- 您現在的位置：買賣IC網 > PDF目錄361135 > NRF2401A-EVKIT (Electronic Theatre Controls, Inc.) Single chip 2.4 GHz Transceiver PDF資料下載
參數資料
| 型號： | NRF2401A-EVKIT |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Single chip 2.4 GHz Transceiver |
| 中文描述： | 單片2.4GHz無線收發 |
| 文件頁數： | 13/38頁 |
| 文件大?。?/td> | 263K |
| 代理商： | NRF2401A-EVKIT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
PRODUCT SPECIFICATION
nRF2401A Single Chip 2.4 GHz Radio Transceiver
DuoCeiver Simultaneous Two Channel Receive Mode
In both ShockBurst & direct modes the nRF2401A can facilitate simultaneous
reception of two parallel independent frequency channels at the maximum data rate.
This means:
nRF2401A can receive data from two 1 Mbps transmitters (ex: nRF2401A
or nRF2402) 8 MHz (8 frequency channels) apart through one antenna
interface.
The output from the two data channels is fed to two separate MCU
interfaces.
Data channel 1: CLK1, DATA, and DR1
Data channel 2: CLK2, DOUT2, and DR2
DR1 and DR2 are available only in ShockBurst.
The nRF2401A DuoCeiver technology provides 2 separate dedicated data channels
for RX and replaces the need for two, stand alone receiver systems.
Nordic Semiconductor ASA - Vestre Rosten 81, N-7075 Tiller, Norway -
Revision: 1.0
Phone +4772898900
-
Fax +4772898989
December 2004
Page 13 of 38
nRF2401A
Tx/Rx
nRF2401A
Tx/Rx
nRF2401A
Tx
/
Rx
Figure 8 Simultaneous 2 channel receive on nRF2401A
There is one absolute requirement for using the second data channel. For the
nRF2401A to be able to receive at the second data channel the frequency channel
must be 8MHz higher than the frequency of data channel 1. The nRF2401A must be
programmed to receive at the frequency of data channel 1. No time multiplexing is
used in nRF2401A to fulfil this function. In direct mode the MCU must be able to
handle two simultaneously incoming data packets if it is not multiplexing between the
two data channels. In ShockBurst it is possible for the MCU to clock out one data
channel at a time while data on the other data channel waits for MCU availability,
without any lost data packets, and by doing so reduce the needed performance of the
MCU.
F
RF1
F
RF2
=F
RF1
+8MHz
Clock
Recovery,
DataSlicer
ADDR,
CRC
Check
Clock
Recovery,
DataSlicer
ADDR,
CRC
Check
DR1
CLK1
DATA
DR2
CLK2
DOUT2
Data(F
RF1
)
Data(F
RF2
)
Figure 9 DuoCeiver
TM
with two simultaneously independent receive channels.
相關PDF資料 |
PDF描述 |
|---|---|
| NRF2401AG | Single chip 2.4 GHz Transceiver |
| NRF2402 | Single chip 2.4 GHz Transmitter |
| NRF2402G | Single chip 2.4 GHz Transmitter |
| NRF902 | Single chip 868 MHz Transmitter |
| NRF9E5-EVKIT868 | 433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| nRF2401AG | 功能描述:射頻收發器 1.9-3.6V 1MBIT XCVR 2.4GHz SHCKBRST RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| nRF2401AG-REEL | 功能描述:射頻收發器 1.9-3.6V 1MBIT XCVR 2.4GHz SHCKBRST RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| nRF2401AG-REEL7 | 功能描述:射頻收發器 1.9-3.6V 1MBIT XCVR 2.4GHz SHCKBRST RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| NRF2401-AREEL | 制造商:Nordic Semiconductor 功能描述: |
| NRF2401-EVKIT | 制造商:Nordic Semiconductor 功能描述:2X BOARDS + 2 WHIP ANT. 2.4GHZ 制造商:Nordic Semiconductor 功能描述:EVALUATION KIT |
發布緊急采購，3分鐘左右您將得到回復。