- 您現在的位置：買賣IC網 > PDF目錄383778 > PS2653 (NEC Corp.) Optocoupler Applications PDF資料下載
參數資料
| 型號： | PS2653 |
| 廠商： | NEC Corp. |
| 英文描述： | Optocoupler Applications |
| 中文描述： | 光耦應用 |
| 文件頁數： | 27/38頁 |
| 文件大小： | 223K |
| 代理商： | PS2653 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
26
Standard characteristics
V
CE
= 5V
600
500
400
300
200
100
0
0.1
0.5
1
5
10
50
Sample A
Sample B
C
Forward Current I
F
(mA)
Figure 9. CTR vs. I
F
Characteristics (Standard Value)
Response Characteristics
The response characteristics of optocouplers are the same as those phototransistors. The fall time t
f
is expressed by:
t
f
R
L
h
FE
C
CB
R
L
: Load resistance
h
FE
: Amplification factor
C
CB
: Collector-base capacitance
If R
L
is too high, t
f
becomes too high to be fit for high-speed signal transmission. Select the proper load resistance for the desired
signal rate. Similarly, the collector current must fully satisfy the minimum value of the CTR, CTR vs. T
A
characteristics, and CTR
vs. time characteristics. Otherwise, the phototransistor will operate unsaturated, causing lower response characteristics and
malfunction.
Figures 10 to 13 show the response-time vs. forward current characteristics and response-time vs. V
CC
characteristics, using load
resistance and ambient temperature as parameters.
CTR vs. I
F
Characteristics (I
F
: Forward Current Flowing Through the LED)
The current transfer ratio (CTR) depends upon the magnitude of a forward current (I
F
). When I
F
goes lower or higher than a
proper magnitude, the CTR becomes smaller. Figure 9 shows the CTR vs. I
F
characteristics.
Note that rate changes of CTRs are very diffrent at low I
F
magnitude (approx. 5 mA), middle I
F
magnitude (approx. 5 mA), and
high I
F
magnitude (approx. 20 mA). Namely, the CTR depends heavily upon the magnitude of forward current I
F
in lower and
higher current ranges.
For low-input and high-output switching, see Chapter 4.
相關PDF資料 |
PDF描述 |
|---|---|
| PS2653L2 | Optocoupler Applications |
| PS2654L2 | Optocoupler Applications |
| PS2625 | HIGH ISOLATION VOLTAGE AC INPUT LARGE FORWARD AC INPUT TYPE 6 PIN PHOTOCOUPLER |
| PS2625L | HIGH ISOLATION VOLTAGE AC INPUT LARGE FORWARD AC INPUT TYPE 6 PIN PHOTOCOUPLER |
| PS2626 | HIGH ISOLATION VOLTAGE AC INPUT LARGE FORWARD AC INPUT TYPE 6 PIN PHOTOCOUPLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PS2653L2 | 制造商:NEC 制造商全稱:NEC 功能描述:Optocoupler Applications |
| PS2654 | 制造商:NEC 制造商全稱:NEC 功能描述:Optocoupler Applications |
| PS2654L2 | 制造商:NEC 制造商全稱:NEC 功能描述:Optocoupler Applications |
| PS2654-V | 功能描述:晶體管輸出光電耦合器 DISC BY CEL 3/01 DIP-6 1CH OPTOCPLR RoHS:否 制造商:Vishay Semiconductors 輸入類型:DC 最大集電極/發射極電壓:70 V 最大集電極/發射極飽和電壓:0.4 V 絕緣電壓:5300 Vrms 電流傳遞比:100 % to 200 % 最大正向二極管電壓:1.65 V 最大輸入二極管電流:60 mA 最大集電極電流:100 mA 最大功率耗散:100 mW 最大工作溫度:+ 110 C 最小工作溫度:- 55 C 封裝 / 箱體:DIP-4 封裝:Bulk |
| PS266528-01 | 功能描述:環形MIL規格后蓋 RoHS:否 制造商:Amphenol PCD MIL 類型:MIL-DTL-38999 III, IV 系列:AS85049 產品類型:Environmental EMI/RFI Backshells 外殼類型:Straight 外殼大小:18 外殼材質:Aluminum Alloy |
發布緊急采購，3分鐘左右您將得到回復。