- 您現在的位置：買賣IC網 > PDF目錄296949 > R1331NS12A (WESTCODE SEMICONDUCTORS LTD) 2687 A, 1200 V, SCR PDF資料下載
參數資料
| 型號： | R1331NS12A |
| 廠商： | WESTCODE SEMICONDUCTORS LTD |
| 元件分類： | 晶閘管 |
| 英文描述： | 2687 A, 1200 V, SCR |
| 文件頁數： | 8/12頁 |
| 文件大?。?/td> | 685K |
| 代理商： | R1331NS12A |
WESTCODE
WESTCODE An IXYS Company
Distributed Gate Thyristor types R1331NS10# to R1331NS12#
Data Sheet. Type R1331NS10# to R1331NS12# Issue 1
Page 5 of 12
December, 2002
15.0 Reverse Recovery Loss
15.1 Determination by Measurement
From waveforms of recovery current obtained from a high frequency shunt (see Note 1, Page 5) and
reverse voltage present during recovery, an instantaneous reverse recovery loss waveform must be
constructed. Let the area under this waveform be E joules per pulse. A new heat sink temperature can
then be evaluated from the following:
()
(
)
Hs
J
th
original
SINK
new
SINK
R
f
k
E
T
+
=
)
(
)
(
Where k=0.227 (°C/W)/s
E = Area under reverse loss waveform per pulse in joules (W.s.)
f = rated frequency Hz at the original heat sink temperature.
Rth(J-Hs) = d.c. thermal resistance (°C/W).
The total dissipation is now given by:
f
E
W
(original)
(TOT)
+
=
15.2 Determination without Measurement
In circumstances where it is not possible to measure voltage and current conditions, or for design
purposes, the additional losses E in joules may be estimated as follows.
Let E be the value of energy per reverse cycle in joules (curves in Figure 9).
Let f be the operating frequency in Hz
()
(
)
()
f
R
E
T
th
original
SINK
new
SINK
=
Where TSINK (new) is the required maximum heat sink temperature and
TSINK (original) is the heat sink temperature given with the frequency ratings.
A suitable R-C snubber network is connected across the thyristor to restrict the transient reverse voltage
to a peak value (Vrm) of 67% of the maximum grade. If a different grade is being used or Vrm is other than
67% of Grade, the reverse loss may be approximated by a pro rata adjustment of the maximum value
obtained from the curves.
NOTE 1- Reverse Recovery Loss by Measurement
This thyristor has a low reverse recovered charge and peak reverse recovery current. When measuring
the charge, care must be taken to ensure that:
(a) a.c. coupled devices such as current transformers are not affected by prior passage of high
amplitude forward current.
(b) A suitable, polarised, clipping circuit must be connected to the input of the measuring oscilloscope
to avoid overloading the internal amplifiers by the relatively high amplitude forward current signal
(c) Measurement of reverse recovery waveform should be carried out with an appropriate critically
damped snubber, connected across diode anode to cathode. The formula used for the calculation
of this snubber is shown below:
dt
di
S
r
C
V
R
= 4
2
Where:
Vr
CS
R
=
Commutating source voltage
Snubber capacitance
Snubber resistance
相關PDF資料 |
PDF描述 |
|---|---|
| R139.076.000 | PANEL MOUNT, CABLE TERMINATED, MALE, RF CONNECTOR, CRIMP, PLUG |
| R139.331.000 | PANEL MOUNT, CABLE TERMINATED, FEMALE, RF CONNECTOR, CRIMP, JACK |
| R143257000 | PANEL MOUNT, CABLE TERMINATED, FEMALE, TNC CONNECTOR, SOLDER, JACK |
| R143334161W | PANEL MOUNT, CABLE TERMINATED, FEMALE, TNC CONNECTOR, CRIMP, JACK |
| R1501J044B-TR-F | 4.4 V FIXED POSITIVE LDO REGULATOR, PSSO5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| R1332 | 制造商:Rochester Electronics LLC 功能描述: |
| R1332N | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic |
| R1333 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic |
| R1334 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic |
| R1335 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic |
發布緊急采購，3分鐘左右您將得到回復。