參數資料
型號： SC16C650BIBS,128
廠商： NXP Semiconductors
文件頁數： 20/48頁
文件大?。?/td> 0K
描述： IC UART SOT617-1
標準包裝： 6,000
通道數： 1，UART
FIFO's： 32 字節
電源電壓： 2.5V，3.3V，5V
帶自動流量控制功能： 是
帶IrDA 編碼器/解碼器： 是
帶故障啟動位檢測功能： 是
帶調制解調器控制功能： 是
帶CMOS： 是
安裝類型： 表面貼裝
封裝/外殼： 32-VFQFN 裸露焊盤
供應商設備封裝： 32-HVQFN（5x5）
包裝： 帶卷 (TR)
其它名稱： 935276404128
SC16C650BIBS-F
SC16C650BIBS-F-ND
SC16C650B_4
NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 04 — 14 September 2009
27 of 48
NXP Semiconductors
SC16C650B
UART with 32-byte FIFOs and IrDA encoder/decoder
7.9 Scratchpad Register (SPR)
The SC16C650B provides a temporary data register to store 8 bits of user information.
7.10 Enhanced Feature Register (EFR)
Enhanced features are enabled or disabled using this register.
Bits 0 through 4 provide single or dual character software ow control selection. When the
Xon1 and Xon2 and/or Xoff1 and Xoff2 modes are selected, the double 8-bit words are
concatenated into two sequential numbers.
Table 22.
Enhanced Feature Register bits description
Bit
Symbol
Description
7
EFR[7]
Automatic CTS ow control.
logic 0 = Automatic CTS ow control is disabled (normal default condition)
logic 1 = enable Automatic CTS ow control. Transmission will stop when
CTS goes to a logic 1. Transmission will resume when the CTS pin returns to
a logic 0.
6
EFR[6]
Automatic RTS ow control. Automatic RTS may be used for hardware ow
control by enabling EFR[6]. When Auto-RTS is selected, an interrupt will be
generated when the receive FIFO is lled to the programmed trigger level and
RTS will go to a logic 1 at the next trigger level. RTS will return to a logic 0 when
data is unloaded below the next lower trigger level (programmed trigger level 1).
The state of this register bit changes with the status of the hardware ow
control. RTS functions normally when hardware ow control is disabled.
0 = Automatic RTS ow control is disabled (normal default condition)
1 = enable Automatic RTS ow control
5
EFR[5]
Special Character Detect.
logic 0 = special character detect disabled (normal default condition)
logic 1 = special character detect enabled. The SC16C650B compares each
incoming receive character with Xoff2 data. If a match exists, the received
data will be transferred to FIFO and ISR[4] will be set to indicate detection of
special character. Bit 0 in the X-registers corresponds with the LSB bit for the
receive character. When this feature is enabled, the normal software ow
control must be disabled (EFR[3:0] must be set to a logic 0).
4
EFR[4]
Enhanced function control bit. The content of IER[7:4], ISR[5:4], FCR[5:4], and
MCR[7:5] can be modied and latched. After modifying any bits in the
enhanced registers, EFR[4] can be set to a logic 0 to latch the new values. This
feature prevents existing software from altering or overwriting the SC16C650B
enhanced functions.
logic 0 = disable (normal default condition)
logic 1 = enable
3:0
EFR[3:0]
Cont-3:0 Tx, Rx control. Logic 0 or cleared is the default condition.
Combinations of software ow control can be selected by programming these
bits. See Table 23.
相關PDF資料
PDF描述
ATMEGA16-16AUR MCU AVR 16KB FLASH 16MHZ 44TQFP
ATMEGA16L-8AUR MCU AVR 16KB FLASH 16MHZ 44TQFP
SC16IS752IBS,128 IC UART DUAL I2C/SPI 32-HVQFN
SC16IS752IBS,157 IC DUAL UART 64BYTE 32HVQFN
SC16IS752IPW,128 IC DUAL UART 64BYTE 28TSSOP
相關代理商/技術參數
參數描述
SC16C650BIBS-F 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 32B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C650BIBS-S 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 32B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C650BIN40 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 32B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C650BIN40,112 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C652 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Dual UART with 32 bytes of transmit and receive FIFOs
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*