參數資料
型號: PMN8118UWS
廠商: ERICSSON POWER MODULES AB
元件分類: 電源模塊
英文描述: 1-OUTPUT 108 W DC-DC REG PWR SUPPLY MODULE
封裝: ROHS COMPLIANT PACKAGE-14
文件頁數: 30/49頁
文件大小: 3681K
代理商: PMN8118UWS
Ericsson Internal
PRODUCT SPECIFICATION
4 (12)
Prepared (also subject responsible if other)
No.
EYIPYAN
3/1301-BMR656 8118 Uen
Approved
Checked
Date
Rev
Reference
SEC/D (Julia You)
EQUENXU
2007-7-9
B
to parallel the regulators without using external current
sharing circuits.
Remote Sense
The DC/DC regulators have remote sense that can be used
to compensate for voltage drops between the output and
the point of load. The sense traces should be located close
to the PCB ground layer to reduce noise susceptibility. The
remote sense circuitry will compensate for up to 10%
voltage drop between output pins and the point of load.
If the remote sense is not needed +Sense should be
connected to +Out and -Sense should be connected to -
Out.
Over Temperature Protection (OTP)
The regulators are protected from thermal overload by an
internal over temperature shutdown circuit.
When Tref as defined in thermal consideration section
exceeds the OTP threshold, the regulator will shut down.
The DC/DC regulator will make continuous attempts to start
up (non-latching mode) and resume normal operation
automatically when the temperature has dropped >10°C
below the temperature threshold.
Over Current Protection (OCP)
The regulators include current limiting circuitry for
protection at continuous overload.
The output voltage will decrease towards zero for output
currents in excess of max output current (max IO). The
regulator will resume normal operation after removal of the
overload. The load distribution should be designed for the
maximum output short circuit current specified.
Soft-start Power Up
From the moment a valid input voltage is applied, the soft-
start control introduces a short time-delay (typically 5-10
ms) before allowing the output voltage to rise.
The initial rise in input current when the input voltage first
starts to rise is the charge current drawn by the input
capacitors. Power-up is complete within 15 ms.
Auto Track Function
Auto TrackTM was designed to simplify the amount of
circuitry required to make the output voltage from each
module power up and power down in sequence. The
sequencing of two or more supply voltages during power
up is a common requirement for complex mixed-signal
applications, that use dual-voltage VLSI ICs such as DSPs,
micro-processors and ASICs.
Adjustable Undervoltage Lockout
The regulators incorporate an input undervoltage lockout
(UVLO). The UVLO feature prevents the operation of the
module until there is a sufficient input voltage to produce a
valid output voltage. This enables the module to provide a
clean, monotonic powerup for the load circuit and also limit
the magnitude of current drawn from regulator’s input
source during the power-up sequence.
The UVLO characteristic is defined by the ON threshold
(V
THD
) voltage. Below the ON threshold, the Inhibit control is
overridden, and the moudule does not produce an output.
The hysterisis voltage, which is the difference oscillations,
which can occur if the input voltage drops slightly when the
modules begins to draw current from the input source.
The UVLO feature of the PMN 8118UW P module allows for
limited adjustment of the ON threshold voltage. The
adjustment is made via the Inhibit/UVLO Prog control pin
(Pin 1) using a single resistor (see figure below). When pin
1 is left open, the ON threshold voltage is intermally set to
its default value. The ON threshold has a nominal voltage of
5.0 V and a hysterisis of 900 mV. This ensures that the
module produces a regulated output when the minimum
input voltage is applied. The ON threshold might need to
be increased if the module is powered from a tightly
regulated 12 V bus. This allows the ON threshold voltage to
be set for a specified input voltage. Adjusting the threshold
voltage prevents the module from operating if the input
E
PMN 8000 series
PoL Regulator
Input 5.5 - 14 V, Output up to 30 A / 108 W
EN/LZT 146 387 R1B December 2009
Ericsson AB
Technical Specication
36
相關PDF資料
PDF描述
PMP5818UWSR 1-OUTPUT 88 W DC-DC REG PWR SUPPLY MODULE
PQ1CF2 1.5 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM5
PQ1CF2J0000H 1.5 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM5
PQ30033QGA30PYS 1-OUTPUT 99.99 W DC-DC REG PWR SUPPLY MODULE
PQ30033QGA30NRS 1-OUTPUT 99.99 W DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
PMN8118UWSR 功能描述:DC/DC轉換器 0.7-3.6V 30A Non-Iso Input 5.5-14V 108W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓(標稱): 輸出端數量:1 輸出電壓(通道 1):3.3 V 輸出電流(通道 1):600 mA 輸出電壓(通道 2): 輸出電流(通道 2): 安裝風格:SMD/SMT 封裝 / 箱體尺寸:
PMN8118UWSR/C 制造商:Ericsson 功能描述:30A 5.5V TO 14V INP NON-ISOL ADJ -40+85 DIPMOD-14 LF - Tape and Reel 制造商:Ericsson 功能描述:30A 5.5V TO 14V INP NON-ISOL LF
PMNF1-35R-3K 功能描述:端子 Metric Ring Terminal funnel entry, nyl RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp
PMNF1-3F-3K 功能描述:端子 Metric Fork Terminal funnel entry, nyl RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp
PMNF1-3F-C 功能描述:端子 METRIC FK TERML RED 0.5-1.5mm RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp