Philips Semiconductors
Product data
PCA9535
16-bit I
2
C and SMBus, low power I/O port with interrupt
2
2003 Jun 27
FEATURES
Operating power supply voltage range of 2.3 V-5.5 V
5 V tolerant I/Os
Polarity inversion register
Active LOW interrupt output
Low stand-by current
Noise filter on SCL/SDA inputs
No glitch on power-up
Internal power-on reset
16 I/O pins which default to 16 inputs
0 to 400 kHz clock frequency
ESD protection exceeds 2000 V HBM per JESD22-A114, 200 V
MM per JESD22-A115, and 1000 V CDM per JESD22-C101
Latch-up testing is done to JESDEC Standard JESD78 which
exceeds 100 mA
Offered in three different packages: SO24, TSSOP24, and
HVQFN24
DESCRIPTION
The PCA9535 is a 24-pin CMOS device that provide 16 bits of
General Purpose parallel Input/Output (GPIO) expansion for
I
2
C/SMBus applications and was developed to enhance the Philips
family of I
2
C I/O expanders. The improvements include higher drive
capability, 5 V I/O tolerance, lower supply current, individual I/O
configuration, and smaller packaging. I/O expanders provide a
simple solution when additional I/O is needed for ACPI power
switches, sensors, pushbuttons, LEDs, fans, etc.
The PCA9535 consist of two 8-bit Configuration (Input or Output
selection); Input, Output and Polarity inversion (Active HIGH or
Active LOW operation) registers. The system master can enable the
I/Os as either inputs or outputs by writing to the I/O configuration
bits. The data for each Input or Output is kept in the corresponding
Input or Output register. The polarity of the read register can be
inverted with the Polarity Inversion Register. All registers can be
read by the system master. Although pin-to-pin and I
2
C address
compatible with the PCF8575, software changes are required due to
the enhancements and are discussed in Application Note AN469.
The PCA9535 is identical to the PCA9555 except for the removal of
the internal I/O pull-up resistor which greatly reduces power
consumption when the I/Os are held LOW.
The PCA9535 open-drain interrupt output is activated when any
input state differs from its corresponding input port register state and
is used to indicate to the system master that an input state has
changed. The power-on reset sets the registers to their default
values and initializes the device state machine.
Three hardware pins (A0, A1, A2) vary the fixed I
2
C address and
allow up to eight devices to share the same I
2
C/SMBus. The fixed
I
2
C address of the PCA9535 is the same as the PCA9554 allowing
up to eight of these devices in any combination to share the same
I
2
C/SMBus.
ORDERING INFORMATION
PACKAGES
TEMPERATURE RANGE
ORDER CODE
TOPSIDE MARK
DRAWING NUMBER
24-Pin Plastic SO
-40 to +85
°
C
-40 to +85
°
C
-40 to +85
°
C
PCA9535D
PCA9535D
SOT137-1
24-Pin Plastic TSSOP
PCA9535PW
PCA9535PW
SOT355-1
24-Pin Plastic HVQFN
Standard packing quantities and other packing data are available at
www.philipslogic.com/packaging
.
I
2
C is a trademark of Philips Semiconductors Corporation.
SMBus as specified by the Smart Battery System Implementers Forum is a derivative of the Philips I
2
C patent.
PCA9535BS
9535
SOT616-1