- 您現在的位置：買賣IC網 > PDF目錄361135 > NRF902 (Electronic Theatre Controls, Inc.) Single chip 868 MHz Transmitter PDF資料下載
參數資料
| 型號： | NRF902 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Single chip 868 MHz Transmitter |
| 中文描述： | 單芯片868兆赫發射機 |
| 文件頁數： | 7/13頁 |
| 文件大小： | 160K |
| 代理商： | NRF902 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁
PRELIMINARY PRODUCT SPECIFICATION
nRF902 Single chip 868 MHz Transmitter
Nordic VLSI ASA - Vestre Rosten 81, N-7075 Tiller, Norway - Phone +4772898900 - Fax +4772898989
Revision: 1.0
Page 7 of 13
April 2000
ASK modulation.
ASK modulation can be realised by using the REXT pin (see Figure 8). When R2 is
connected to VDD, the chip transmits a carrier. When the bias resistor is connected to
VSS then the internal output power amplifier is turned off. These two situations
represent logic ‘1’ and logic ‘0’ in an ASK system. When ASK modulation is used,
the FSK pin must be connected to VDD.
Matching Network/
Antenna
X1 13.567MHz
REXT
xtal
XO8
VDD
1
2
3
4
VDD
R2
R1
Clock
Output
FSK
VSS
8
ant1
Data
Input
ant2
VDD
7
6
5
C1
C2
VDD
nRF902
Figure 8. FSK transmitter in ASK Transmit mode
Antenna output
The “ant” output pins provide a balanced RF output to the antenna. The pins must
have a DC path to V
DD
, either via a RF choke or via the centre point in a loop antenna.
The load impedance seen between the ant1/ant2 outputs should be in the range 200-
700
. A load impedance of 400
is recommended if maximum output power
(10dBm) is needed. Lower load impedance (for instance 50
) can be obtained by
fitting a simple matching network or a RF transformer (balun). The 50
load can
also be connected directly between the ant1/ant2 pins, but this will result in higher
current consumption for a given output power to the antenna.
Note: Application notes of antenna layout solutions with matching networks will soon
be available on our website:
http://www.nvlsi.no.
相關PDF資料 |
PDF描述 |
|---|---|
| NRF9E5-EVKIT868 | 433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
| NRF9E5-EVKIT433 | 433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
| NRF9E5-EVKIT915 | 433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
| NRF9E5IC | 433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
| NRN9S104JTS | SINGLE-IN-LINE SIP RESISTOR NETWORKS CONFORMAL COATED LOW PROFILE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NRF903 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Evaluation board |
| NRF903G | 制造商:Nordic Semiconductor 功能描述: |
| NRF903G-REEL | 制造商:Nordic Semiconductor 功能描述: |
| NRF904 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Wireless Component application notes/nRF904， RF and Antenna Layout |
| nRF905 | 功能描述:射頻收發器 1.9-3.6V 433/868/ 915MHz TRNSCVR RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。