參數資料
型號： PCF8558
廠商： NXP Semiconductors N.V.
英文描述： Universal LCD driver for small graphic panels(應用于小型圖形面板的通用LCD驅動器)
中文描述： 通用LCD驅動器小圖板（應用于小型圖形面板的通用液晶驅動器）
文件頁數： 5/24頁
文件大?。?/td> 157K
代理商： PCF8558
1998 Apr 07
5
Philips Semiconductors
Objective specification
Universal LCD driver for small graphic
panels
PCF8558
FUNCTIONAL DESCRIPTION
LCD bias voltage generator
The intermediate bias voltages for the LCD display are
generated and buffered on-chip. This removes the need
for an external resistor bias chain and significantly reduces
the system power consumption.
Oscillator
The on-chip oscillator provides the clock signal for the
display system. No external components are required and
the OSC pin must be connected to V
DD
.
External clock
If an external clock is to be used it is input at the OSC pin.
The resulting display frame frequency is given by
f
3072
.
Only in the power-down state is the clock allowed to be
stopped (OSC connected to V
SS
), otherwise the LCD will
be frozen in a state where a DC voltage is applied to it.
Power-on reset
The on-chip power-on reset block initializes the chip after
power-on or power failure. This is a synchronous reset and
requires 2 oscillator cycles to execute. These oscillator
cycles must be provided from the external clock source if
the internal oscillator is not used. If this is not done, the
device may not respond to command sequences
transmitted via the I
2
C-bus interface.
Power-down
The chip can be put into power-down mode where all static
currents are switched off (no internal oscillator, no internal
power-on reset, no bias level generation and all LCD
outputs are internally connected to V
DD
) when
PD = logic 1.
During power-down the information in the RAMs and the
internal chip states are preserved. Instruction execution
during power-down is possible if an externally clock signal
is applied to pad OSC.
Registers
The PCF8558 has one 8-bit register, time shared as a
Command Register (CR) and a Data Register (DR).
The command register stores the command code such as
display on or display off and address information for the
f
frame
------------
=
Display Data RAM (DDRAM). Both registers can be written
to but not read from by the system controller.
Address Counter (AC)
The address counter assigns addresses to the DDRAM for
writing and is set by Y2 to Y0 in the command and
X6 to X0 in the address. After a write operation the
address counter is automatically incremented by 1 in
accordance with the V flag.
Display Data RAM (DDRAM)
The PCF8558 contains a 40
×
101-bit static RAM which
stores the display data. The RAM is divided into 5 banks of
101 bytes (5
×
8
×
101 bits). During RAM access, data is
transferred to the RAM via the I
2
C-bus. There is a direct
correspondence between the X address and the column
output number.
Timing generator
The timing generator produces the various signals
required to drive the internal circuitry. Internal chip
operation is not disturbed by operations on the data buses.
Display control
The display is generated by continuously shifting rows of
RAM data to the dot matrix LCD via the column outputs.
The display status (all dots on/off and normal/inverse
video) is set by bits E and D in the command word.
LCD row and column drivers
The PCF8558 contains 40 row and 101 column drivers,
which connect the appropriate LCD bias voltages in
sequence to the display in accordance with the data to be
displayed. Figure 3 illustrates typical waveforms. Unused
outputs should be left unconnected.
The bias voltage levels, V2 to V5, are chosen to give
optimum display contrast for a multiplex rate of 1 : 40.
Table 1
Voltage bias levels
LEVEL
VOLTAGE
V2
V3
V4
V5
0.8635
×
(V
DD
V
LCD
)
0.7270
×
(V
DD
V
LCD
)
0.2730
×
(V
DD
V
LCD
)
0.1365
×
(V
DD
V
LCD
)
相關PDF資料
PDF描述
PCF8558U Universal LCD driver for small graphic panels
PCF8563 Real-time clock/calendar(實時時鐘/日歷)
PCF8566 Universal LCD driver for low multiplex rates
PCF8573 Clock/calendar with Power Fail Detector
PCF8573P Clock/calendar with Power Fail Detector
相關代理商/技術參數
參數描述
PCF8558U 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal LCD driver for small graphic panels
PCF8558U/10 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal LCD driver for small graphic panels
PCF8558U/12 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal LCD driver for small graphic panels
PCF8562 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal LCD driver for low multiplex rates
PCF8562_09 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal LCD driver for low multiplex rates
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*