- 您現(xiàn)在的位置：買賣IC網 > PDF目錄3879 > PIC16F639-I/P (Microchip Technology)IC MCU FLASH 2KX14 20DIP PDF資料下載
參數資料
| 型號： | PIC16F639-I/P |
| 廠商： | Microchip Technology |
| 文件頁數： | 14/74頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU FLASH 2KX14 20DIP |
| 標準包裝： | 22 |
| 系列： | PIC® 16F |
| 核心處理器： | PIC |
| 芯體尺寸： | 8-位 |
| 速度： | 20MHz |
| 外圍設備： | 欠壓檢測/復位，LVD，POR，WDT |
| 輸入/輸出數： | 11 |
| 程序存儲器容量： | 3.5KB（2K x 14） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 128 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2 V ~ 3.6 V |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 20-DIP（0.300"，7.62mm） |
| 包裝： | 管件 |
| 配用： | AC162066-ND - HEADER INTRFC MPLAB ICD2 20PIN AC164039-ND - MODULE SKT PROMATE II 20DIP/SOIC DM163029-ND - BOARD PICDEM FOR MECHATRONICS ACICE0203-ND - MPLABICE 20P 300 MIL ADAPTER |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
Micrel, Inc.
KSZ8841-PMQL
October 2007
21
M9999-100407-1.5
On the transmit side, the KSZ8841-PMQL has intelligent and efficient ways to determine when to invoke flow control.
The flow control is based on availability of the system resources.
The KSZ8841-PMQL issues a flow control frame (XON), containing the maximum pause time defined in IEEE standard
802.3x. Once the resource is freed up, the KSZ8841-PMQL sends out another flow control frame (XOFF) with zero
pause time to turn off the flow control (turn on transmission to the port). A hysteresis feature is provided to prevent the
flow control mechanism from being constantly activated and deactivated.
Half-Duplex Backpressure
A half-duplex backpressure option (non-IEEE 802.3 standards) is also provided. The activation and deactivation
conditions are the same as above in full-duplex mode. If backpressure is required, the KSZ8841-PMQL sends
preambles to defer the other stations' transmission (carrier sense deference).
To avoid jabber and excessive deference (as defined in the 802.3 standard), after a certain time, the KSZ8841-PMQL
discontinues the carrier sense and then raises it again quickly. This short silent time (no carrier sense) prevents other
stations from sending out packets thus keeping other stations in a carrier sense deferred state. If the port has packets
to send during a backpressure situation, the carrier sense type backpressure is interrupted and those packets are
transmitted instead. If there are no additional packets to send, carrier sense type backpressure is reactivated again until
chip resources free up. If a collision occurs, the binary exponential back-off algorithm is skipped and carrier sense is
generated immediately, thus reducing the chance of further colliding and maintaining carrier sense to prevent packet
reception.
The backpressure will take effect automatically in Auto-negotiation enable and half-duplex mode.
Clock Generator
The X1 and X2 pins are connected to a 25MHz crystal. X1 can also serve as the connector to the 3.3V 25MHz oscillator
(as described in the pin description).
EEPROM Interface
An external serial EEPROM with a standard microwire bus interface is used for non-volatile storage of information such
as the node address and subsystem ID.
As part of the initialization after system reset, the KSZ8841-PMQL reads the external EEPROM and places the data
into certain host-accessible registers if the EEEN pin is pulled-up, the KSZ8841-PMQL performs an automatic read of
the EEPROM word from 0x0 to 0x6 after the de-assertion of Reset. An EEPROM of 1KB(93C46) or 4KB(93C66) can be
used based on application.
The EEPROM read/write function can also be performed by software reading and writing to the EEPCR register.
The KSZ8841-PMQL EEPROM format is given in Table 2.
WORD
15
8
7
0
0x0
Reserved
0x1
MAC Address Byte 2
MAC Address Byte 1
0x2
MAC Address Byte 4
MAC Address Byte 3
0x3
MAC Address Byte 6
MAC Address Byte 5
0x4
0x5
0x6
0x7-0x3F
Subsystem ID
Subsystem Vendor ID
ConfigParam
Not used by KSZ8841-PMQL (available for user to use)
Table 2. KSZ8841-PMQL EEPROM Format
相關PDF資料 |
PDF描述 |
|---|---|
| PIC18F25K20-I/SS | IC PIC MCU FLASH 16KX16 28SSOP |
| PIC16C58B-04/P | IC MCU OTP 2KX12 18DIP |
| DSPIC30F2010-30I/SO | IC DSPIC MCU/DSP 12K 28SOIC |
| PIC18F4539-E/ML | IC PIC MCU FLASH 12KX16 44QFN |
| PIC18F2539-E/SP | IC PIC MCU FLASH 12KX16 28DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIC16F639T-I/SO | 功能描述:8位微控制器 -MCU 4kb 128 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16F639T-I/SS | 功能描述:8位微控制器 -MCU 4kb 128 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16F648A-E/ML | 功能描述:8位微控制器 -MCU 7KB 256 RAM 16 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16F648A-E/P | 功能描述:8位微控制器 -MCU 7KB 256 RAM 16 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| PIC16F648A-E/SO | 功能描述:8位微控制器 -MCU 7KB 256 RAM 16 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發(fā)布緊急采購，3分鐘左右您將得到回復。