- 您現在的位置：買賣IC網 > PDF目錄65942 > PKF4221ASI (ERICSSON POWER MODULES AB) 2-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PKF4221ASI |
| 廠商： | ERICSSON POWER MODULES AB |
| 元件分類： | 電源模塊 |
| 英文描述： | 2-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 7/8頁 |
| 文件大?。?/td> | 251K |
| 代理商： | PKF4221ASI |
7
EN/LZT 146 040 R1A Ericsson Power Modules AB, October 2003
Characteristics
min
typ
max
Unit
High level
2.2
6.5
V
Threshold level
*)
1.2
1.7
2.2
V
Low level
0
0.4
V
Sink current
1.5
mA
Sync. frequency
520
688
kHz
Version
Part No.
Surface mount
4221A SI
Output Voltage Adjust (Vadj)
Output voltage, VO, can be adjusted by using an external
resistor or other external circuitry. If other circuitry is used,
the slew rate has to be limited to maximum 5 V/ms. If pins
8 and 9 are not connected together the output will decrease
to a low value. To increase VO a resistor should be connected
between pin 8/9 and 17, and to decrease VO a resistor should be
connected between pin 8 and 9 (see g. 3).
To increase output voltage:
Rounom=4.3×(15.25-VO)/(VO-VI) k
Vi is the initial output voltage when pin 8 and 9 are connected,
VO is the desired output voltage.
To decrease output voltage:
Rodnom=16.5×(VI-VO)/(VO-8.85) k
Vi is the initial output voltage when pin 8 and 9 are connected,
VO is the desired output voltage.
Figure 3
Current Limiting Protection (Ilim)
The output power is limited at loads above the output current
limiting threshold (Ilim), specied as a minimum value.
Capacitive Load
The PKF series has no maximum limit for capacitive load
on the output. The power module may operate in current
limiting mode during start-up, affecting the ramp-up and the
start-up time. For optimum start performance we recommend
maximum 100 F/A of IO. Connect capacitors at the point of
load for best performance.
Parallel Operation
Paralleling of several converters is easily accomplished by
direct connection of the output voltage terminal pins. The load
regulation characteristic is specically designed for optimum
paralleling performance. Load sharing between converters will
be within ±10%. It is recommended not to exceed PO = n ×
0.9 × POmax, where POmax is the maximum converter output
power and n the number of paralleled converters, to prevent
overloading any of the converters and thereby decreasing the
reliability performance.
Ordering Information
*)
Rise time <10ns
Input and Output Impedance
Both the source impedance of the power feeding and the load
impedance will interact with the impedance of the DC/DC
power module.
Due to the low energy storage capability of the power module,
it is very important to maintain a low characteristic impedance
at the input and output of the module i.e. a low ratio between
L and C.
Use an electrolytic capacitor across the input if the source
inductance is higher than 10 H. Their equivalent series
resistance together with the capacitance acts as a lossless
damping lter. Suitable capacitor values are in the range 10–
100 F.
Synchronization (Sync)
It is possible to synchronize the switching frequency to an
external symmetrical clock signal. The input can be driven by
an TTL-compatible output and referenced to the input pin 17.
Figure 2
相關PDF資料 |
PDF描述 |
|---|---|
| PKF4510PI | 1-OUTPUT 5 W DC-DC REG PWR SUPPLY MODULE |
| PKF4713SI | 1-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| PKF4621SI | 2-OUTPUT 6 W DC-DC REG PWR SUPPLY MODULE |
| PKF4628PI | 2-OUTPUT 6 W DC-DC REG PWR SUPPLY MODULE |
| PKF4621PI | 2-OUTPUT 6 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PKF4310 | 制造商:ERICSSON 制造商全稱:Ericsson 功能描述:3?7 W DC/DC Power Modules 48 V Input Series |
| PKF4310PI | 制造商:Ericsson 功能描述: |
| PKF4310SI | 制造商:ERICSSON 制造商全稱:Ericsson 功能描述:3?7 W DC/DC Power Modules 48 V Input Series |
| PKF4510 | 制造商:ERICSSON 制造商全稱:Ericsson 功能描述:3?7 W DC/DC Power Modules 48 V Input Series |
| PKF4510PI | 制造商:Ericsson 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。