- 您現在的位置：買賣IC網 > PDF目錄376340 > SCANPSC110FFMQB (NATIONAL SEMICONDUCTOR CORP) SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support) PDF資料下載
參數資料
| 型號： | SCANPSC110FFMQB |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support) |
| 中文描述： | SPECIALTY MICROPROCESSOR CIRCUIT, CDFP28 |
| 封裝： | FP-28 |
| 文件頁數： | 10/29頁 |
| 文件大?。?/td> | 459K |
| 代理商： | SCANPSC110FFMQB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
Level 1 Protocol
(Continued)
TABLE 4. SCANPSC110F Bridge Address Modes
Address Types
Hex Address
(Note 2)
00 to 3A
3B
3C
3D
3E
3F
Binary Address
(Note 3)
XX000000 to XX111010
XX111011
XX111100
XX111101
XX111110
XX111111
TDO
B
State
Direct Address
Broadcast Address
Multi-Cast Group 0
Multi-Cast Group 1
Multi-Cast Group 2
Multi-Cast Group 3
Normal IEEE Std. 1149.1
Always TRI-STATED
Always TRI-STATED
Always TRI-STATED
Always TRI-STATED
Always TRI-STATED
Note 2:
Hex address ’7X’, ’BX’, or ’FX’ may be used instead of ’3X’.
Note 3:
Only the six (6) LSB’s of the address is compared to the S
(0–5)
inputs. The two (2) MSB’s are “don’t cares”.
DIRECT ADDRESSING
The ’PSC110F enters the Wait-For-Address state when:
1.
its TAP Controller enters the Test-Logic-Reset state, or
2.
its instruction register is updated with the GOTOWAIT in-
struction (while either selected or unselected).
Each ’PSC110F within a scan network must be statically
configured with a unique address via its S
inputs. While
the ’PSC110F controller is in the Wait-For-Address state,
data shifted into bits 5 through 0 of the instruction register is
compared with the address present on the S
inputs in
the Update-IRstate. If the six (6) LSBs of the instruction reg-
ister match the address on the S
inputs, (see Figure 6 )
the ’PSC110F becomes selected, and is ready to receive
Level 2 Protocol (i.e., further instructions). When the
’PSC110F is selected, its device identification register is in-
serted into the active scan chain.
All ’PSC110Fs whose S
address does not match the in-
struction register address become unselected. They will re-
main unselected until either their TAP Controller enters the
Test-Logic-Reset state, or their instruction register is up-
dated with the GOTOWAIT instruction.
BROADCAST ADDRESSING
The Broadcast Address allows a tester to simultaneously se-
lect all ’PSC110Fs in a test network. This mode is useful in
testing systems which contain multiple identical boards. To
avoid bus contention between scan-path output drivers on
different boards, each ’PSC110F’s TDO
buffer is always
tri-stated while in Broadcast mode. In this configuration, the
on-chip Linear Feedback Shift Register (LFSR) can be used
to accumulate a test result signature for each board that can
be read back later by direct-addressing each board’s
’PSC110F.
MULTI-CAST ADDRESSING
As a way to make the broadcast mechanism more selective,
the ’PSC110F provides a “Multi-cast” addressing mode. A
’PSC110F’s multi-cast group register (MCGR) can be pro-
grammed to assign that ’PSC110F to one of four (4)
Multi-Cast
groups.
When
Wait-For-Address state are updated with a Multi-Cast ad-
dress, all ’PSC110Fs whose MCGR matches the Multi-Cast
group will become selected. As in Broadcast mode, TDO
B
is
always tri-stated while in Multi-cast mode.
’PSC110Fs
in
the
DS100327-7
FIGURE 6. Direct Addressing: Device Address Loaded into Instruction Register
S
www.national.com
10
相關PDF資料 |
PDF描述 |
|---|---|
| SCANPSC110FLMQB | SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support) |
| SCANSTA101 | RES 30K OHM 1/16W 0.1% 0402 SMD |
| SCANSTA111SM | EMITTER IR 850NM 5MM RADIAL |
| SCANSTA111 | Enhanced SCAN bridge Multidrop Addressable IEEE 1149.1 (JTAG) Port |
| SCANSTA111MT | Enhanced SCAN bridge Multidrop Addressable IEEE 1149.1 (JTAG) Port |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SCANPSC110FLMQB | 功能描述:IC BRIDGE LCC SCAN MUL JTAG PORT RoHS:否 類別:集成電路 (IC) >> 接口 - 專用 系列:* 標準包裝:3,000 系列:- 應用:PDA，便攜式音頻/視頻，智能電話 接口:I²C，2 線串口 電源電壓:1.65 V ~ 3.6 V 封裝/外殼:24-WQFN 裸露焊盤 供應商設備封裝:24-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) 安裝類型:表面貼裝 產品目錄頁面:1015 (CN2011-ZH PDF) 其它名稱:296-25223-2 |
| SCANPSC110FSC | 功能描述:特定功能邏輯 SCAN JTAG Port RoHS:否 制造商:Texas Instruments 產品: 系列:SN74ABTH18502A 工作電源電壓:5 V 封裝 / 箱體:LQFP-64 封裝:Tube |
| SCANPSC110FSCX | 功能描述:特定功能邏輯 SCAN JTAG Port RoHS:否 制造商:Texas Instruments 產品: 系列:SN74ABTH18502A 工作電源電壓:5 V 封裝 / 箱體:LQFP-64 封裝:Tube |
| SCANSTA101 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Voltage IEEE 1149.1 STA Master |
| SCANSTA101_06 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Voltage IEEE 1149.1 STA Master |
發布緊急采購，3分鐘左右您將得到回復。