參數資料
型號: PIC16F871T-E/L
廠商: Microchip Technology
文件頁數: 71/143頁
文件大?。?/td> 0K
描述: IC MCU CMOS 20MHZ 2K FLSH 44PLCC
標準包裝: 500
系列: PIC® 16F
核心處理器: PIC
芯體尺寸: 8-位
速度: 20MHz
連通性: UART/USART
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 33
程序存儲器容量: 3.5KB(2K x 14)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 64 x 8
RAM 容量: 128 x 8
電壓 - 電源 (Vcc/Vdd): 4 V ~ 5.5 V
數據轉換器: A/D 8x10b
振蕩器型: 外部
工作溫度: -40°C ~ 125°C
封裝/外殼: 44-LCC(J 形引線)
包裝: 帶卷 (TR)
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁當前第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁
2003 Microchip Technology Inc.
DS30569B-page 31
PIC16F870/871
At the completion of the write cycle, the WR bit is
cleared and the EEIF interrupt flag bit is set. (EEIF
must be cleared by firmware.) Since the microcontroller
does not execute instructions during the write cycle, the
firmware does not necessarily have to check either
EEIF, or WR, to determine if the write had finished.
EXAMPLE 3-4:
FLASH PROGRAM WRITE
3.7
Write Verify
The PIC16F870/871 devices do not automatically ver-
ify the value written during a write operation. Depend-
ing on the application, good programming practice may
dictate that the value written to memory be verified
against the original value. This should be used in appli-
cations where excessive writes can stress bits near the
specified endurance limits.
3.8
Protection Against Spurious
Writes
There are conditions when the device may not want to
write to the EEPROM data memory or FLASH program
memory. To protect against these spurious write condi-
tions, various mechanisms have been built into the
PIC16F870/871 devices. On power-up, the WREN bit
is cleared and the Power-up Timer (if enabled)
prevents writes.
The write initiate sequence and the WREN bit together,
help prevent any accidental writes during brown-out,
power glitches, or firmware malfunction.
3.9
Operation While Code Protected
The PIC16F870/871 devices have two code protect
mechanisms, one bit for EEPROM data memory and
two bits for FLASH program memory. Data can be read
and written to the EEPROM data memory, regardless
of the state of the code protection bit, CPD. When code
protection is enabled and CPD cleared, external
access via ICSP is disabled, regardless of the state of
the program memory code protect bits. This prevents
the contents of EEPROM data memory from being read
out of the device.
The state of the program memory code protect bits,
CP0 and CP1, do not affect the execution of instruc-
tions out of program memory. The PIC16F870/871
devices can always read the values in program mem-
ory, regardless of the state of the code protect bits.
However, the state of the code protect bits and the
WRT bit will have different effects on writing to program
memory. Table 4-1 shows the effect of the code protect
bits and the WRT bit on program memory.
Once code protection has been enabled for either
EEPROM data memory or FLASH program memory,
only a full erase of the entire device will disable code
protection.
BSF
STATUS, RP1
;
BCF
STATUS, RP0
;Bank 2
MOVF
ADDRL, W
;Write address
MOVWF
EEADR
;of desired
MOVF
ADDRH, W
;program memory
MOVWF
EEADRH
;location
MOVF
VALUEL, W
;Write value to
MOVWF
EEDATA
;program at
MOVF
VALUEH, W
;desired memory
MOVWF
EEDATH
;location
BSF
STATUS, RP0
;Bank 3
BSF
EECON1, EEPGD ;Point to Program memory
BSF
EECON1, WREN
;Enable writes
;Only disable interrupts
BCF
INTCON, GIE
;if already enabled,
;otherwise discard
MOVLW
0x55
;Write 55h to
MOVWF
EECON2
;EECON2
MOVLW
0xAA
;Write AAh to
MOVWF
EECON2
;EECON2
BSF
EECON1, WR
;Start write operation
NOP
;Two NOPs to allow micro
NOP
;to setup for write
;Only enable interrupts
BSF
INTCON, GIE
;if using interrupts,
;otherwise discard
BCF
EECON1, WREN
;Disable writes
相關PDF資料
PDF描述
PIC16F871-E/PT IC MCU CMOS 20MHZ 2K FLSH 44TQFP
PIC16F871-E/L IC MCU CMOS 20MHZ 2K FLSH 44PLCC
PIC16F870T-E/SS IC MCU CMOS 20MHZ 2K FLSH 28SSOP
PIC16F870T-E/SO IC MCU CMOS 20MHZ 2K FLSH 28SOIC
PIC16F84AT-20E/SS IC MCU CMOS 20MHZ 1K FLSH 20SSOP
相關代理商/技術參數
參數描述
PIC16F871T-I/L 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 33 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC16F871T-I/PT 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 33 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC16F872-E/SO 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 22 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC16F872-E/SOVAO 制造商:Microchip Technology Inc 功能描述:
PIC16F872-E/SP 功能描述:8位微控制器 -MCU 3.5KB 128 RAM 22 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT