
2
PS8786C
0505/07
PI2DBS412
1.8V, 1.8GHz, Differential Broadband Signal Switch,
4-Differential Channel, 2:1 Mux/DeMux Switch
Storage Temperature....................................–65°C to +150°C
Supply Voltage to Ground Potential...............–0.5V to +2.5V
DC Input Voltage ............................................–0.5V to VCC
DC Output Current......................................................120mA
Power Dissipation...........................................................0.5W
Note:
Stresses greater than those listed under MAXIMUM RATINGS may cause
permanent damage to the device. This is a stress rating only and func-
tional operation of the device at these or any other conditions above those
indicated in the operational sections of this specication is not implied.
Exposure to absolute maximum rating conditions for extended periods
may affect reliability.
Maximum Ratings
(Above which useful life may be impaired. For user guidelines, not tested.)
DC Electrical Characteristics for Switching over Operating Range (TA = –40°C to +85°C, VCC = 1.5V to 2.0V)
Paramenter
Description
Test Conditions(1)
Min.
Typ.(2)
Max.
Units
VIH
Input HIGH Voltage
Guaranteed HIGH level
0.65 x VCC
V
VIL
Input LOW Voltage
Guaranteed LOW level
–0.5
0.35 x VCC
VIK
Clamp Diode Voltage
VCC = Max., IIN = –18mA
–0.7
–1.2
IIH
Input HIGH Current
VCC = Max., VIN = VCC
±5
μA
IIL
Input LOW Current
VCC = Max., VIN = GND
±5
Dynamic Electrical Characteristics Over the Operating Range (TA= –40 to +85C, VCC = 1.8V±10%, GND=0V)
Parameter
Description
Test Conditions(1)
Min.
Typ.(2)
Max.
Units
XTALK(3)
Crosstalk
See Fig. 1 for Measurement Setup, f = 10 MHz
–68
dB
OIRR(3)
OFF Isolation
See Fig. 2 for Measurement Setup, f = 10 MHz
–77
BW(3)
Bandwidth
1.8
GHz
Notes:
1.
For Max. or Min. conditions, use appropriate value specied under Electrical Characteristics for the applicable device type.
2.
Typical values are at VCC = 1.8V, TA = 25°C ambient and maximum loading.
3.
Guaranteed by design.
Power Supply Characteristics
Parameters
Description
Test Conditions(1)
Min.
Typ.(2)
Max.
Units
ICC
Quiescent Power Supply Current
VCC = Max., VIN = GND or VCC
200
μA
Notes:
1.
For Max. or Min. conditions, use appropriate value specied under Electrical Characteristics for the applicable device type.
2.
Typical values are at VCC = 1.8V, TA = 25°C ambient and maximum loading.
Notes:
1.
For Max. or Min. conditions, use appropriate value specied under Electrical Characteristics for the applicable device type.
2.
Typical values are at VCC = 1.8V, TA = 25°C ambient and maximum loading.
07-0123