參數資料
型號： R1230D201G-TL
廠商： RICOH COMPANY LTD
元件分類： 穩壓器
英文描述： SWITCHING REGULATOR, 575 kHz SWITCHING FREQ-MAX, PDSO8
封裝： 0.9 MM HEIGHT, SON-8
文件頁數： 3/20頁
文件大?。?/td> 401K
代理商： R1230D201G-TL
Rev. 1.20
- 11 -
and VOUT=3.6V, phase back becomes also large, and even if the device is used with a heavy load, the operation will
be stable.
Rb is effective for reducing the noise on VFB, however, it is not always necessary. If it is necessary, use as much as
30k
as Rb.
s External Components
1. Inductor
Select an inductor that peak current does not exceed ILmax. If some larger current than allowable current flows,
magnetic saturation occurs and make transform efficiency worse.
Supposed that the load current is at the same, the smaller value of L is used, the larger the ripple current is.
Provided that the allowable current is large in that case and DC current is small, therefore, for large output current,
efficiency is better than using an inductor with a large value of L and vice versa.
2. Capacitor
As for CIN, use a capacitor with low ESR (Equivalent Series Resistance) Ceramic type of a capacity at least 10
F
for stable operation.
COUT can reduce ripple of Output Voltage, therefore as much as 10
F tantalum type is recommended.
3. Diode
If VFM mode is chosen at light load, use a Schottky diode with small VF. A diode with small VF makes the efficiency
of the circuit improved. Small reverse direction current, IR is an important factor, however, VF has more important
priority than IR.
s TIMING CHART
Internal Oscillator Waveform
Internal Operational
Amplifier Output
Internal Soft-start
Set Voltage
Lx Pin Output
Soft-start Time
Stable
Output
Short
Delay Time of Protection
Latched
CE pin Voltage
Output Short
The timing chart as shown above describes the waveforms starting from the IC is enabled with CE and latched with
protection. During the soft-start time, until the level is rising up to the internal soft-start set voltage, the duty cycle of Lx
is gradually wider and wider to prevent the over-shoot of the voltage. During the term, the output of amplifier is “H”,
then after the output voltage reaches the set output voltage, they are balanced with the stable state. Herein, if the
output pin would be short circuit, the output of amplifier would become “H” again, and the condition would continue for
1.5ms (Typ.), latch circuit would work and the output of Lx would be latched with “OFF”. (Output =“High-Z”)
If the output short is released before the latch circuit works (within 1.5ms after output shorted), the output of amplifier
is balanced in the stable state again.
Once the IC is latched, to release the protection, input “L” with CE pin, or make the supply voltage at UVLO level or
相關PDF資料
PDF描述
R1230D281E-TL SWITCHING REGULATOR, 575 kHz SWITCHING FREQ-MAX, PDSO8
R1242S001F-E2-FE SWITCHING REGULATOR, 550 kHz SWITCHING FREQ-MAX, PDSO8
R125.461.171 PANEL MOUNT, FEMALE, SMA CONNECTOR, RECEPTACLE
R125.464.310 PANEL MOUNT, FEMALE, SMA CONNECTOR, RECEPTACLE
R125.612.000 PANEL MOUNT, FEMALE, SMA CONNECTOR, SOLDER, RECEPTACLE
相關代理商/技術參數
參數描述
R1230D211A-TL 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller
R1230D211A-TR 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller
R1230D211B-TL 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller
R1230D211B-TR 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller
R1230D221A-TL 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*