- 您現在的位置：買賣IC網 > PDF目錄367828 > PCM3793RHBT 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier PDF資料下載
參數資料
| 型號： | PCM3793RHBT |
| 元件分類： | Codec |
| 英文描述： | 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier |
| 中文描述： | 16位，低功耗立體聲音頻編解碼器麥克風偏置，耳機，揚聲器放大器和數字 |
| 文件頁數： | 16/63頁 |
| 文件大小： | 915K |
| 代理商： | PCM3793RHBT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁
www.ti.com
PCM3793/94 DESCRIPTION
Analog Input
Gain Settings for Analog Input
A/D Converter
D/A Converter
Common Voltage
Line Output
Headphone Output
Headphone Plug Insertion Detection
PCM3793
PCM3794
SLES193A–AUGUST 2006–REVISED SEPTEMBER 2006
The AIN1L, AIN1R, AIN2L, AIN2R, AIN3L, and AIN3R pins can be used as microphone or line inputs with
selectable 0- or 20-dB boost and 1-Vrms input. All analog inputs have high input impedance (20 k
), which is
not changed by gain settings. One pair of inputs is selected by register 87 (AIL[1:0], AIR[1:0]). AIN1L and AIN1R
can be used as monaural differential inputs.
Analog signals can be adjusted from 30 dB to –12 dB in 1-dB steps following the 0- or 20-dB boost amplifier.
The gain level can be set for each channel by registers 79 and 80 (ALV[5:0], ARV[5:0]).
The ADC includes a multilevel delta-sigma modulator, aliasing filter, decimation filter, high-pass filter, and notch
filter and can accept a 1-Vrms full-scale voltage input. The decimation filter has a digital soft mute controlled by
register 81 (RMUL, RMUR). The high-pass filter can be disabled by register 81 (HPF[1:0]) and the notch filter
can be disabled by registers 96 to 104 if it is not necessary to cancel a dc offset or compensate for wind noise.
The DAC includes a multilevel delta-sigma modulator and interpolation filter. These can be used to obtain high
PSRR, low jitter sensitivity, and low out-of-band noise quickly and easily. The interpolation filter includes digital
attenuator, digital soft mute, three-band tone control (bass, midrange and treble), and 3-D sound controlled by
registers 92 to 95. The de-emphasis filter (32, 44.1 and 48 kHz) is controlled by registers 68 to 70 (ATL[5:0],
ATR[5:0], PMUL, PMUR, DEM[1:0]). Oversampling rate control can reduce out-of-band noise when operating at
low sampling rate by using register 70 (OVER).
The V
COM
pin is normally biased to 0.5 V
CC
, and it provides the common voltage to internal circuitry. It is
recommended that a 10-
μ
F capacitor be connected between this pin and ground to provide clean voltage and
avoid pop noise. The PCM3793/94 may have a little pop noise on each analog output if a capacitor smaller than
10
μ
F is used.
The HPOL/LOL and HPOR/LOR and HPCOM/MONO pins can be used as a monaural single-ended, monaural
differential, or stereo single-line output with 1-V
output by register 74 (HPS[1:0]). The line outputs can drive a
10-k
load. These outputs include an analog volume amplifier, except for the HPCOM/MONO pin that can be
set from 6 dB to –70 dB and mute with 0.5-, 1-, 2- or 4-dB steps for each output, as controlled by registers 64
and 65 (HLV[5:0], HRV[5:0], HMUL, HMUR). A dc blocking capacitor is not required when connecting to an
external speaker amplifier with monaural differential input. The center voltage is 0.5 V
CC
with zero data input.
The HPOL/LOL, HPOR/LOR, and HPCOM/MONO pins are stereo, monaural, or monaural differential
headphone outputs with more than 30 or 40 mWrms output power into a 32- or 16-
load, either through a dc
blocking capacitor or without a capacitor, as selected by register 74 (HPS[2:0]). These outputs include analog
volume amplifiers, except for the HPCOM/MONO pin, which can be set from 6 dB to –70 dB with 0.5-, 1-, 2- or
4-dB steps for each output using registers 64 and 65 (HLV[5:0], HRV[5:0], HMUL, HMUR). The center voltage is
0.5 V
CC
with zero data input.
The HDTI pin detects the insertion status of headphone plug and writes the status to register 77 (HPDS), which
can be read by the I
2
C interface. The polarity of the status indication can be inverted by register 75 (HPDP). The
headphone
and
speaker
amplifiers
are
disabled
insertion/extractrion if register 75, HPDE = 1. They are controlled by register settings if register 75, HPDE = 0.
HPCOM/MONO is not affected by the status when register 74, CMS[0] = 1.
or
enabled
automatically
by
headphone
plug
16
Submit Documentation Feedback
相關PDF資料 |
PDF描述 |
|---|---|
| PCM3794 | 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier |
| PCM3794RHB | 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier |
| PCM3794RHBR | 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier |
| PCM3794RHBRG4 | 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier |
| PCM3794RHBT | 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCM3793RHBTG4 | 功能描述:接口—CODEC Very Lo-Pwr Stereo CODEC RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| PCM3794 | 制造商:BB 制造商全稱:BB 功能描述:16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier |
| PCM-3794 | 制造商:AAEON 制造商全稱:AAEON 功能描述:PCI-104 2-slot PCMCIA Module /Three IEEE-1394 Port Daughter Board |
| PCM3794A | 制造商:BB 制造商全稱:BB 功能描述:16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier |
| PCM-3794-A10 | 制造商:AAEON Technology Inc 功能描述:PCI-104 2-SLOT PCMCIA (HOT SWAP) - Bulk |
發布緊急采購，3分鐘左右您將得到回復。