- 您現在的位置：買賣IC網 > PDF目錄385775 > RT9186A-25PF (Richtek Technology Corporation) Low Profile 500mA LDO with Enable and Power Good/Reset PDF資料下載
參數資料
| 型號： | RT9186A-25PF |
| 廠商： | Richtek Technology Corporation |
| 英文描述： | Low Profile 500mA LDO with Enable and Power Good/Reset |
| 中文描述： | 超薄500mA的低壓降穩壓器的啟用和電源良好/復位 |
| 文件頁數： | 9/13頁 |
| 文件大?。?/td> | 220K |
| 代理商： | RT9186A-25PF |
RT9186A/B
9
DS9186AB-10 August 2007
www.richtek.com
Application Information
Capacitor Selection and Regulator Stability
Careful selection of the external capacitors for RT9186 is
highly recommended in order to remain high stability and
performance.
Regarding the Input capacitor, connecting an X7R or X5R
ceramic capacitor which is
ground is a must. Distance less than 1 cm between input
pin and ground of RT9186 is recommended to avoid any
unstability. With larger value of capacitor adding on lower
ESR could result in better performance for both PSRR
and line transient response.
1
≧
μ
F between input and
Regarding the output capacitor, connecting a10
μ
F
capacitor between output and ground is a must. Any
capacitor is acceptable only with a highlight of relation
between ESR region and Load current, shown in below.
Output capacitor with larger capacitance can reduce noise
and improve load transient response, stability, and PSRR.
The same as Input capacitor, distance less than 1 cm
between output pin and ground of RT9186 is recommended
to avoid any unstability.
Region of Stable C
OUT
ESR vs. Load Current
100.00
0.01
0.10
1.00
10.00
0
100
200
300
400
500
Load Current (mA)
C
O
Ω
)
Instable
Instable
Stable
1
10
V
IN
= 3V
Input-Output (Dropout) Voltage
A regulator
’
s minimum input-to-output voltage differential
(dropout voltage) determines the lowest usable supply
voltage. In battery-powered systems, this determines the
useful end-of-life battery voltage. Because the device uses
a P-MOSFET, its dropout voltage is a function of drain-to-
source on-resistance, R
DS(ON)
, multiplied by the load
current:
V
DROPOUT
= V
IN
-V
OUT
= R
DS(ON)
I
OUT
Over-Current and Short-Circuit Protection
The RT9186 continuously monitors output current to
provide maximum safety. In the event of output over current
or short-circuit, over-current protection function will activate
and override the voltage regulation function to limit output
current at 1.4A typically. Large power dissipation at this
condition may cause chip temperature to raise and trigger
the over temperature protection if over-current or short-
circuit is not removed in a short time
Power Good and Reset
The power good and the reset output is an open-drain
output. Connect an 100k
pull up resistor to V
OUT
to obtain
an output voltage. The power good will output high
immediately after the output voltage arrives 80% of normal
output voltage. In the same situation, the reset will output
high with 6ms delay time. See Timing Diagram and Typical
Operating Characteristics.
Adjustable Operation
The output voltage of RT9186 is adjustable from 0.8V to
4.5V by an external voltage divider as shown in Typical
Application Circuit Figure 2. The value of R2 should be
less than 80k
to ensure regulation.
Chip Enable Operation
Pull the EN pin low to drive the device into shutdown mode.
At the same time, pin 3 (PGOOD/RST) is pulled low. During
shutdown mode, the standby current drops to 0.1
μ
A (typ).
The output voltage decay rate is determined by the external
capacitor and load current. Drive the EN pin high to turn
on the device again.
相關PDF資料 |
PDF描述 |
|---|---|
| RT9186A-25PQV | Low Profile 500mA LDO with Enable and Power Good/Reset |
| RT9186A-33GF | Low Profile 500mA LDO with Enable and Power Good/Reset |
| RT9186A-33GQV | Low Profile 500mA LDO with Enable and Power Good/Reset |
| RT9186A-33PF | Low Profile 500mA LDO with Enable and Power Good/Reset |
| RT9186A-33PQV | Low Profile 500mA LDO with Enable and Power Good/Reset |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RT9186AGF | 功能描述:IC REG LDO ADJ .5A 8MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:50 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3.3V 輸入電壓:最高 15V 電壓 - 壓降（標準）:1.1V @ 800mA 穩壓器數量:1 電流 - 輸出:800mA 電流 - 限制（最?。?800mA 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-4，D²Pak（3 引線+接片），TO-263AA 供應商設備封裝:D2PAK-3 包裝:管件 |
| RT9186AGQV | 功能描述:IC REG LDO ADJ .5A 8VDFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:50 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:2.1V 輸入電壓:最高 7.5V 電壓 - 壓降（標準）:- 穩壓器數量:1 電流 - 輸出:5A（最小值） 電流 - 限制（最?。?5.1A 工作溫度:-40°C ~ 100°C 安裝類型:通孔 封裝/外殼:TO-220-5 供應商設備封裝:TO-220-5 包裝:管件 配用:296-20624-ND - EVAL MOD FOR TPS72518 其它名稱:296-15154-5 |
| RT9187CGB | 制造商:Richtek Technology Corporation 功能描述:600mA, Ultra-Low Dropout, Ultra-Fast CMOS LDO Regulator |
| RT9187G | 功能描述:IC REG LDO ADJ 1A SOT-23 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:MIC5365/66 Ultra-small LDO Regulators 標準包裝:1 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.155V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最?。?200mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:4-UDFN 裸露焊盤，4-TMLF? 供應商設備封裝:4-TMLF?（1x1） 包裝:Digi-Reel® 其它名稱:576-3192-6 |
| RT9187GQV | 功能描述:IC REG LDO ADJ 1A 8VDFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:MIC5365/66 Ultra-small LDO Regulators 標準包裝:1 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.155V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最小）:200mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:4-UDFN 裸露焊盤，4-TMLF? 供應商設備封裝:4-TMLF?（1x1） 包裝:Digi-Reel® 其它名稱:576-3192-6 |
發布緊急采購，3分鐘左右您將得到回復。