參數資料
    型號: OR2C06A-3S160I
    廠商: Electronic Theatre Controls, Inc.
    元件分類: FPGA
    英文描述: Field-Programmable Gate Arrays
    中文描述: 現場可編程門陣列
    文件頁數: 141/192頁
    文件大?。?/td> 3148K
    代理商: OR2C06A-3S160I
    第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁當前第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁
    52
    Lucent Technologies Inc.
    Data Sheet
    ORCA Series 2 FPGAs
    June 1999
    Special Function Blocks
    Special function blocks in the Series 2 provide extra
    capabilities beyond general FPGA operation. These
    blocks reside in the corners of the FPGA array.
    Single Function Blocks
    Most of the special function blocks perform a specific
    dedicated function. These functions are data/configura-
    tion readback control, global 3-state control (TS_ALL),
    internal oscillator generation, global set/reset (GSRN),
    and start-up logic.
    Readback Logic
    The readback logic is located in the upper right corner
    of the FPGA.
    Readback is used to read back the configuration data
    and, optionally, the state of the PFU outputs. A read-
    back operation can be done while the FPGA is in nor-
    mal system operation. The readback operation cannot
    be daisy-chained. To use readback, the user selects
    options in the bit stream generator in the
    ORCA
    Foundry Development System.
    Table 11 provides readback options selected in the bit
    stream generator tool. The table provides the number
    of times that the configuration data can be read back.
    This is intended primarily to give the user control over
    the security of the FPGA’s configuration program. The
    user can prohibit readback (0), allow a single readback
    (1), or allow unrestricted readback (U).
    Table 11. Readback Options
    The pins used for readback are readback data
    (RD_DATA), read configuration (RD_CFG), and configu-
    ration clock (CCLK). A readback operation is initiated
    by a high-to-low transition on RD_CFG. The RD_CFG
    input must remain low during the readback operation.
    The readback operation can be restarted at frame 0 by
    driving the RD_CFG pin high, applying at least two ris-
    ing edges of CCLK, and then driving RD_CFG low
    again. One bit of data is shifted out on RD_DATA at the
    rising edge of CCLK. The first start bit of the readback
    frame is transmitted out several cycles after the first ris-
    ing edge of CCLK after RD_CFG is input low (see Table
    48, Readback Timing Characteristics in the Timing
    Characteristics section).
    It should be noted that the RD_DATA output pin is also
    used as the dedicated boundary-scan output pin, TDO.
    If this pin is being used as TDO, the RD_DATA output
    from readback can be routed internally to any other pin
    desired. The RD_CFG input pin is also used to control
    the global 3-state (TS_ALL) function. Before and during
    configuration, the TS_ALL signal is always driven by
    the RD_CFG input and readback is disabled. After con-
    figuration, the selection as to whether this input drives
    the readback or global 3-state function is determined
    by a set of bit stream options. If used as the RD_CFG
    input for readback, the internal TS_ALL input can be
    routed internally to be driven by any input pin.
    The readback frame contains the configuration data
    and the state of the internal logic. During readback, the
    value of all five PFU outputs can be captured. The fol-
    lowing options are allowed when doing a capture of the
    PFU outputs.
    1. Do not capture data (the data written to the capture
    RAMs, usually 0, will be read back).
    2. Capture data upon entering readback.
    3. Capture data based upon a configurable signal
    internal to the FPGA. If this signal is tied to
    logic 0, capture RAMs are written continuously.
    4. Capture data on either options 2 or 3 above.
    The readback frame has a similar, but not identical, for-
    mat to the configuration frame. This eases a bitwise
    comparison between the configuration and readback
    data. The readback data is not inverted. Every data
    frame has one low start bit and one high stop bit. The
    preamble, including the length count field, is not part of
    the readback frame. The readback frame contains
    states in locations not used in the configuration. These
    locations need to be masked out when comparing the
    configuration and readback frames. The development
    system optionally provides a readback bit stream to
    compare to readback from the FPGA. Also note that if
    any of the LUTs are used as RAM and new data is writ-
    ten to them, these bits will not have the same values as
    the original configuration data frame either.
    Option
    Function
    0
    Prohibit Readback
    1
    Allow One Readback Only
    U
    Allow Unrestricted Number of Readbacks
    相關PDF資料
    PDF描述
    OR2C06A-3S208 Field-Programmable Gate Arrays
    OR2C06A-3S208I Field-Programmable Gate Arrays
    OR2C06A-3S240 Field-Programmable Gate Arrays
    OR2C06A-3S240I Field-Programmable Gate Arrays
    OR2C06A-3S256 Field-Programmable Gate Arrays
    相關代理商/技術參數
    參數描述
    OR2C06A-3S208 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays
    OR2C06A-3S208I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays
    OR2C06A3S208I-DB 功能描述:FPGA - 現場可編程門陣列 Use ECP/EC or XP RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
    OR2C06A-3S240 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays
    OR2C06A-3S240I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays