- 您現在的位置：買賣IC網 > PDF目錄385764 > R1282D002A-TR (RICOH COMPANY LTD) 2CH PWM DC/DC CONTROLLER PDF資料下載
參數資料
| 型號： | R1282D002A-TR |
| 廠商： | RICOH COMPANY LTD |
| 元件分類： | 穩壓器 |
| 英文描述： | 2CH PWM DC/DC CONTROLLER |
| 中文描述： | DUAL SWITCHING CONTROLLER, 805 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | 0.90 MM HEIGHT, TSON-10 |
| 文件頁數： | 18/18頁 |
| 文件大小： | 327K |
| 代理商： | R1282D002A-TR |
R1282D002A
TECHNICAL NOTES on EXTERNAL COMPONENTS
18
External components should be set as close to this IC as possible. Especially, wiring of the capacitor
connected to V
IN
pin should be as short as possible.
Enforce the ground wire. Large current caused by switching operation flows through GND pin. If the
impedance of ground wire is high, internal voltage level of this IC might fluctuate and operation could be
unstable.
Recommended capacitance value of C3 is equal or more than 4.7
μ
F.
If the spike noise of V
OUT1
is too large, the noise is feedback from V
FB1
pin and operation might be unstable.
In that case, use the resistor ranging from 10k
to 50k
as R5 and try to reduce the noise level. In the case
of V
OUT2
, use the resistor as much as 10k
as R6.
Select an inductor with low D.C. current, large permissible current, and uneasy to cause magnetic
saturation. If the inductance value is too small, IL
X
might be beyond the absolute maximum rating at the
maximum load.
Select a Schottky diode with fast switching speed and large enough permissible current.
Recommended capacitance value of C1 and C2 is as much as Ceramic 10
μ
F. In case that the operation
with the system of DC/DC converter would be unstable, add a series resister less than 0.5
to each output
capacitor or use tantalum capacitors with appropriate ESR. If you choose too large ESR, ripple noise may
be forced to V
FB1
and V
FB2
, and unstable operation may result. Use a capacitor with fully large voltage
tolerance of the capacitor.
this IC, for the test efficiency, latch release function is included. By forcing (V
IN
0.3)V or more voltage to
DTC1 pin or DTC2 pin, Latch release function works.
Performance of the power controller with using this IC depends on external components. Each component,
layout should not be beyond each absolute maximum rating such as voltage, current, and power
dissipation.
相關PDF資料 |
PDF描述 |
|---|---|
| R15P215S | 2 Watt SIP 7 Single & Dual Output |
| R12P205D | 2 Watt SIP 7 Single & Dual Output |
| R12P205S | 2 Watt SIP 7 Single & Dual Output |
| R12P209D | 2 Watt SIP 7 Single & Dual Output |
| R12P209S | 2 Watt SIP 7 Single & Dual Output |
相關代理商/技術參數 |
參數描述 |
|---|---|
| R128359707 | 功能描述:RF 連接器 PR COUD PLAT FLOT SOUDE .141C100 RoHS:否 制造商:Bomar Interconnect 產品:Connectors 射頻系列:BNC 型式:Jack (Female) 極性: 觸點電鍍:Gold 阻抗: 端接類型:Solder 主體類型:Straight Bulkhead 電纜類型: |
| R128359707W | 功能描述:RF 連接器 PR COUD PLAT FLOT SOUD.141 RoHS:否 制造商:Bomar Interconnect 產品:Connectors 射頻系列:BNC 型式:Jack (Female) 極性: 觸點電鍍:Gold 阻抗: 端接類型:Solder 主體類型:Straight Bulkhead 電纜類型: |
| R128359827 | 制造商:Radiall 功能描述:CONN BMA F 0HZ TO 12.4GHZ 50OHM RA PNL MNT AU OVER NI - Bulk |
| R128359827W | 制造商:Radiall 功能描述:CONN BMA F 0HZ TO 12.4GHZ 50OHM RA PNL MNT AU OVER NI - Bulk |
| R128360701 | 制造商:Radiall 功能描述:PR COUD PLAT FLOT SD .085 C100 - Bulk 制造商:Radiall 功能描述:PR COUD PLAT FLOT SOUDE .085 C100 制造商:Radiall 功能描述:RF COAXIAL CABLE MOUNT CONNECTOR |
發布緊急采購，3分鐘左右您將得到回復。