
4
OPT210
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Burr-Brown
recommends that all integrated circuits be handled with ap-
propriate precautions. Failure to observe proper handling and
installation procedures can cause damage.
ESD damage can range from subtle performance degradation
to complete device failure. Precision integrated circuits may
be more susceptible to damage because very small parametric
changes could cause the device not to meet its published
specifications.
MOISTURE SENSITIVITY
AND SOLDERING
Clear plastic does not contain the structural-enhancing fillers
used in black plastic molding compound. As a result, clear
plastic is more sensitive to environmental stress than black
plastic. This can cause difficulties if devices have been stored
in high humidity prior to soldering. The rapid heating during
soldering can stress wire bonds and cause failures. Prior to
soldering, it is recommended that plastic devices be baked-out
at 85
°
C for 24 hours.
The fire-retardant fillers used in black plastic are not compat-
ible with clear molding compound. The OPT210 plastic
packages cannot meet flammability test, UL-94.
Top View
DIP
Top View
SIP
PIN CONFIGURATIONS
ABSOLUTE MAXIMUM RATINGS
Supply Voltage ...................................................................................
±
18V
Input Voltage Range (Common Pin) ....................................................
±
V
S
Output Short-Circuit (to ground)............................................... Continuous
Operating Temperature: P, W ........................................... –25
°
C to +85
°
C
Storage Temperature: P, W ........................................... –25
°
C to +85
°
C
Junction Temperature: P, W .......................................................... +85
°
C
Lead Temperature (soldering, 10s)................................................ +300
°
C
(Vapor-Phase Soldering Not Recommended on Plastic Packages)
PACKAGE DRAWING
NUMBER
(1)
PRODUCT
PACKAGE
OPT210P
OPT210P-J
OPT210W
8-Pin Plastic DIP
8-Lead Surface Mount
(2)
5-Pin Plastic SIP
006-5
006-6
321-1
NOTE: (1) For detailed drawing and dimension table, please see end of data
sheet, or Appendix C of Burr-Brown IC Data Book. (2) 8-pin DIP with leads
formed for surface mounting.
PACKAGE INFORMATION
V+
–In
V–
NC
Common
NC
NC
Output
1
2
3
4
8
7
6
5
(1)
NOTE: (1) Photodiode location.
Common
V+
–In
V–
Output
1
2
3
4
5
(1)
NOTE: (1) Photodiode location.