參數資料
型號: PT5813N
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 19 A SWITCHING REGULATOR, 350 kHz SWITCHING FREQ-MAX, SMA18
封裝: SIP-18
文件頁數: 8/12頁
文件大小: 226K
代理商: PT5813N
For technical support and more information, see inside back cover or visit www.ti.com
Application Notes
Startup of the PT5800 & PT5810 Series ISRs
with Back-Feeding Source (Pre-Bias Capability)
In complex digital systems an external voltage can
sometimes be present at the output of the regulator
during power up. For example, this voltage may be
backfed through a dual-supply logic component such as
an FPGA or ASIC. Another path might be via a clamp
diode (to a lower supply voltage) as part of a power-up
sequencing implementation.
Although the PT5800 (5-V input) and PT5810 (3.3-V
input) series of regulators will sink current under steady-
state operating conditions, they will not do so during
startup 1 as long as certain conditions are maintained 2.
This feature allows these regulators to start up while an
external voltage is simultaneously applied to the output.
Figure 2-1 is an application schematic that demonstrates
this capability. The waveforms in Figure 2-2 show the
behavior of the circuit as input power is applied. Note
that the plot of the regulator output current (Io) is approxi-
mately zero up to the timestamp ‘A’, even though a voltage
is initially backfed to the output via the 3.3-V input supply
and diodes D1 & D2. The regulator sources current 3 when
it begins raising the output above the back-fed voltage to
its nominal regulation value.
Notes
1. Startup includes both the application of a valid input
source voltage, or the removal of a ground signal from
the Inhibit* control (pin 2) with a valid input source
applied. The output of the regulator is effectively off
(tri-state), during the period that the Inhibit* control is
held low.
Vin (1V/Div)
Vo (1V/Div)
Io (5A/Div)
HORIZ SCALE 5ms/Div
A
Figure 2-2; Power-up Waveforms with Back-Feeding Source
Figure 2-1; Schematic Demonstrating Startup into Pre-Bias Capability
PT5812
14–17
9–13
5–7
V
IN
V
OUT
GND
C
out
+
C
IN
+
(3.3 VDC)
COM
V
IN
V
O (2.5 V)
8
18
Sense(+)
Sense(–)
D
2
I
o
D
1
2. To ensure that the regulator does not sink current, the
input voltage must always be greater or equal to the
output voltage throughout the power-up and power-down
sequence.
3. If an external source backfeeding the regulator’s output
is greater than the nominal regulation voltage, the output
will begin sinking current at the end of its soft-start
power-up sequence. If this current exceeds the rated
output, the module could be overstressed.
PT5800 & PT5810 Series
相關PDF資料
PDF描述
PT5812N 19 A SWITCHING REGULATOR, 350 kHz SWITCHING FREQ-MAX, SMA18
PT5815C 20 A SWITCHING REGULATOR, 350 kHz SWITCHING FREQ-MAX, MSSO18
PT5815A 19 A SWITCHING REGULATOR, 350 kHz SWITCHING FREQ-MAX, SMA18
PT5814A 20 A SWITCHING REGULATOR, 350 kHz SWITCHING FREQ-MAX, MSIP18
PT5816A 20 A SWITCHING REGULATOR, 350 kHz SWITCHING FREQ-MAX, MSIP18
相關代理商/技術參數
參數描述
PT5814 制造商:未知廠家 制造商全稱:未知廠家 功能描述:1.5V 20-A. 3.3-V Input Adjustable Step-Down ISR
PT5814A 功能描述:開關變換器、穩壓器與控制器 1.5V 20-A 3.3V Inpt Adj Step-Down ISR RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel
PT5814C 功能描述:DC/DC轉換器 1.5V 20-A 3.3V Inpt Adj Step-Down ISR RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓(標稱): 輸出端數量:1 輸出電壓(通道 1):3.3 V 輸出電流(通道 1):600 mA 輸出電壓(通道 2): 輸出電流(通道 2): 安裝風格:SMD/SMT 封裝 / 箱體尺寸:
PT5814N 功能描述:開關變換器、穩壓器與控制器 1.5V 20-A 3.3V Inpt Adj Step-Down ISR RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel
PT5815 制造商:未知廠家 制造商全稱:未知廠家 功能描述:1.2V 20-A. 3.3-V Input Adjustable Step-Down ISR