μs, the PG (power-good)
signal is pulled low to indicate an AC line power-down
condition. The voltage amplitude of the PWM switching
相關PDF資料 |
PDF描述 |
|---|---|
| SG6105ADZ | Power Supply Supervisor + Regulator + PWM |
| SG6108 | Power Supply Supervisor + PWM |
| SG6108DZ | Power Supply Supervisor + PWM |
| SG6203 | Synchronous Rectifier Controller for Flyback Converter |
| SG6203DZ | Synchronous Rectifier Controller for Flyback Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SG6105A_09 | 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:Power Supply Supervisor Regulator PWM |
| SG6105ADY | 功能描述:監控電路 Switching Mode Power Supply Contrl RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| SG6105ADZ | 功能描述:監控電路 Power Supply Sprvsr + Regulator + PWM RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| SG6105ADZ_F116 | 功能描述:監控電路 Power Supply Sprvsr Regulator + PWM RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| SG6105D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Supply Supervisor + Regulator + PWM |
發布緊急采購，3分鐘左右您將得到回復。