參數資料
型號： SAK-XC164CM-8F20F
廠商： INFINEON TECHNOLOGIES AG
元件分類： 微控制器/微處理器
英文描述： 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP64
封裝： 0.50 MM PITCH, GREEN, PLASTIC, TQFP-64
文件頁數： 59/70頁
文件大小： 2001K
代理商： SAK-XC164CM-8F20F
XC164CM
Derivatives
Electrical Parameters
Data Sheet
60
V1.4, 2007-03
The used mechanism to generate the master clock is selected by register PLLCON.
CPU and EBC are clocked with the CPU clock signal
f
CPU. The CPU clock can have the
same frequency as the master clock (
f
CPU = fMC) or can be the master clock divided by
two:
f
CPU = fMC / 2. This factor is selected by bit CPSYS in register SYSCON1.
The specification of the external timing (AC Characteristics) depends on the period of the
CPU clock, called “TCP”.
The other peripherals are supplied with the system clock signal
f
SYS which has the same
frequency as the CPU clock signal
f
CPU.
Bypass Operation
When bypass operation is configured (PLLCTRL = 0xB) the master clock is derived from
the internal oscillator (input clock signal XTAL1) through the input- and output-
prescalers:
f
MC = fOSC / ((PLLIDIV + 1) × (PLLODIV + 1)).
If both divider factors are selected as ‘1’ (PLLIDIV = PLLODIV = ‘0’) the frequency of
f
MC
directly follows the frequency of
f
OSC so the high and low time of fMC is defined by the duty
cycle of the input clock
f
OSC.
The lowest master clock frequency is achieved by selecting the maximum values for both
divider factors:
f
MC = fOSC / ((3 + 1) × (14 + 1)) = fOSC / 60.
Phase Locked Loop (PLL)
When PLL operation is configured (PLLCTRL = 11B) the on-chip phase locked loop is
enabled and provides the master clock. The PLL multiplies the input frequency by the
factor F (
f
MC = fOSC × F) which results from the input divider, the multiplication factor, and
the output divider (F = PLLMUL+1 / (PLLIDIV+1
× PLLODIV+1)). The PLL circuit
synchronizes the master clock to the input clock. This synchronization is done smoothly,
i.e. the master clock frequency does not change abruptly.
Due to this adaptation to the input clock the frequency of
f
MC is constantly adjusted so it
is locked to
f
OSC. The slight variation causes a jitter of fMC which also affects the duration
of individual TCMs.
The timing listed in the AC Characteristics refers to TCPs. Because
f
CPU is derived from
f
MC, the timing must be calculated using the minimum TCP possible under the respective
circumstances.
The actual minimum value for TCP depends on the jitter of the PLL. As the PLL is
constantly adjusting its output frequency so it corresponds to the applied input frequency
(crystal or oscillator) the relative deviation for periods of more than one TCP is lower than
for one single TCP (see formula and Figure 16).
相關PDF資料
PDF描述
SAF-XC164D-8R20F 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP100
SAF-XC164D-16F40F 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP100
SAF-XC164D-8F40F 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP100
SAF-XC164D-8R40F 16-BIT, MROM, 40 MHz, MICROCONTROLLER, PQFP100
SAF-XC164GM-16F20F 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP64
相關代理商/技術參數
參數描述
SAK-XC164CM-8F20F AA 功能描述:16位微控制器 - MCU MICROCONTROLLER 16-BIT RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAK-XC164CM-8F20FAA 制造商:Rochester Electronics LLC 功能描述: 制造商:Infineon Technologies AG 功能描述:
SAKXC164CM8F20FAAXT 制造商:Infineon Technologies AG 功能描述:MCU 16-Bit XC166 CISC/DSP/RISC 64KB Flash 2.5V/5V 64-Pin TQFP
SAK-XC164CM-8F40F 制造商:Infineon Technologies AG 功能描述:16BIT MCU 64K FLASH TQFP64 164
SAKXC164CM8F40F AA 制造商:Infineon Technologies AG 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*