- 您現在的位置：買賣IC網 > PDF目錄98055 > PMF4218TSR (ERICSSON POWER MODULES AB) 1-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PMF4218TSR |
| 廠商： | ERICSSON POWER MODULES AB |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT, SMD-10 |
| 文件頁數： | 15/29頁 |
| 文件大小： | 663K |
| 代理商： | PMF4218TSR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
Ericsson Internal
PRODUCT SPEC.
3 (5)
Prepared (also subject responsible if other)
No.
SEC/D KEVIN YAN
3/1301-BMR 643 4 Uen
Approved
Checked
Date
Rev
Reference
SEC/D (Wei Zhang A)
2006-02-08
A
Soft-start Power Up
From the moment a valid input voltage is applied, the soft-
start control introduces a short time-delay (typically 5-10 ms)
before allowing the output voltage to rise.
The initial rise in input current when the input voltage first
starts to rise is the charge current drawn by the input
capacitors. Power-up is complete within 15 ms.
Auto-Track Function
Auto-Track was designed to simplify the amount of circuitry
required to make the output vltage from each module power
up and power down in sequence. The sequencing of two or
more supply voltages during power up is a common
requirement for complex mixed-signal applications, that use
dual-voltage VLSI ICs such as DSPs, micro-processors and
ASICs.
Margin Up/Down controls
These controls allow the input voltage to be momentarily
adjusted, either up or down, by a nominal 5 %. This provides
a convenient method for dynamically testing the operation of
the load circuit over its supply margin or range. It can also be
used to verify the function of supply voltage supervisors.
Pre-Bias Startup Capability
This often occurs in complex digital systems when current
from another power source is backfed through a dual-supply
logic component, such as FPGA or ASIC.
The PMF(3.3/5.0V Vin) incorporate synchronous rectifiers, but
will not sink current during startup, or whenever the Inhibit pin
is held low. However, to ensure satisfactory operation of this
function, certain conditions must be maintained.
Thermal Consideration
General
The regulators are designed to operate in different thermal
environments and sufficient cooling must be provided to
ensure reliable operation.
Cooling is achieved mainly by conduction, from the pins to
the host board, and convection, which is dependant on the
airflow across the regulator. Increased airflow enhances the
cooling of the regulator.
The Output Current Derating graph found in the Output
section for each model provides the available output current
vs. ambient air temperature and air velocity at Vin = 3.3 V.
The DC/DC regulator is tested on a 254 x 254 mm,
35 μm (1 oz), 8-layer test board mounted vertically in a wind
tunnel with a cross-section of 305 x 305 mm.
Proper cooling of the DC/DC regulator can be verified by
measuring the temperature at positions P1, P2 and P3. The
temperature at these positions should not exceed the max
values provided in the table below.
Note that the max value is the absolute maximum rating
(non destruction) and that the electrical Output data is
guaranteed up to Tref +85°C.
See Design Note 019 for further information.
Position
Device
Designation
max value
P1
Pcb
130 C
P2
Mosfet
Tref
125 C
P3
Inductor
130 C
E
PMF 4000 series
POL regulator, Input 2.95-3.65 V, Output 10 A/25 W
EN/LZT 146 316 R1B February 2006
Ericsson Power Modules AB
Technical Specication
E
PMF 4000 series
POL regulator, Input 2.95-3.65 V, Output 10 A/25 W
EN/LZT 146 316 R1B April 2006
Ericsson Power Modules AB
Technical Specication
E
PMF 4000 series
POL regulator, Input 2.95-3.65 V, Output 10 A/25 W
EN/LZT 146 316 R1C Aug 2007
Ericsson Power Modules AB
Technical Specication
22
相關PDF資料 |
PDF描述 |
|---|---|
| PMF4218TP | 1-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE |
| PMF4218TS | 1-OUTPUT 25 W DC-DC REG PWR SUPPLY MODULE |
| PMF5118VSRF | 1-OUTPUT 12.5 W DC-DC REG PWR SUPPLY MODULE |
| PMF5118VPF | 1-OUTPUT 12.5 W DC-DC REG PWR SUPPLY MODULE |
| PMF5118VSF | 1-OUTPUT 12.5 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PMF4218TSR/B | 制造商:Ericsson 功能描述:DC/DC PS SGL-OUT 0.8V TO 2.5V 10A 45W - Trays |
| PMF4218TSR/C | 制造商:Ericsson 功能描述:DC/DC PS SGL-OUT 0.8V TO 2.5V 10A 45W - Tape and Reel |
| PM-F44 | 制造商:PANASONIC ELECTRIC WORKS ACSD 功能描述:SENSOR,SMALL CABLE F TYPE,LO/DO,5MM FIXED 制造商:PANASONIC ELECTRIC WORKS - ACSD 功能描述:SENSOR PHOTO 5MM 5-24VDC NPN 制造商:PANASONIC INDUSTRIAL AUTOMATION SALES 功能描述:SENSOR PHOTO 5MM 5-24VDC NPN 制造商:Panasonic Electric Works 功能描述:SENSOR PHOTO 5MM NPN 制造商:Panasonic Electric Works 功能描述:SENSOR, PHOTO, 5MM, NPN 制造商:Panasonic Electric Works 功能描述:SENSOR, PHOTO, 5MM, NPN; Sensing Range Max:5mm; Output Current:50mA; Sensor Output:NPN; Supply Voltage DC Min:5V; Supply Voltage DC Max:24V; Sensing Range:0mm to 5mm; Supply Voltage Range DC:5V to 24V ;RoHS Compliant: Yes 制造商:Panasonic Electric Works 功能描述:Photointerrupter Transmissive 5mm Photologic, Open Collector |
| PM-F44-C3 | 制造商:PANASONIC ELECTRIC WORKS - ACSD 功能描述:SENSOR PHOTO 5MM 5-24VDC NPN 制造商:PANASONIC INDUSTRIAL AUTOMATION SALES 功能描述:SENSOR PHOTO 5MM 5-24VDC NPN |
| PMF44P | 制造商:Panasonic Electric Works 功能描述:U-shaped thru-beam sensor,PMF44P |
發布緊急采購，3分鐘左右您將得到回復。