參數資料
型號: R5310L001B
廠商: RICOH COMPANY LTD
元件分類: 基準電壓源/電流源
英文描述: Multi LDOs for Cellular-phone
中文描述: FIXED POSITIVE LDO REGULATOR, PQFP32
封裝: 0.50 MM PITCH, LQFP-32
文件頁數: 13/34頁
文件大?。?/td> 270K
代理商: R5310L001B
Rev.1.10
- 13 -
I
FUNCTIONAL DESCRIPTION
1.
3-wire Serial Interface
1-1. Data Transfer Summary
SCK
CSB
DATA
D0
0
D1
1
D2
2
D3
3
D4
4
D5
5
D6
6
D7
7
D8
0
D9
1
D10
2
D11
3
D12
4
D13
5
D14
6
D15
7
All data transfers are initiated by driving the CSB input low. The CSB input serves two functions. First, CSB turns on the
control logic which allows access to the shift register for the address/command sequence. Second, the CSB signal provides a
method of terminating data transfer. A clock cycle is a sequence of a falling edge followed by a rising edge. For data inputs,
data must be valid during the rising edge of the clock.
All data transfer terminates if the CSB input is high. Data transfer is illustrated as above.
1-2. Command Byte
7
6
5
4
3
2
1
0
D7
D6
D5
D4
D3
D2
D1
D0
The Command byte is shown as above. Each data transfer is initiated by a command byte.
The LSB (bit zero) must be a logic zero. An any data for each of bit six and bit seven which might be zero or one, is ignored.
Bits one through five specify the designated registers to be input.
The command byte is always input starting with the LSB (bit zero).
1-3. Data Input
Following the eight SCK cycles that input a write command byte, a data byte is input on the rising edge of the next eight SCK
cycles. And any successive instruction set which consists of command byte and data byte is allowable. The data byte is always
input starting with the LSB (bit zero).
1-4. Regulator Switch
Each of regulators can be enabled or disabled independently. In the VR switch register, designations for each of seven
regulators' ON/OFF can be written to bit zero through six. Bit seven is ignored.
1-5. Battery Monitor / LED Drivers / Ringer Controller
An analog output of cell voltage monitor is available with enable switch. Three of constant voltage outputs for LEDs and a
ringer controller can be independently ON/OFF. All of those enable switches are controlled by output port register. Bit zero
and one through three are for enable switch of battery monitor and LED drivers respectively.
Bit four through six is input digit of electronic volume for ringer controller, bit four is defined as the LSB. Bit seven is enable
switch for ringer controller.
1-6. Programmable Voltage Regulators /VR3, 4
The output voltage of VR3 and VR4 can be controlled externally by written data to the VR3/VR4 output registers.
VR3 outputs from 0.5V to 2.492V, VR4 outputs from 1.008V to 3.0V with eight bit resolution for each. Bit zero of each
register is the LSB.
相關PDF資料
PDF描述
R5312L Multi LDOs for Cellular-phone
R5312L001A Coaxial Cable; Impedance:75ohm; Conductor Size AWG:22; No. Strands x Strand Size:7 x 30; Jacket Material:Polyvinylchloride (PVC); Leaded Process Compatible:Yes; Voltage Nom.:300V; RG Cable Type:59 RoHS Compliant: Yes
R5320G CMOS Multi-LDOs for RF Unit
R5320G001A CMOS Multi-LDOs for RF Unit
R5320G001A-TR CMOS Multi-LDOs for RF Unit
相關代理商/技術參數
參數描述
R5310LXXXX 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Management ICs
R5311 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic
R531-120-000 功能描述:罩類、盒類及殼類產品 CROSS RAIL RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red
R531-160-000 功能描述:罩類、盒類及殼類產品 CROSS RAIL RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red
R5312 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic