參數(shù)資料
型號: SAH-XC2387A-104F80L
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 16-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
封裝: 0.50 MM PITCH, GREEN, PLASTIC, LQFP-144
文件頁數(shù): 116/141頁
文件大?。?/td> 1795K
代理商: SAH-XC2387A-104F80L
XC2385A, XC2387A
XC2000 Family / Base Line
Functional Description
Data Sheet
76
V2.1, 2011-07
3.16
Watchdog Timer
The Watchdog Timer is one of the fail-safe mechanisms which have been implemented
to prevent the controller from malfunctioning for longer periods of time.
The Watchdog Timer is always enabled after an application reset of the chip. It can be
disabled and enabled at any time by executing the instructions DISWDT and ENWDT
respectively. The software has to service the Watchdog Timer before it overflows. If this
is not the case because of a hardware or software failure, the Watchdog Timer
overflows, generating a prewarning interrupt and then a reset request.
The Watchdog Timer is a 16-bit timer clocked with the system clock divided by 16,384
or 256. The Watchdog Timer register is set to a prespecified reload value (stored in
WDTREL) in order to allow further variation of the monitored time interval. Each time it
is serviced by the application software, the Watchdog Timer is reloaded and the
prescaler is cleared.
Time intervals between 3.2
μs and 13.42 s can be monitored (@ 80 MHz).
The default Watchdog Timer interval after power-up is 6.5 ms (@ 10 MHz).
3.17
Clock Generation
The Clock Generation Unit can generate the system clock signal
f
SYS for the XC238xA
from a number of external or internal clock sources:
External clock signals with pad voltage or core voltage levels
External crystal or resonator using the on-chip oscillator
On-chip clock source for operation without crystal/resonator
Wake-up clock (ultra-low-power) to further reduce power consumption
The programmable on-chip PLL with multiple prescalers generates a clock signal for
maximum system performance from standard crystals, a clock input signal, or from the
on-chip clock source. See also Section 4.6.2.
The Oscillator Watchdog (OWD) generates an interrupt if the crystal oscillator frequency
falls below a certain limit or stops completely. In this case, the system can be supplied
with an emergency clock to enable operation even after an external clock failure.
All available clock signals can be output on one of two selectable pins.
相關PDF資料
PDF描述
SAH-XC2387C-200F100L 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
SAH-XC2387C-136F100L 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
SAH-XC2387C-104F100L 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
SAF-XC2387C-200F80L 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAF-XC2387C-200F100L 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
相關代理商/技術參數(shù)
參數(shù)描述
SAI Y-4S M8-M8 制造商:Weidmuller 功能描述:SPLITTER PLUG TO 2X RCPT M8 制造商:Weidmuller 功能描述:SPLITTER, PLUG TO 2X RCPT, M8, 4 WAY 制造商:Weidmuller 功能描述:SPLITTER, PLUG TO 2X RCPT, M8, 4 WAY, No. of Ports:2, SVHC:No SVHC (20-Jun-2013)
SAI01 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Surface-Mount, Separate Excitation Switching Type
SAI01-1 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Surface-mount and Separate Excitation Type
SAI01V1 制造商:Sanken Electric Co Ltd 功能描述:IC REG BUCK 5V 0.5A PS-4PIN
SAI02 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Surface-mount and Separate Excitation Type