- 您現在的位置：買賣IC網 > PDF目錄382379 > PCA9552 (NXP Semiconductors N.V.) GT 10C 10#16 SKT RECP BOX RM PDF資料下載
參數資料
| 型號： | PCA9552 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | GT 10C 10#16 SKT RECP BOX RM |
| 中文描述： | 16位I2C LED與可編程閃爍率司機 |
| 文件頁數： | 2/21頁 |
| 文件大?。?/td> | 166K |
| 代理商： | PCA9552 |
Philips Semiconductors
Product data sheet
PCA9552
16-bit I
2
C LED driver with
programmable blink rates
2
2004 Oct 01
FEATURES
16 LED drivers (on, off, flashing at a programmable rate)
2 selectable, fully programmable blink rates (frequency and duty
cycle) between 0.172 Hz and 44 Hz (5.82 and 0.023 seconds)
Input/outputs not used as LED drivers can be used as regular
GPIOs
Internal oscillator requires no external components
I
2
C-bus interface logic compatible with SMBus
Internal power-on reset
Noise filter on SCL/SDA inputs
Active-LOW reset input
16 open drain outputs directly drive LEDs to 25 mA
Edge rate control on outputs
No glitch on power-up
Supports hot insertion
Low stand-by current
Operating power supply voltage range of 2.3 V to 5.5 V
0 to 400 kHz clock frequency
ESD protection exceeds 2000 V HBM per JESD22-A114,
150 V MM per JESD22-A115 and 1000 V CDM per JESD22-C101
Latch-up testing is done to JESDEC Standard JESD78 which
exceeds 100 mA
Packages offered: SO24, TSSOP24, HVQFN24
DESCRIPTION
The PCA9552 LED Blinker blinks LEDs in I
2
C-bus and SMBus
applications where it is necessary to limit bus traffic or free up the
I
2
C Master’s (MCU, MPU, DSP, chipset, etc.) timer. The uniqueness
of this device is the internal oscillator with two programmable blink
rates. To blink LEDs using normal I/O Expanders like the PCF8574
or PCA9554, the bus master must send repeated commands to turn
the LED on and off. This greatly increases the amount of traffic on
the I
2
C-bus and uses up one of the master’s timers. The PCA9552
LED Blinker instead requires only the initial set up command to
program BLINK RATE 1 and BLINK RATE 2 (i.e., the frequency and
duty cycle) for each individual output. From then on, only one
command from the bus master is required to turn each individual
open drain output ON, OFF, or to cycle at BLINK RATE 1 or BLINK
RATE 2. Maximum output sink current is 25 mA per bit and 200 mA
per package.
Any bits not used for controlling the LEDs can be used for General
Purpose Parallel Input/Output (GPIO) expansion.
The active-LOW hardware reset pin (RESET) and Power-On Reset
(POR) initializes the registers to their default state, all zeroes,
causing the bits to be set HIGH (LED off).
Three hardware address pins on the PCA9552 allow eight devices
to operate on the same bus.
ORDERING INFORMATION
PACKAGES
TEMPERATURE RANGE
ORDER CODE
TOPSIDE MARK
DRAWING NUMBER
24-pin plastic SO
–40
°
C to +85
°
C
–40
°
C to +85
°
C
–40
°
C to +85
°
C
PCA9552D
PCA9552D
SOT137-1
24-pin plastic TSSOP
PCA9552PW
PCA9552PW
SOT355-1
24-pin plastic HVQFN
Standard packing quantities and other packaging data are available at www.standardproducts.philips.com/packaging.
I
2
C is a trademark of Philips Semiconductors Corporation.
PCA9552BS
9552
SOT616-1
相關PDF資料 |
PDF描述 |
|---|---|
| PCA9554 | 8-bit I2C and SMBus I/O port with interrupt |
| PCA9554A | 8-bit I2C and SMBus I/O port with interrupt |
| PCA9554AN | 8-bit I2C and SMBus I/O port with interrupt |
| PCA9554N | 8-bit I2C and SMBus I/O port with interrupt |
| PCA9559PWDH | 5-bit multiplexed/1-bit latched 6-bit I2C EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCA9552_06 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16-bit I2C-bus LED driver with programmable blink rates |
| PCA9552BS | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16-bit I2C-bus LED driver with programmable blink rates |
| PCA9552BS,118 | 功能描述:LED照明驅動器 16-BIT I2C FM OD LED BLK RST RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| PCA9552D | 功能描述:LED照明驅動器 I2C LED BLINKR 16BIT RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| PCA9552D,112 | 功能描述:LED照明驅動器 I2C LED BLINKR 16BIT RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
發布緊急采購，3分鐘左右您將得到回復。