參數資料
型號： PMN8118UWP
廠商： ERICSSON POWER MODULES AB
元件分類： 電源模塊
英文描述： 1-OUTPUT 108 W DC-DC REG PWR SUPPLY MODULE
封裝： ROHS COMPLIANT PACKAGE-14
文件頁數： 21/37頁
文件大?。?/td> 2048K
代理商： PMN8118UWP
Ericsson Internal
PRODUCT SPECIFICATION
3 (8)
Prepared (also subject responsible if other)
No.
EYIPYAN
3/1301-BMR656 8118 Uen
Approved
Checked
Date
Rev
Reference
SEC/D (Julia You)
EQUENXU
2007-7-9
B
If the remote sense is not needed +Sense should be
connected to +Out and -Sense should be connected to -Out.
Over Temperature Protection (OTP)
The regulators are protected from thermal overload by an
internal over temperature shutdown circuit.
When Tref as defined in thermal consideration section
exceeds the OTP threshold, the regulator will shut down. The
DC/DC regulator will make continuous attempts to start up
(non-latching mode) and resume normal operation
automatically when the temperature has dropped >10°C
below the temperature threshold.
Over Current Protection (OCP)
The regulators include current limiting circuitry for protection
at continuous overload.
The output voltage will decrease towards zero for output
currents in excess of max output current (max IO). The
regulator will resume normal operation after removal of the
overload. The load distribution should be designed for the
maximum output short circuit current specified.
Soft-start Power Up
From the moment a valid input voltage is applied, the soft-
start control introduces a short time-delay (typically 5-10 ms)
before allowing the output voltage to rise.
The initial rise in input current when the input voltage first
starts to rise is the charge current drawn by the input
capacitors. Power-up is complete within 15 ms.
Auto Track Function
Auto TrackTM was designed to simplify the amount of circuitry
required to make the output voltage from each module
power up and power down in sequence. The sequencing of
two or more supply voltages during power up is a common
requirement for complex mixed-signal applications, that use
dual-voltage VLSI ICs such as DSPs, micro-processors and
ASICs.
Adjustable Undervoltage Lockout
The regulators incorporate an input undervoltage lockout
(UVLO). The UVLO feature prevents the operation of the
module until there is a sufficient input voltage to produce a
valid output voltage. This enables the module to provide a
clean, monotonic powerup for the load circuit and also limit
the magnitude of current drawn from regulator’s input source
during the power-up sequence.
The UVLO characteristic is defined by the ON threshold (VTHD)
voltage. Below the ON threshold, the Inhibit control is
overridden, and the moudule does not produce an output.
The hysterisis voltage, which is the difference oscillations,
which can occur if the input voltage drops slightly when the
modules begins to draw current from the input source.
The UVLO feature of the PMN 8118UW P module allows for
limited adjustment of the ON threshold voltage. The
adjustment is made via the Inhibit/UVLO Prog control pin (Pin
1) using a single resistor (see figure below). When pin 1 is left
open, the ON threshold voltage is intermally set to its default
value. The ON threshold has a nominal voltage of 5.0 V and a
hysterisis of 900 mV. This ensures that the module produces
a regulated output when the minimum input voltage is
applied. The ON threshold might need to be increased if the
module is powered from a tightly regulated 12 V bus. This
allows the ON threshold voltage to be set for a specified input
voltage. Adjusting the threshold voltage prevents the module
from operating if the input bus fails to completely rise to its
specified regulation voltage.
The below equation determines the value of RUVLO required to
adjust VTHD to a new value. The default value is 5 V and it may
only be adjusted to a higher value.
)
(
100
)
1
(
9
.
24
))
1
(
9
.
24
(
2590
×
×
=
k
V
R
THD
UVLO
The above table lists the standard resistor values for RUVLO for
different values of the ON threshold (VTHD) voltage.
The figure of UVLO Program Resistor Placement is as follow.
Turbo TransTM Technology
Turbo TransTM optimizes the transient response of the
regulator with added external capacitance using a single
external resistor. The benefits of this technology include:
reduced output capacitance, minimized output voltage
deviation following a load transient, and enhanced stability
when using ultra-low ESR output capacitors. The amout of
output capacitance required to meet a target output voltage
deviation, is reduded with Turbo TransTM activated. Likewise,
for a given amout of output capacitance, with Turbo TransTM
engaged, the amplitude of the voltage deviation following a
load transient is reduced. Applications requiring tight
transient voltage tolerances and minimized capacitor footprint
area benefit from this technology.
E
PMN 8000 series
POL regulator, Input 5.5-14 V, Output up to 30 A/108 W
EN/LZT 146 387 R1A
July 2007
Ericsson Power Modules AB
Technical Specification
28
相關PDF資料
PDF描述
PMN8118UWS 1-OUTPUT 108 W DC-DC REG PWR SUPPLY MODULE
PMP5818UWSR 1-OUTPUT 88 W DC-DC REG PWR SUPPLY MODULE
PQ1CF2 1.5 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM5
PQ1CF2J0000H 1.5 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM5
PQ30033QGA30PYS 1-OUTPUT 99.99 W DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
PMN8118UWP/B 制造商:Ericsson 功能描述:CONVERTER/PMN8118UW P 5.5-14VIN/0.7-3.6V - Trays
PMN8118UWS 功能描述:DC/DC轉換器 .7-3.6 Vdc 30A Iso Input 4.5-5.5V 108W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸:
PMN8118UWSR 功能描述:DC/DC轉換器 0.7-3.6V 30A Non-Iso Input 5.5-14V 108W RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸:
PMN8118UWSR/C 制造商:Ericsson 功能描述:30A 5.5V TO 14V INP NON-ISOL ADJ -40+85 DIPMOD-14 LF - Tape and Reel 制造商:Ericsson 功能描述:30A 5.5V TO 14V INP NON-ISOL LF
PMNF1-35R-3K 功能描述:端子 Metric Ring Terminal funnel entry, nyl RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*