參數資料
型號: PT7A4408
英文描述: AC Servo Drive Control System Accelerator Software Manual
中文描述: T1/E1/OC3系統同步?
文件頁數: 26/34頁
文件大?。?/td> 306K
代理商: PT7A4408
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Data Sheet
PT7A4402B/4402L
T1/E1 System Synchronizer
PT0100(08/02)
Ver:0
32
Test Conditions:
1. PRI reference input selected.
2. SEC reference input selected.
3. Normal State selected.
4. Holdover State selected.
5. Free-Run State selected.
6. 8kHz frequency source selected.
7. 1.544MHz frequency source selected.
8. 2.048MHz frequency source selected.
9. Master clock input OSCi at 20MHz ±0ppm.
10. Master clock input OSCi at 20MHz ±32ppm.
11. Master clock input OSCi at 20MHz ±100ppm.
12. Selected reference input at ±0ppm.
13. Selected reference input at ±32ppm.
14. Selected reference input at ±100ppm.
15. For Free-Run State of ±0ppm.
16. For Free-Run State of ±32ppm.
17. For Free-Run State of ±100ppm.
18. For capture range of ±230ppm.
19. For capture range of ±198ppm.
20. For capture range of ±130ppm.
21. 25pF capacitive load.
22. OSCi Master Clock Jitter is less than 2ns p-p, or 0.04UI
p-p where 1UI p-p = 1/20MHz.
23. Jitter on reference input is less than 7ns p-p.
24. Applied jitter is sinusoidal.
25. Minimum applied input jitter magnitude to regain syn-
chronization.
26. Loss of synchronization is obtained at slightly higher in-
put jitter amplitudes.
27. Within 10ms of the state, reference or input change.
28. 1UIpp = 125
s for 8kHz signals.
29. 1UIpp = 648ns for 1.544MHz signals.
30. 1UIpp = 488ns for 2.048MHz signals.
31. 1UIpp = 324ns for 3.088MHz signals.
32. 1UIpp = 244ns for 4.096MHz signals.
33. 1UIpp = 122ns for 8.192MHz signals.
34. 1UIpp = 61ns for 16.384MHz signals.
35. No filter.
36. 40Hz to 100kHz bandpass filter.
37. With respect to reference input signal frequency.
38. After a RST or TCLR.
39. Master clock duty cycle 40% to 60%.
40. Prior to Holdover State, device was in Normal State and
phase locked.
Notes:
1. Voltages are with respect to ground (GND) unless otherwise stated.
2. Supply voltage and operation temperature are as per Recommended Operating Conditions.
3. Timing parameters are as per AC Electrical Characteristics - Voltage Levels for Timing Parameter Measurement.
相關PDF資料
PDF描述
PT7A4408L Complete BrainPower Control System Accelerator Verilog Object Code Manual
PT7A4409 Single Axis Bundled System Accelerator1 System Manual
PT7A4409L Complete Motion Control Verilog Library
PT7A4410 PWM Waveform Generator Accelerator Verilog Module
PT7A4410L Incremental Encoder Interface Accelerator Verilog Module
相關代理商/技術參數
參數描述
PT7A4408L 制造商:未知廠家 制造商全稱:未知廠家 功能描述:T1/E1/OC3 System Synchronizer?
PT7A4409 制造商:未知廠家 制造商全稱:未知廠家 功能描述:T1/E1/0C3 System Synchronizer?
PT7A4409L 制造商:未知廠家 制造商全稱:未知廠家 功能描述:T1/E1/0C3 System Synchronizer?
PT7A4410 制造商:未知廠家 制造商全稱:未知廠家 功能描述:T1/E1/OC3 System Synchronizer
PT7A4410J 制造商:未知廠家 制造商全稱:未知廠家 功能描述:T1/E1/OC3 System Synchronizer