• <dfn id="vbskw"></dfn>
    • <code id="vbskw"></code>
        • 參數資料
          型號: PIC16C58B-04/P
          廠商: Microchip Technology
          文件頁數: 126/194頁
          文件大?。?/td> 0K
          描述: IC MCU OTP 2KX12 18DIP
          產品培訓模塊: Asynchronous Stimulus
          8-bit PIC® Microcontroller Portfolio
          標準包裝: 25
          系列: PIC® 16C
          核心處理器: PIC
          芯體尺寸: 8-位
          速度: 4MHz
          外圍設備: POR,WDT
          輸入/輸出數: 12
          程序存儲器容量: 3KB(2K x 12)
          程序存儲器類型: OTP
          RAM 容量: 73 x 8
          電壓 - 電源 (Vcc/Vdd): 3 V ~ 5.5 V
          振蕩器型: 外部
          工作溫度: 0°C ~ 70°C
          封裝/外殼: 18-DIP(0.300",7.62mm)
          包裝: 管件
          配用: 309-1059-ND - ADAPTER 18 ZIF BD W/18SO PLUGS
          DVA16XP180-ND - ADAPTER DEVICE FOR MPLAB-ICE
          AC164001-ND - MODULE SKT PROMATEII 18/28DIP
          第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁當前第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁
          2002 Microchip Technology Inc.
          Preliminary
          DS30453D-page 35
          PIC16C5X
          7.0
          I/O PORTS
          As with any other register, the I/O Registers can be
          written and read under program control. However, read
          instructions (e.g., MOVF PORTB,W) always read the I/O
          pins independent of the pin’s input/output modes. On
          RESET, all I/O ports are defined as input (inputs are at
          hi-impedance) since the I/O control registers (TRISA,
          TRISB, TRISC) are all set.
          7.1
          PORTA
          PORTA is a 4-bit I/O Register. Only the low order 4 bits
          are used (RA<3:0>). Bits 7-4 are unimplemented and
          read as '0's.
          7.2
          PORTB
          PORTB is an 8-bit I/O Register (PORTB<7:0>).
          7.3
          PORTC
          PORTC is an 8-bit I/O Register for PIC16C55,
          PIC16C57 and PIC16CR57.
          PORTC is a General Purpose Register for PIC16C54,
          PIC16CR54, PIC16C56, PIC16CR56, PIC16C58 and
          PIC16CR58.
          7.4
          TRIS Registers
          The Output Driver Control Registers are loaded with
          the contents of the W Register by executing the
          TRIS f
          instruction. A '1' from a TRIS Register bit puts
          the corresponding output driver in a hi-impedance
          (input) mode. A '0' puts the contents of the output data
          latch on the selected pins, enabling the output buffer.
          The TRIS Registers are “write-only” and are set (output
          drivers disabled) upon RESET.
          7.5
          I/O Interfacing
          The equivalent circuit for an I/O port pin is shown in
          Figure 7-1. All ports may be used for both input and
          output operation. For input operations these ports are
          non-latching. Any input must be present until read by
          an input instruction (e.g., MOVF PORTB, W). The out-
          puts are latched and remain unchanged until the output
          latch is rewritten. To use a port pin as output, the corre-
          sponding direction control bit (in TRISA, TRISB,
          TRISC) must be cleared (= 0). For use as an input, the
          corresponding TRIS bit must be set. Any I/O pin can be
          programmed individually as input or output.
          FIGURE 7-1:
          EQUIVALENT CIRCUIT
          FOR A SINGLE I/O PIN
          TABLE 7-1:
          SUMMARY OF PORT REGISTERS
          Note:
          A read of the ports reads the pins, not the
          output data latches. That is, if an output
          driver on a pin is enabled and driven high,
          but the external system is holding it low, a
          read of the port will indicate that the pin is
          low.
          Note 1: I/O pins have protection diodes to VDD and VSS.
          Data
          Bus
          Q
          D
          Q
          CK
          Q
          D
          Q
          CK
          P
          N
          WR
          Port
          TRIS ‘f’
          Data
          TRIS
          RD Port
          VSS
          VDD
          I/O
          pin(1)
          W
          Reg
          Latch
          RESET
          Address
          Name
          Bit 7
          Bit 6
          Bit 5
          Bit 4
          Bit 3
          Bit 2
          Bit 1
          Bit 0
          Value on
          Power-On
          Reset
          Value on
          MCLR and
          WDT Reset
          N/A
          TRIS
          I/O Control Registers (TRISA, TRISB, TRISC)
          1111 1111
          05h
          PORTA
          RA3
          RA2
          RA1
          RA0
          ---- xxxx
          ---- uuuu
          06h
          PORTB
          RB7
          RB6
          RB5
          RB4
          RB3
          RB2
          RB1
          RB0
          xxxx xxxx
          uuuu uuuu
          07h
          PORTC
          RC7
          RC6
          RC5
          RC4
          RC3
          RC2
          RC1
          RC0
          xxxx xxxx
          uuuu uuuu
          Legend: x = unknown, u = unchanged, — = unimplemented, read as '0', Shaded cells = unimplemented, read as ‘0’
          相關PDF資料
          PDF描述
          DSPIC30F2010-30I/SO IC DSPIC MCU/DSP 12K 28SOIC
          PIC18F4539-E/ML IC PIC MCU FLASH 12KX16 44QFN
          PIC18F2539-E/SP IC PIC MCU FLASH 12KX16 28DIP
          PIC18F2539-E/SO IC PIC MCU FLASH 12KX16 28SOIC
          PIC18F4439-E/PT IC PIC MCU FLASH 6KX16 44TQFP
          相關代理商/技術參數
          參數描述
          PIC16C58B-20/P 功能描述:8位微控制器 -MCU 3KB 73 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
          PIC16C58B-20/SO 功能描述:8位微控制器 -MCU 3KB 73 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
          PIC16C58B-20/SS 功能描述:8位微控制器 -MCU 3KB 73 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
          PIC16C58B-20E/P 功能描述:8位微控制器 -MCU 3KB 73 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
          PIC16C58B-20E/SO 功能描述:8位微控制器 -MCU 3KB 73 RAM 12 I/O RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT