參數資料
型號: Q67000-A9284-X201-K5
廠商: SIEMENS AG
英文描述: High Performance Power Combi Controller
中文描述: 高性能功率Combi機控制器
文件頁數: 7/39頁
文件大小: 472K
代理商: Q67000-A9284-X201-K5
TDA 16888
Semiconductor Group
7
Data Sheet 1998-05-06
Both PFC and PWM section are equipped with a peak current limitation, which is realized
by the comparators C3 and C9 sensing at pin 6 (PFC CL) and pin 11 (PWM CS)
respectively. When being activated this current limitation will immediately shut down the
respective gate drive PFC OUT (pin 8) or PWM OUT (pin 10).
Finally each pin is protected against electrostatic discharge.
Oscillator/Synchronization
The PFC and PWM clock signals as well as the PFC voltage ramp are synchronized by
the internal oscillator (see
Figure 18
). The oscillator’s frequency is set by an external
resistor connected to pin 16 (ROSC) and ground (see
Figure 5
). The corresponding
capacitor, however, is integrated to guarantee a low current consumption and a high
resistance against electromagnetic interferences. In order to ensure superior precision
of the clock frequency, the clock signal CLK OSC is derived from a triangular instead of
a saw-tooth signal. Furthermore to provide a clock reference CLK OUT with exactly 50%
duty cycle, the frequency of the oscillator’s clock signal CLK OSC is halved by a D-latch
before being fed into the PFC and PWM section respectively (see
Figure 18
).
The ramp signal of the PFC section
V
PFC RMP
is composed of a slowly falling and a
steeply rising edge. This ramp has been reversed in contrast to the common practice, in
order to simultaneously allow for current measurement at pin 5 (GND S) and for external
compensation of OP2 by means of pin 5 (GND S) and pin 3 (PFC CC).
The oscillator can be synchronized with an external clock signal supplied at pin 12
(SYNC). However, since the oscillator’s frequency is halved before being fed into the
PFC and PWM section, a synchronization frequency being twice the operating frequency
is recommended. As long as the synchronization signal is H the oscillator’s triangular
signal
V
OSC
is interrupted and its clock signal CLK OSC is H (see
Figure 19
and
Figure 20
). However, as soon as the external clock changes from H to L the oscillator is
released. Correspondingly, by means of an external clock signal supplied at pin 12
(SYNC) the oscillator frequency
f
OSC
set by an external resistor at pin 16 (ROSC) can be
varied on principle only within the range from 0.66
f
OSC
to 2
f
OSC
. If the oscillator has to
be synchronized over a wider frequency range, a synchronization by means of the sink
current at pin 16 (ROSC) has to be preferred to a synchronization by means of pin 12
(SYNC). Anyhow, please note, that pin 12 (SYNC) is not meant to permanently
shutdown both PFC and PWM section. It can be used to halt the oscillator freezing the
prevailing state of both drivers but does not allow to automatically shut them down. A
shutdown can be achieved by shorting pin 2 (
V
REF
) to ground, instead.
Finally, In order to reduce the overall current consumption under low load conditions, the
oscillator frequency itself is halved as long as the voltage at pin 13 (PWM SS) is less
than 0.4 V (disabled PWM section).
相關PDF資料
PDF描述
Q67001-A5214 Components for Entertainment Electronics, Satellite Sound IF
Q67003H9339 ICs for Communications
Q67006-A9171 Dynamic Differential Hall Effect Sensor IC
Q67006-A9515 Step Down Voltage-Regulator with Reset
Q67006-A9286 5-V Voltage Regulator
相關代理商/技術參數
參數描述
Q67000-A9295 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:5-A DC Motor Driver with Inhibit
Q67000-A9303 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:1-A DC Motor Driver for Servo Driver Applications
Q67000-A9310-A702 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:High Performance Power Combi Controller
Q67000-A9324 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:5-A H-Bridge for DC-Motor Applications
Q67000-A940 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:LED Driver for Light Spot Displays