- 您現在的位置：買賣IC網 > PDF目錄66055 > PT6725C (TEXAS INSTRUMENTS INC) 14 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA17 PDF資料下載
參數資料
| 型號： | PT6725C |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 14 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA17 |
| 封裝： | ROHS COMPLIANT, SMD-17 |
| 文件頁數： | 5/9頁 |
| 文件大?。?/td> | 205K |
| 代理商： | PT6725C |
For technical support and more information, see inside back cover or visit www.ti.com
Application Notes
Using the Standby Function of the PT6725
Series of Integrated Switching Regulators
The PT6725 series of power modules are high efficiency
regulators that operate off a +12V input bus voltage.
These regulators incorporate an on/off ‘Standby’ func-
tion, which may be used to disable the regulator output.
The standby function is provided by the STBY* control,
pin 2. If pin 2 is left open-circuit the regulator operates
normally, and provides a regulated output when a valid
supply voltage is applied to Vin (pins 4–6) with respect to
GND (pins 8–12). If a low voltage 3 is then applied to
pin 2 the regulator output will be disabled and the input
current drawn by the ISR will be reduced to 0.5mA 1.
The standby control may also be used to hold-off the
regulator output during the period that input power is
applied.
Pin 2 is ideally controlled with an open-collector (or
open-drain) discrete transistor (See Figure 1). The open-
circuit voltage is typcially the input voltage Vin. Table 1
gives the circuit parameters for this control input.
Table 1 Standby Control Requirements (2, 3)
Parameter
Min
Typ
Max
Input Low (VIL)
–0.1V
+0.4V
Istby (pin 2 =ground)
—
–0.5mA
—
Vstby (open circuit)
—
Vin
—
Notes:
1. When the regulator output is disabled the current drawn
from the +Vin input source is typically reduced to 0.5mA.
2 The standby control input requires no external pull-up
resistor. The open-circuit voltage of the STBY* pin is
approximately th input voltage Vin (+12V).
3. The standby control input is Not compatible with TTL
devices that incorporate a totem-pole output drive. Use
only a true open-collector device, preferably a discrete
bipolar transistor (or MOSFET). To ensure the regulator
output is disabled, the control pin must be pulled to less
than 0.4Vdc with a low-level 0.5mA sink to ground.
4. After Q1 in Figure 1 is turned off and before the output
begins to rise, the regulator output will assert a low
impedance to ground. If an external voltage is applied to
the output it will sink current and possibly over-stress the
part.
Figure 1
Turn-On Time:
In the circuit of Figure 1, turning Q1 on
applies a low voltage to the STBY control (pin 2) and
disables the regulator ouput. Correspondingly, turning
Q1 off removes the low-voltage signal and enables the
output. Once enabled, the output will typically experience
a 10–15ms delay followed by a predictable ramp-up of
voltage. The regulator should provide a fully regulated
output voltage within 30ms. Figure 2 shows the output
voltage response, Vo, of a PT6726 (2.5V) following the
turn-off of Q1. The turn-off of Q1 corresponds to the
rise in Vstby. The waveform was measured with a 12Vdc
input voltage, and 9.3ADC resistive load.
Figure 2
PT6725
Sense(+)
Sense(–)
V
OUT
GND
Vo(adj)
V
IN
STBY*
13–16
17
7
1
8–12
4–6
2
C
OUT
+
C
IN
+
STBY
+V
in
GND
V
out
Q1
BSS138
PT6725 Series
Vo (1V/Div)
Vstby (10V/Div)
HORIZ SCALE: 5ms/Div
相關PDF資料 |
PDF描述 |
|---|---|
| PT6725A | 14 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA17 |
| PT6729C | 13 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA17 |
| PT6726C | 14 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA17 |
| PT6728C | 13 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA17 |
| PT6729A | 13 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA17 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PT6725N | 功能描述:開關變換器、穩壓器與控制器 3.3Vout 13A 12V Inp Adjustable ISR RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| PT6726 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:14-A 12V-Input Adjustable Integrated Switching Regulator |
| PT6726A | 功能描述:開關變換器、穩壓器與控制器 2.5Vout 14A 12V-Inp CU Case Adj ISR RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| PT6726C | 功能描述:REGULTR 2.5V 14A CU CASE HRZ SMD RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:PT6720 標準包裝:10 系列:PT4570 類型:隔離 輸出數:1 電壓 - 輸入（最?。?36V 電壓 - 輸入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:3.3A 電源（瓦） - 制造商系列:30W 電壓 - 隔離:1.5kV（1500V） 特點:- 安裝類型:表面貼裝 封裝/外殼:19-SIP SMD 模塊 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包裝:托盤 工作溫度:-40°C ~ 85°C 效率:84% 電源（瓦特）- 最大:30W |
| PT6726N | 功能描述:開關變換器、穩壓器與控制器 2.5Vout 14A 12V-Inp CU Case Adj ISR RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。