- 您現在的位置：買賣IC網 > PDF目錄367901 > PEB80900F ?Network Termination Controller? PDF資料下載
參數資料
| 型號： | PEB80900F |
| 英文描述： | ?Network Termination Controller? |
| 中文描述： | ？網絡終端控制器？ |
| 文件頁數： | 121/181頁 |
| 文件大?。?/td> | 3288K |
| 代理商： | PEB80900F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁當前第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁
PEB 80900
Part II
’
IEC-T
’
: Functional Description
Data Sheet
109
2001-04-02
6.7.3
A 1 kHz transparent channel is provided via the T bit on the IOM
-1 interface in both
directions. Every 8th T bit is transmitted via the Uk0 M channel. A low in the T bit causes
the M symbol to be set to minus polarity, overwriting any loop 4, loop 2 requests or RDS
errors that might be transmitted via Uk0. A high in the T bit causes the M symbol to be
set to zero or plus polarity depending on any loop 4, loop 2 requests or RDS errors. So
it is obvious, that during activation it is essential to keep the T bit high to enable the NT
(NT-RP) to recognize the loop status.
Each received M symbol with zero or plus polarity causes 8 consecutive T bits set to
high. Each received M symbol with minus polarity causes 8 consecutive T bits set to low.
Transparent Maintenance Channel
6.7.4
Interfaces to the Power Supply Circuit
The two-wire interface Uk0 provides power for the equipment repeater, network
termination (NT) and possibly one telephone terminal in emergency conditions, when
they must be fed by the exchange in the ISDN basic access. The NTC-T AM with IEC-T
functionality selected has an interface to the power supply/feeding circuit of the
exchange.
6.7.4.1
Scanning of Measured Values (MPF)
Using the common clocks 8 kHz and 512 or 4096 kHz, the feeding circuit transmits
serially an octet via the MPF pin into the NTC-T AM with IEC-T functionality selected at
the beginning of each IOM
-frame, which represents the measured loop feeding current.
As shown in fig. 5.4, fig. 5.5 and fig. 5.7 , the data at pin MPF are defined with equivalent
timing and therefore are clocked in at the same instants as the data an DIN pin. The octet
passed by the feeding circuit is identically placed as octet B1, the first of each frame both
in 256 kHz and 2048 kHz modes.
If not used, the MPF pin may be clamped either to VDD or GND.
6.7.4.2
Supervision of Power Feed (LT Mode)
For supervision of power feed control, lines DISS, APF, CLS are used in static, level
sensed operation mode.
In the C/I channel, a command LTD (LT disable, see
Chapter 7.3.3
) is defined to disable
the power feed, setting the pin DISS on high. If the power feed unit is disabled either by
the DISS pin or by an overload condition (short circuit), it indicates this to the NTC-T AM
with IEC-T functionality selected, setting the CLS pin to high. The NTC-T AM with IEC-
T functionality selected hands this information over to layer 2 units putting HI (high
impedance, see
Chapter 7.3.4
) into the C/I channel (see
Figure 79
).
An overload condition is indicated by the power feed unit with a short response time, by
means of a high on the APF pin (alarm power feed). In this condition, further adaption
相關PDF資料 |
PDF描述 |
|---|---|
| PEB80900H | ?Network Termination Controller? |
| PEB8091(64MQFP) | ISDN Line Interface |
| PEB8091(64TQFP) | ISDN Line Interface |
| PEF8091(64MQFP) | 1MHz Off-Line Current Mode PWM and DC/DC Converter; Package: SO; No of Pins: 8; Temperature Range: 0°C to +70°C |
| PEF8091(64TQFP) | ISDN Line Interface |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PEB8090FV1.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Infineon Technologies AG 功能描述: |
| PEB8091FDV1.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| PEB8091FGDV1.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Infineon Technologies AG 功能描述: |
| PEB8091HDV1.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Infineon Technologies AG 功能描述: |
| PEB8191FGDV1.1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。