
Datasheet Information
5-12
Revision 4
Advance v0.8
(continued)
This sentence was updated in the "No-Glitch MUX (NGMUX)" section to delete GLA:
The GLMUXCFG[1:0] configuration bits determine the source of the CLK inputs (i.e.,
internal signal or GLC).
2-32
In Table 2-13 NGMUX Configuration and Selection Table, 10 and 11 were deleted.
2-32
The method to enable sleep mode was updated for bit 0 in Table 2-16 RTC
Control/Status Register.
2-38
S2 was changed to D2 in Figure 2-39 Read Waveform (Pipe Mode, 32-bit access)
for RD[31:0] was updated.
2-51
The definitions for bits 2 and 3 were updated in Table 2-24 Page Status Bit
Definition.
2-52
Figure 2-46 FlashROM Timing Diagram was updated.
2-58
Table 2-26 FlashROM Access Time is new.
2-58
Figure 2-55 Write Access After Write onto Same Address, Figure 2-56 Read
Access After Write onto Same Address, and Figure 2-57 Write Access After Read
onto Same Address are new.
2-68–
2-70
Table 2-31 RAM4K9 and Table 2-32 RAM512X18 were updated.
2-71, 2-72
The VAREF and SAMPLE functions were updated in Table 2-36 Analog Block Pin
Description.
2-82
The title of Figure 2-72 Timing Diagram for Current Monitor Strobe was updated to
add the word "positive."
2-91
The "Gate Driver" section was updated to give information about the switching rate
in High Current Drive mode.
2-94
The "ADC Description" section was updated to include information about the
SAMPLE and BUSY signals and the maximum frequencies for SYSCLK and
ADCCLK. EQ 2 was updated to add parentheses around the entire expression in the
denominator.
2-102
Table 2-46 Analog Channel Specifications and Table 2-47 ADC Characteristics in
Direct Input Mode were updated.
2-118,
2-121
The note was removed from Table 2-55 Analog Multiplexer Truth Table—AV (x = 0),
AC (x = 1), and AT (x = 3).
2-131
Table 2-63 Internal Temperature Monitor Control Truth Table is new.
2-132
The "Cold-Sparing Support" section was updated to add information about cases
where current draw can occur.
2-143
Figure 2-104 Solution 4 was updated.
2-147
Table 2-75 Fusion Standard I/O Standards—OUT_DRIVE Settings was updated.
2-153
The "GNDA Ground (analog)" section and "GNDAQ Ground (analog quiet)" section
were updated to add information about maximum differential voltage.
The AREF Analog Reference Voltage" section and "VPUMP Programming Supply
Voltage" section were updated.
2-226
The "VCCPLA/B PLL Supply Voltage" section was updated to include information
about the east and west PLLs.
2-225
The VCOMPLF pin description was deleted.
N/A
The "Axy Analog Input/Output" section was updated with information about
grounding and floating the pin.
2-226
Revision
Changes
Page