
WM_PRJ_Q2400_PTS_002 - 002
24th January 2003
confidential
Page :
32 / 81
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à
des tiers sans son autorisation préalable.
L1, L2, C3 and C4 has to be put near the WISMO Quik Q24x6 Series connector
and can be removed according to their environment (ground plane, shielding
...etc). The best way is to plan all the components and to remove those which
are not necessary to filter out the TDMA noise on the audio path.
2.12.1.3.2
Typical implementation:
Single-ended connection
L1
C1
C2
MIC1P
MIC1N
V
AUDIO
C4
R1
R2
L2
C3
C5
Figure 5 : MIC1 inputs (single-ended connection)
Note : V
AUDIO
must be very “clean” in single-ended connection (for example,
VCC plus filter cell like RC or LC).
R1 = from 100 to 330
R2 = usually between 1K
and 3.3K
as per the V
AUDIO
voltage level and the
microphone characteristics
C1 = 10pF to 33pF
C2 = C3 = C5 = 47pF to 100pF
C4 = 47μF
L1 = L2 = 100nH
R1 is used as a voltage supply filter with C4.
C5 has to be the nearest possible to the microphone. Microphone
manufacturers provide this capacitor directly soldered on the microphone.
C1, C2, C3 have to be very close to the WISMO Quik Q24x6 Series connector.
L1, and L2 has to be put near the WISMO Quik Q24x6 Series connector and
can be removed according to their environment (ground plane, shielding ...etc).
The best way is to plan all the components and to remove those which are not
necessary to filter out the TDMA noise on the audio path.