參數資料
型號: REG101UA-3.3/2K5G4
廠商: TEXAS INSTRUMENTS INC
元件分類: 固定正電壓單路輸出LDO穩壓器
英文描述: 3.3 V FIXED POSITIVE LDO REGULATOR, 0.13 V DROPOUT, PDSO8
封裝: GREEN, PLASTIC, MS-012AA, SOIC-8
文件頁數: 2/23頁
文件大?。?/td> 719K
代理商: REG101UA-3.3/2K5G4
REG101
10
SBVS026D
FIGURE 4. Block Diagram.
FIGURE 5. Output Noise versus Noise Reduction Capacitor.
ENABLE
The Enable pin is active HIGH and compatible with stan-
dard TTL-CMOS levels. Inputs below 0.5V (max) turn the
regulator off and all circuitry is disabled. Under this condi-
tion, ground pin current drops to approximately 10nA. When
a pull-up resistor is used, and operation down to VIN = 1.8V
is required, use values < 50k
.
OUTPUT NOISE
A precision band-gap reference is used for the internal
reference voltage, VREF. This reference is the dominant
noise source within the REG101 and it generates approxi-
mately 29
Vrms in the 10Hz to 100kHz bandwidth at the
reference output. The regulator control loop gains up the
reference noise, so that the noise voltage of the regulator is
approximately given by:
V = 29 Vrms
R+ R
R2
Vrms
V
N
1
2
OUT
REF
= 29
Since the value of VREF is 1.267V, this relationship reduces to:
V= 23
Vrms
V
N
OUT
Connecting a capacitor, CNR, from the Noise Reduction (NR)
pin to ground, as shown in Figure 4, forms a low-pass filter for
the voltage reference. For CNR = 10nF, the total noise in the
10Hz to 100kHz bandwidth is reduced by approximately a
factor of 2.8 for VO = 3.3V. This noise reduction effect is
shown in Figure 5 and as “RMS Noise Voltage vs CNR” in the
Typical Characteristics section.
Noise can be further reduced by carefully choosing an
output capacitor, COUT. Best overall noise performance is
achieved with very low (< 0.22
F) or very high (> 2.2F)
values of COUT. See “RMS Noise Voltage vs COUT” in the
Typical Characteristics section.
The REG101 utilizes an internal charge pump to develop an
internal supply voltage sufficient to drive the gate of the
DMOS pass element above VIN. The charge-pump switch-
ing noise (nominal switching frequency = 2MHz) is not
measurable at the output of the regulator over most values of
COUT and IOUT.
The REG101 adjustable version does not have the noise-
reduction pin available, however, the adjust pin is the sum-
ming junction of the error amplifier. A capacitor, CFB,
connected from the output to the adjust pin will reduce both
the output noise and the peak error from a load transient. See
the typical characteristics for output noise performance.
Over Current
Over Temp
Protection
V
REF
(1.26V)
Low Noise
Charge Pump
DMOS
Pass
Transistor
R
1
NOTE: R
1 and R2 are internal
on fixed output versions.
V
OUT
Adj
(Adjustable
Versions)
R
2
NR
(fixed output
versions only)
Enable
REG101
V
IN
C
NR
(optional)
110
1k
100
10k
110
100
90
80
70
60
50
40
30
20
Noise
Voltage
(
Vrms)
C
NR (pF)
RMS NOISE VOLTAGE vs C
NR
C
NR = 0F
10Hz < BW < 100kHz
REG101-5.0
REG101-2.5
REG101-3.3
相關PDF資料
PDF描述
REG101UA-5/2K5G4 5 V FIXED POSITIVE LDO REGULATOR, 0.13 V DROPOUT, PDSO8
REG101UA-3.3G4 3.3 V FIXED POSITIVE LDO REGULATOR, 0.13 V DROPOUT, PDSO8
REG101NA-2.85/3K 2.85 V FIXED POSITIVE LDO REGULATOR, 0.13 V DROPOUT, PDSO5
REG101NA-3.3/3K 3.3 V FIXED POSITIVE LDO REGULATOR, 0.13 V DROPOUT, PDSO5
REG101NA-3/3K 3 V FIXED POSITIVE LDO REGULATOR, 0.13 V DROPOUT, PDSO5
相關代理商/技術參數
參數描述
REG101UA-3G4 功能描述:低壓差穩壓器 - LDO DMOS 100mA LDO Reg RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
REG101UA-5 功能描述:低壓差穩壓器 - LDO DMOS 100mA LDO Reg RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
REG101UA-5 制造商:Texas Instruments 功能描述:IC V REG LDO 0.1A 5V SOIC8
REG101UA-5/250 制造商:TI 制造商全稱:Texas Instruments 功能描述:DMOS 100mA Low-Dropout Regulator
REG101UA-5/250G4 制造商:TI 制造商全稱:Texas Instruments 功能描述:DMOS 100mA Low-Dropout Regulator