- 您現在的位置：買賣IC網 > PDF目錄224619 > OKX2-T/10-W5P-C (MURATA POWER SOLUTIONS INC) 1-OUTPUT 33 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | OKX2-T/10-W5P-C |
| 廠商： | MURATA POWER SOLUTIONS INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 33 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT, SIP-11 |
| 文件頁數： | 10/13頁 |
| 文件大?。?/td> | 314K |
| 代理商： | OKX2-T/10-W5P-C |
Soldering Guidelines
Murata Power Solutions recommends the specications below when installing these
converters. These specications vary depending on the solder type. Exceeding these
specications may cause damage to the product. Your production environment may dif-
fer; therefore please thoroughly review these guidelines with your process engineers.
Wave Solder Operations for through-hole mounted products (THMT)
For Sn/Ag/Cu based solders:
Maximum Preheat Temperature
115° C.
Maximum Pot Temperature
270° C.
Maximum Solder Dwell Time
7 seconds
For Sn/Pb based solders:
Maximum Preheat Temperature
105° C.
Maximum Pot Temperature
250° C.
Maximum Solder Dwell Time
6 seconds
Model Number
Product Code
OKX-T/16-W5N-C
X00016
OKX-T/16-W5P-C
X01016
OKX2-T/16-W5N-C
X20016
OKX2-T/16-W5P-C
X21016
OKX-T/10-W5N-C
X00010
OKX-T/10-W5P-C
X01010
OKX2-T/10-W5N-C
X20010
OKX2-T/10-W5P-C
X21010
(9)
All models are fully operational and meet published specifications, including “cold start” at –40°C.
(10) Regulation specifications describe the deviation as the line input voltage or output load current is varied
from a nominal midpoint value to either extreme.
(11) Other input or output voltage ranges will be reviewed under scheduled quantity special order.
(12) Maximum PC board temperature is measured with the sensor in the center of the converter.
(13) Do not exceed maximum power specifications when adjusting the output trim.
(14) The maximum output capacitive loads depend on the the Equivalent Series Resistance (ESR) of the external
output capacitor and, to a lesser extent, the distance and series impedance to the load. Larger caps will
reduce output noise but may change the transient response. Newer ceramic caps with very low ESR may
require lower capacitor values to avoid instability. Thoroughly test your capacitors in the application. Please
refer to the Output Capacitive Load Application Note.
(15) Do not allow the input voltage to degrade lower than the input undervoltage shutdown voltage at all times.
Otherwise, you risk having the converter turn off. The undervoltage shutdown is not latching and will
attempt to recover when the input is brought back into normal operating range.
(16) The outputs are not intended to sink appreciable reverse current.
Output Voltage Adjustment
The output voltage may be adjusted over a limited range by connect-
ing an external trim resistor (Rtrim) between the Trim pin and Ground. The
Rtrim resistor must be a 1/10 Watt precision metal lm type, ±1% accuracy
or better with low temperature coefcient, ±100 ppm/°C. or better. Mount
the resistor close to the converter with very short leads or use a surface
mount trim resistor.
In the tables opposite, the calculated resistance is given. Do not exceed
the specied limits of the output voltage or the converter’s maximum power
rating when applying these resistors. Also, avoid high noise at the Trim
input. However, to prevent instability, you should never connect any capaci-
tors to Trim.
RTRIM (
:) = ____________
–5110
VOUT – 0.7525V
21070
OKX2-T/10-W5, -T/16-W5
Output Voltage
Calculated Rtrim (KΩ)
3.3 V.
3.160
2.5 V.
6.947
2.0 V.
11.780
1.8 V.
15.004
1.5 V.
23.077
1.2 V.
41.973
1.0 V.
80.021
0.7525 V.
∞ (open)
Resistor Trim Equation, W5 models:
OKX T/10 & T/16-W5 Series
Adjustable DOSA 10/16-Amp SIP DC/DC Converters
MDC_OKX_T10T16-W5 Series.A03 Page 6 of 13
www.murata-ps.com/support
Product Label
Because of the small size of these products, the product label contains a
character-reduced code to indicate the model number and manufacturing
date code. Not all items on the label are always used. Please note that the label
differs from the product photograph on page 1. Here is the layout of the label:
The label contains three rows of information:
First row – Murata Power Solutions logo
Second row – Model number product code (see table)
Third row – Manufacturing date code and revision level
The manufacturing date code is four characters:
First character – Last digit of manufacturing year, example 2009
Second character – Month code (1 through 9 and O through D)
Third character – Day code (1 through 9 = 1 to 9, 10 = O and
11 through 31 = A through Z)
Fourth character – Manufacturing information
Figure 2.
Label Artwork Layout
X00016
Product code
Mfg.
date
code
Revision level
YMDX Rev.
相關PDF資料 |
PDF描述 |
|---|---|
| OM1323SRM | SC70/µDFN, Single/Dual Low-Voltage, Low-Power µP Reset Circuits |
| OM6059SB2 | 600V Single N-Channel Hi-Rel MOSFET in a PB-3A package |
| OM9375 | 25 Amp. Push-Pull 3-Phase Brushless DC Motor Controller/Driver Module in a Power Flatpack |
| OMR117HVNH | Hi-Rel Adjustable Voltage 3-Terminal Positive Radiation Hardened Regulator |
| OMR117HVNM | Hi-Rel Adjustable Voltage 3-Terminal Positive Radiation Hardened Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OKX-T/10 | 制造商:MURATA-PS 制造商全稱:Murata Power Solutions Inc. 功能描述:Adjustable DOSA 10/16-Amp SIP DC/DC Converters |
| OKX-T/10-D12 | 制造商:Murata Power Solutions 功能描述:- Rail/Tube |
| OKX-T/10-D12N-C | 功能描述:DC/DC轉換器 12Vin 0.75-5.5Vout 10A 50W Neg logic RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| OKX-T/10-D12N-C | 制造商:Murata Power Solutions 功能描述:PSU POL SIP 10A 12 VIN NEG ON/OFF 制造商:Murata Power Solutions 功能描述:PSU, POL, SIP, 10A, 12 VIN, NEG ON/OFF 制造商:Murata Power Solutions 功能描述:PSU, POL, SIP, 10A, 12 VIN, NEG ON/OFF; DC / DC Converter Type:DOSA; DC / DC Converter Output Type:Adjustable; Input Voltage DC Min:8.3V; Input Voltage DC Max:14V; No. of Outputs:1; Output Voltage Nom.:750mV to 5.5V; Output Current ;RoHS Compliant: Yes |
| OKX-T/10-D12P-C | 功能描述:DC/DC轉換器 12Vin 0.75-5.5Vout 10A 50W Pos logic RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。