
Barrier Strips
Tri-Barriers
MOUNTING POSITION
Vertical Mounting
CATALOG LETTER CODE:
V. Used where direct top-to-bottom feed-through is
required with no need for circuit isolation on the bottom side. The most
common example of this is printed circuit board mounting.
Right Angle Mounting
CATALOG LETTER CODE:
R. Provides a printed circuit board mounting option
with top-side wire entry. Supplied with terminal option 15.
END CONTACT MOUNTING OPTIONS
End Position Mounting
CATALOG LETTER CODE:
M. Supplied without contact in end sections to allow
installer to mount blocks with screws in end section holes. Base of block will
support #6 mounting screws.
Direct Mounting
CATALOG LETTER CODE:
P. RSB3 may be solder-mounted using the bottom
terminals themselves, as in the case of printed circuit board applications.
End Position Mounting with Mounting Plates
CATALOG LETTER CODE
T. Supplied with threaded mounting plates instead of
contacts in end sections to facilitate bottom screw mounting using standard
6-32 screws.
TERMINAL STYLE
Printed Circuit Pin
CATALOG NUMBER CODE:
12. Designed specifically
for mounting on .063” thick circuit board.
Special, readily solderable plating permits good
fillet development in automated soldering
processes.
Non-Feed-Through
CATALOG NUMBER CODE:
13.
Extended Printed Circuit Pin
CATALOG NUMBER CODE:
14. Useful for thicker
printed circuit boards or single-wrap connec-
tions.
Right Angle Printed Circuit Pins
CATALOG NUMBER CODE:
15.
Wire Wrap
CATALOG NUMBER CODE:
17. Longer than
extended circuit board terminals.
0.325” PITCH
SERIES RSB3
66
Thomas & Betts Electronics/OEM Division Tel: 901-252-5000 Fax: 901-252-1312
LR49571
E60980
Dimensions shown are for reference only. Dimensions are in inches.