參數資料
型號: SAK-XC164CS-32F20F
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 16-BIT, FLASH, 20 MHz, RISC MICROCONTROLLER, PQFP100
封裝: 0.50 MM PITCH, GREEN, PLASTIC, TQFP-100
文件頁數: 25/81頁
文件大?。?/td> 1106K
代理商: SAK-XC164CS-32F20F
XC164-32
Derivatives
Functional Description
Data Sheet
29
V1.1, 2006-08
3.6
Capture/Compare Units (CAPCOM1/2)
The CAPCOM units support generation and control of timing sequences on up to
32 channels with a maximum resolution of 1 system clock cycle (8 cycles in staggered
mode). The CAPCOM units are typically used to handle high speed I/O tasks such as
pulse and waveform generation, pulse width modulation (PMW), Digital to Analog (D/A)
conversion, software timing, or time recording relative to external events.
Four 16-bit timers (T0/T1, T7/T8) with reload registers provide two independent time
bases for each capture/compare register array.
The input clock for the timers is programmable to several prescaled values of the internal
system clock, or may be derived from an overflow/underflow of timer T6 in module GPT2.
This provides a wide range of variation for the timer period and resolution and allows
precise adjustments to the application specific requirements. In addition, external count
inputs for CAPCOM timers T0 and T7 allow event scheduling for the capture/compare
registers relative to external events.
Both of the two capture/compare register arrays contain 16 dual purpose
capture/compare registers, each of which may be individually allocated to either
CAPCOM timer T0 or T1 (T7 or T8, respectively), and programmed for capture or
compare function.
12 registers of the CAPCOM2 module have each one port pin associated with it which
serves as an input pin for triggering the capture function, or as an output pin to indicate
the occurrence of a compare event.
Table 6
Compare Modes (CAPCOM1/2)
Compare Modes
Function
Mode 0
Interrupt-only compare mode;
several compare interrupts per timer period are possible
Mode 1
Pin toggles on each compare match;
several compare events per timer period are possible
Mode 2
Interrupt-only compare mode;
only one compare interrupt per timer period is generated
Mode 3
Pin set ‘1’ on match; pin reset ‘0’ on compare timer overflow;
only one compare event per timer period is generated
Double Register
Mode
Two registers operate on one pin;
pin toggles on each compare match;
several compare events per timer period are possible
Single Event Mode
Generates single edges or pulses;
can be used with any compare mode
相關PDF資料
PDF描述
SAK-XC2267M-104F80LAA 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP100
SAK-XC2285M-104F80LAA RISC MICROCONTROLLER, PQFP144
SAK-XC2285M-56F80LAA RISC MICROCONTROLLER, PQFP144
SAF-XC2287M-72F80LAA RISC MICROCONTROLLER, PQFP144
SAF-XC2285M-72F80LAA RISC MICROCONTROLLER, PQFP144
相關代理商/技術參數
參數描述
SAK-XC164CS-32F20F BB-A 功能描述:16位微控制器 - MCU 16BIT SNGL CHIP 5V 20MHz Flash RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAK-XC164CS-32F20F BB-A TR 制造商:Infineon Technologies AG 功能描述:
SAKXC164CS32F20FBB-A 制造商:Infineon Technologies AG 功能描述:
SAK-XC164CS-32F40F 制造商:Rochester Electronics LLC 功能描述:- Bulk
SAK-XC164CS-32F40F BB 制造商:Infineon Technologies AG 功能描述:MCU 16-Bit XC166 CISC/DSP/RISC 256KB Flash 2.5V/5V 100-Pin TQFP