參數資料
型號: RF2705
廠商: RF MICRO DEVICES INC
元件分類: 無繩電話/電話
英文描述: 887664300
中文描述: TELECOM, CELLULAR, RF AND BASEBAND CIRCUIT, PQCC24
封裝: 4 X 4 MM, PLASTIC, QFN-24
文件頁數: 19/24頁
文件大?。?/td> 379K
代理商: RF2705
5-131
RF2705
Rev A4 041026
Application Information
The baseband inputs of the RF2705 must be driven with balanced signals. Amplitude and phase matching <0.5dB and
<0.5 degrees are recommended. Phase or gain imbalances between the complementary input signals will cause addi-
tional distortion including some second order baseband distortion.
The RF2705 is designed to be driven with either single-ended or differential LO signals. Driving the chip differentially is
beneficial in improving the LO leakage performance. Decreasing the LO drive level will also improve LO leakage, but the
output noise performance will be degraded. Driving the LO level too high will degrade linearity.
The ground lines for the LO sections are brought out of the chip independently from the ground to the RF and modulator
sections. This is intended to give the board design the independence of isolating the LO signals from the RF output sec-
tions.
The RF2705 includes frequency doubler and divider modes that allow the LO to operate at half or twice the frequency
depending on the application. This provides some flexibility in improving VCO isolation and LO leakage through fre-
quency translation.
The RF outputs use open collector architecture and may be biased at voltages higher than V
CC
. In practice, biasing at a
higher voltage may improve the intermodulation performance. The load resistors are selected to provide sufficient output
power while maintaining good linearity.
The GC DEC and V
REF
output pins should be decoupled to ground. A 10nF capacitor on V
REF
and a 1nF capacitor on
GC CEC are recommended. The purpose of these capacitors is to filter out low frequency noise (20MHz) in the gain
control lines that may cause noise on the RF signal. The capacitor on the GC DEC line will effect the settling time of the
step response in power control voltage. A 1nF capacitor equates to around a 200ns settling time; a 0.5nF capacitor
equates to a 100ns settling time. There is a trade-off between setting time and phase noise as gain control is applied.
As with any RF circuit, the RF2705 is sensitive to PC board layout. The suggested schematic and board layout is
included as a guideline. Proper grounding of the die flag under the chip is essential in achieving acceptable RF perfor-
mance. A symmetric output structure will maintain signal balance while keeping the RF lines short will reduce losses.
Proper routing and bypassing of the supply lines will improve stability and performance, especially under low gain control
settings where carrier suppression becomes crucial. The location and value of the bypass capacitor on pin 1 is critical in
promoting good carrier suppression and is designated to resonate out the series wire bond and PC board inductance.
相關PDF資料
PDF描述
RF2705PCBA-41X 887664400
RF2713 887667300
RF2721 QUADRATURE DEMODULATOR
RF2909 3V 915MHZ SPREAD-SPECTRUM TRANSMITTER IC
RF2915 433/868/915MHZ FSK/ASK/OOK TRANSCEIVER
相關代理商/技術參數
參數描述
RF2705-000 制造商:TE Connectivity 功能描述:FUSE 40A 72V RESETTABLE - Bag
RF2705G 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:LOW NOISE, MULTI-MODE, QUAD-BAND, QUADRATURE MODULATOR AND PA DRIVER
RF2705G_1 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:LOW NOISE, MULTI-MODE, QUAD-BAND, QUADRATURE MODULATOR AND PA DRIVER
RF2705GPCBA-41X 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:LOW NOISE, MULTI-MODE, QUAD-BAND, QUADRATURE MODULATOR AND PA DRIVER
RF2705PB005 制造商:Hubbell Wiring Device-Kellems 功能描述:HAZ LOC LINKOSITY FEM, 5W, 20A