參數資料
型號: S101S16V
廠商: SHARP ELECTRONICS CORP
元件分類: 繼電器,輸入/輸出模塊
英文描述: TRIGGER OUTPUT SOLID STATE RELAY, 3000 V ISOLATION-MAX
封裝: PLASTIC, SIP-4
文件頁數: 12/13頁
文件大小: 234K
代理商: S101S16V
8
S101S16V Series
■ Design Considerations
In order for the SSR to turn off, the triggering current (lF) must be 0.1mA or less.
For over voltage protection, a Varistor may be used.
A varistor used for the above mentioned scenarios should be located as close to the main output triac as
possible.
Particular attention needs to be paid when utilizing SSRs that incorporate zero crossing circuitry.
If the phase difference between the voltage and the current at the output pins is large enough, zero crossing
type SSRs cannot be used. The result, if zero crossing SSRs are used under this condition, is that the SSR
may not turn on and off irregardless of the input current. In this case, only a non zero cross type SSR should
be used in combination with the above mentioned snubber circuit selection process.
The load current should be within the bounds of derating curve. (Refer to Fig.2)
Also, please use the optional heat sink when necessary.
In case the optional heat sink is used and the isolation voltage between the device and the optional heat sink
is needed, please locate the insulation sheet between the device and the heat sink.
When the optional heat sink is equipped, please set up the M3 screw-fastening torque at 0.3 to 0.5Nm.
In order to dissipate the heat generated from the inside of device effectively, please follow the below sugges-
tions.
(a) Make sure there are no warps or bumps on the heat sink, insulation sheet and device surface.
(b) Make sure there are no metal dusts or burrs attached onto the heat sink, insulation sheet and device sur-
face.
(c) Make sure silicone grease is evenly spread out on the heat sink, insulation sheet and device surface.
Silicone grease to be used is as follows;
1) There is no aged deterioration within the operating temperature ranges.
2) Base oil of grease is hardly separated and is hardly permeated in the device.
3) Even if base oil is separated and permeated in the device, it should not degrade the function of a device.
Recommended grease : G-746 (Shin-Etsu Chemical Co., Ltd.)
: G-747 (Shin-Etsu Chemical Co., Ltd.)
: SC102 (Dow Corning Toray Silicone Co., Ltd.)
● Design guide
Sheet No.: D4-A03101EN
Recommended Operating Conditions
Parameter
Symbol
Unit
Input
Output
Input signal current at ON state
Input signal current at OFF state
Load supply voltage
Load supply current
Frequency
Operating temperature
IF(ON)
IF(OFF)
VOUT(rms)
IOUT(rms)
f
Topr
mA
V
mA
Hz
C
Conditions
25
0
80
0.1
47
20
35
0.1
120
IT(rms)
×80%()
63
80
MIN.
MAX.
() See Fig.2 about derating curve (IT(rms) vs. ambient temperature).
相關PDF資料
PDF描述
S102S01 TRIGGER OUTPUT SOLID STATE RELAY, 4000 V ISOLATION-MAX
S202S01 TRIGGER OUTPUT SOLID STATE RELAY, 4000 V ISOLATION-MAX
S1C17003D00E100 RISC MICROCONTROLLER, UUC
S1C17003F00E100 RISC MICROCONTROLLER, PQFP64
S1C17601F00E100 16-BIT, FLASH, 8.2 MHz, RISC MICROCONTROLLER, PQFP64
相關代理商/技術參數
參數描述
S-101T 功能描述:穩流二極管 100V .10mA RoHS:否 制造商:Central Semiconductor 最大調節器電流:5.17 mA 最大極限電壓:2.9 V 最大峰值工作電壓:100 V 安裝風格:Through Hole 封裝 / 箱體:DO-204AH 封裝:
S101WHE 制造商:Thomas & Betts 功能描述:Universal Recessed Box And Cover
S102 制造商:DFX 功能描述:STRIPLIGHT LED 300MM PURE CLEAR 制造商:DFX 功能描述:STRIPLIGHT, LED, 300MM PURE CLEAR 制造商:DFX 功能描述:STRIPLIGHT, LED, 300MM PURE CLEAR; Light Colour:Neutral White; Power Rating:6W; Supply Voltage:230VAC; Light Bar Length:320mm; IP Rating:(Not Available); Average Bulb Life:50000h; Bulb Size:T-4; CCT:5000K; Colour:Clear; Depth:22mm; ;RoHS Compliant: Yes
S-102 制造商:Amphenol Aerospace 功能描述:SOCKET 制造商:Amphenol Nexus 功能描述:SOCKET - Bulk
S102 a 制造商:DFX Technology 功能描述:LED MAINS STRIP 300 7500K