- 您現在的位置：買賣IC網 > PDF目錄1967 > SC16C652BIB48,157 (NXP Semiconductors)IC ENCODER/DECODER IRDA 48LQFP PDF資料下載
參數資料
| 型號： | SC16C652BIB48,157 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 6/21頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ENCODER/DECODER IRDA 48LQFP |
| 標準包裝： | 1,250 |
| 特點： | 2 通道 |
| 通道數： | 2，DUART |
| FIFO's： | 32 字節 |
| 電源電壓： | 2.5V，3.3V，5V |
| 帶自動流量控制功能： | 是 |
| 帶IrDA 編碼器/解碼器： | 是 |
| 帶故障啟動位檢測功能： | 是 |
| 帶調制解調器控制功能： | 是 |
| 帶CMOS： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 托盤 |
| 其它名稱： | 935274409157 SC16C652BIB48 SC16C652BIB48-ND |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁
SC16C652B_4
Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet
Rev. 04 — 1 September 2005
14 of 43
Philips Semiconductors
SC16C652B
Dual UART with 32-byte FIFOs and IrDA encoder/decoder
6.11 Sleep mode
Sleep mode is an enhanced feature of the SC16C652B UART. It is enabled when EFR[4],
the enhanced functions bit, is set and when IER[4] of both channels are set. Sleep mode
is entered when:
Modem input pins are not toggling.
The serial data input line, RX, is idle (logic HIGH).
The TX FIFO and TX shift register are empty.
There are no interrupts pending.
Remark: Sleep mode will not be entered if there is data in the RX FIFO.
In Sleep mode, the UART clock and baud rate clock are stopped. Since most registers are
clocked using these clocks, the power consumption is greatly reduced.
Remark: Writing to the divisor latches, DLL and DLH, to set the baud clock, must not be
done during Sleep mode. Therefore, it is advisable to disable Sleep mode using IER[4]
before writing to DLL or DLH.
SC16C652B resumes normal operation by any of the following:
Receives a start bit on RXA/RXB pin.
Data is loaded into transmit FIFO.
A change of state on any of the modem input pins
If the device is awakened by one of the conditions described above, it will return to the
Sleep mode automatically after the last character is transmitted or read by the user. The
device will stay in Sleep mode until it is disabled by setting any channel’s IER bit 4 to a
logic 0.
相關PDF資料 |
PDF描述 |
|---|---|
| SC16C654BIBS,557 | IC QUAD UART 64BYTE 48HVQFN |
| SC16C750BIB64,151 | IC UART SINGLE W/FIFO 64-LQFP |
| SC16C752BIBS,157 | IC DUAL UART 64BYTE 32HVQFN |
| SC16C752IB48,128 | IC DUAL UART 64BYTE 48LQFP |
| SC16C754BIB80,557 | IC UART QUAD W/FIFO 80-LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC16C652BIB48-F | 功能描述:UART 接口集成電路 16CB 2.5V-5V 2CH UART 32B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C652BIB48-S | 制造商:NXP Semiconductors 功能描述:UART 2-CH 32Byte FIFO 2.5V/3.3V/5V 48-Pin LQFP Tray |
| SC16C652BIBS | 功能描述:UART 接口集成電路 16CB 2.5V-5V 2CH UART 32B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C652BIBS,128 | 功能描述:UART 接口集成電路 16CB 2.5V-5V 2CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C652BIBS,151 | 功能描述:UART 接口集成電路 16CB 2.5V-5V 2CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。