- 您現在的位置：買賣IC網 > PDF目錄296948 > R1230D121F-TR (RICOH COMPANY LTD) SWITCHING REGULATOR, 920 kHz SWITCHING FREQ-MAX, PDSO8 PDF資料下載
參數資料
| 型號： | R1230D121F-TR |
| 廠商： | RICOH COMPANY LTD |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, 920 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 0.9 MM HEIGHT, SON-8 |
| 文件頁數： | 6/26頁 |
| 文件大?。?/td> | 284K |
| 代理商： | R1230D121F-TR |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
R1230D
14
External Components
1.
Inductor
Select an inductor that peak current does not exceed ILmax. If larger current than allowable current flows, mag-
netic saturation occurs and make transform efficiency worse.
Supposed that the load current is at the same, the smaller value of L is used, the larger the ripple current is.
Provided that the allowable current is large in that case and DC current is small, therefore, for large output current,
efficiency is better than using an inductor with a large value of L and vice versa.
2.
Capacitor
As for CIN, use a capacitor with low ESR (Equivalent Series Resistance) Ceramic type of a capacity at least 10F for
stable operation.
COUT can reduce ripple of Output Voltage, therefore as much as 10F tantalum type is recommended.
3.
Diode
If VFM mode is chosen at light load, use a Schottky diode with small VF. A diode with small VF makes the efficiency
of the circuit improved. Small reverse direction current, IR is an important factor, however, VF has more important pri-
ority than IR.
TIMING CHART
Soft-start Time
Internal Soft-start
Set Voltage
CE pin Voltage
Lx Pin Output
Stable
Latched
Output Short
Output
Short
Internal Opertional
Amplifier Output
Internal Oscillator Waveform
Delay Time of Protection
The timing chart as shown above describes the waveforms starting from the IC is enabled with CE and latched with
protection. During the soft-start time, until the level is rising up to the internal soft-start set voltage, the duty cycle of LX
is gradually wider and wider to prevent the over-shoot of the voltage. During the term, the output of amplifier is "H", then
after the output voltage reaches the set output voltage, they are balanced with the stable state. Herein, if the output pin
would be short circuit, the output of amplifier would become "H" again, and the condition would continue for 1.5ms (Typ.),
latch circuit would work and the output of LX would be latched with "OFF". (Output ="High-Z")
If the output short is released before the latch circuit works (within 1.5ms after output shorted), the output of am-
plifier is balanced in the stable state again.
Once the IC is latched, to release the protection, input "L" with CE pin, or make the supply voltage at UVLO level
or less.
相關PDF資料 |
PDF描述 |
|---|---|
| R1230D211F-TR | SWITCHING REGULATOR, 920 kHz SWITCHING FREQ-MAX, PDSO8 |
| R1230D221H-TR | SWITCHING REGULATOR, 920 kHz SWITCHING FREQ-MAX, PDSO8 |
| R1230D141H-TR | SWITCHING REGULATOR, 920 kHz SWITCHING FREQ-MAX, PDSO8 |
| R1230D211G-TR | SWITCHING REGULATOR, 575 kHz SWITCHING FREQ-MAX, PDSO8 |
| R1230D301F-TR | SWITCHING REGULATOR, 920 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| R1230D131A-TL | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller |
| R1230D131A-TR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller |
| R1230D131B-TL | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller |
| R1230D131B-TR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller |
| R1230D141A-TL | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller |
發布緊急采購，3分鐘左右您將得到回復。