- 您現在的位置：買賣IC網 > PDF目錄10242 > SA572NG (ON Semiconductor)IC COMPANDOR 2CHAN GAIN 16-DIP PDF資料下載
參數資料
| 型號： | SA572NG |
| 廠商： | ON Semiconductor |
| 文件頁數： | 8/12頁 |
| 文件大小： | 0K |
| 描述： | IC COMPANDOR 2CHAN GAIN 16-DIP |
| 標準包裝： | 500 |
| 類型： | 壓縮擴展器 |
| 應用： | 自動電平控制，立體聲擴展器 |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 16-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 16-DIP |
| 包裝： | 管件 |
| 產品目錄頁面： | 1131 (CN2011-ZH PDF) |
| 其它名稱： | SA572NG-ND SA572NGOS |
SA572
http://onsemi.com
5
The residual distortion is third harmonic distortion and
is caused by gain control ripple. In a compandor system,
available control of fast attack and slow recovery improve
ripple distortion significantly. At the unity gain level of
100 mV, the gain cell gives THD (total harmonic
distortion) of 0.17% typ. Output noise with no input signals
is only 6.0
mV in the audio spectrum (10 Hz-20 kHz). The
output current IO must feed the virtual ground input of an
operational amplifier with a resistor from output to
inverting input. The non-inverting input of the operational
amplifier has to be biased at VREF if the output current IO
is DC coupled.
VREF
THD
TRIM
V+
1
2
IG )
1
IO
I1
140mA
280mA
I2
IG
IO
Q4
Q3
Q1
Q2
VIN
+
A1
Figure 3. Basic Gain Cell Schematic
R1
6.8kW
Rectifier
The rectifier is a full-wave design as shown in Figure 4.
The input voltage is converted to current through the input
resistor R2 and turns on either Q5 or Q6 depending on the
signal polarity. Deadband of the voltage to current
converter is reduced by the loop gain of the gain block A2.
If AC coupling is used, the rectifier error comes only from
input bias current of gain block A2. The input bias current
is typically about 70 nA. Frequency response of the gain
block A2 also causes second-order error at high frequency.
The collector current of Q6 is mirrored and summed at the
collector of Q5 to form the full wave rectified output
current IR. The rectifier transfer function is:
IR +
VIN * VREF
R2
(eq. 3)
If VIN is AC-coupled, then the equation will be reduced
to:
IRAC +
VIN(AVG)
R2
The internal bias scheme limits the maximum output
current IR to be around 300 mA. Within a "1.0 dB error
band the input range of the rectifier is about 52 dB.
VIN
VREF
V+
A2
+
IR +
VIN * VREF
R2
Figure 4. Simplified Rectifier Schematic
Q5
Q6
R2
D7
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2232CUK#PBF | IC ADC 10BIT 105MSPS SAMPL 48QFN |
| VE-B2V-MW-F2 | CONVERTER MOD DC/DC 5.8V 100W |
| VI-26Y-MW | CONVERTER MOD DC/DC 3.3V 66W |
| VE-B2V-MW-F1 | CONVERTER MOD DC/DC 5.8V 100W |
| LTC2232CUK | IC ADC 10BIT 105MSPS SAMPL 48QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SA575 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low voltage compandor |
| SA5751D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Cell-Phone Circuit |
| SA5752 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Audio processor - companding, VOX and amplifier section |
| SA5752D | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Audio processor-companding, VOX and amplifier section |
| SA5752DK | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Audio processor - companding, VOX and amplifier section |
發布緊急采購，3分鐘左右您將得到回復。