- 您現在的位置：買賣IC網 > PDF目錄359243 > MVTX2804 (Zarlink Semiconductor Inc.) 8-Port 1000 Mbps Ethernet Distributed Switch PDF資料下載
參數資料
| 型號： | MVTX2804 |
| 廠商： | Zarlink Semiconductor Inc. |
| 英文描述： | 8-Port 1000 Mbps Ethernet Distributed Switch |
| 中文描述： | 8端口1000 Mbps以太網交換機分布式 |
| 文件頁數： | 16/174頁 |
| 文件大?。?/td> | 2249K |
| 代理商： | MVTX2804 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁
MVTX2804
Data Sheet
16
Zarlink Semiconductor Inc.
1.0 Block Functionality
1.1 Frame Data Buffer (FDB) Interfaces
The FDB interface supports pipelined ZBT-SRAM memory at 133 MHz. To ensure a non-blocking switch, two
memory domains are required. Each domain has a 64-bit wide memory bus. At 133 MHz, the aggregate
memory bandwidth is 17 Gbps, which is enough to support 8 Gigabit ports at full wire speed switching. A patent
pending scheme is used to access the FDB memory. Each slot has one tick to read or write 8 bytes.
1.2 Switch Database (SDB) Interface
A pipelined synchronous burst SRAM (SBRAM) memory is used to store the switch database information
including MAC Table, VLAN Table and IP Multicast Table. Search Engine accesses the switch database via
SDB interface. The SDB memory has 32-bit wide bus at 133MHz.
1.3 GMII/PCS MAC Module (GMAC)
The GMII/PCS Media Access Control (MAC) module provides the necessary buffers and control interface
between the Frame Engine (FE) and the external physical device (PHY). The MVTX2804 has two interfaces,
GMII or PCS. The MAC of the MVTX2804 meets the IEEE 802.3z specification and supports the MII interface. It
is able to operate in 10M/100M/1G in Full Duplex mode with a flow control mechanism. It has the options to
insert Source Address/CRC/VLAN ID to each frame. The GMII/PCS Module also supports hot plug detection.
1.4 CPU Interface Module
One extra port is dedicated to the CPU via the CPU interface module. The CPU interface utilizes a 16/8-bit bus
in managed mode. It also supports a serial and an I
2
C interface, which provides an easy way to configure the
system if unmanaged.
1.5 Management Module
The CPU can send a control frame to access or configure the internal network management database. The
Management Module decodes the control frame and executes the functions requested by the CPU.
1.6 Frame Engine
The main function of the frame engine is to forward a frame to its proper destination port or ports. When a frame
arrives, the frame engine parses the frame header (64 bytes) and formulates a switching request, which is sent
to the search engine to resolve the destination port. The arriving frame is moved to the FDB. After receiving a
switch response from the search engine, the frame engine performs transmission scheduling based on the
frame's priority. The frame engine forwards the frame to the MAC module when the frame is ready to be sent.
1.7 Search Engine
The Search Engine resolves the frame's destination port or ports according to the destination MAC address (L2)
or IP multicast address (IP multicast packet) by searching the database. It also performs MAC learning, priority
assignment, and trunking functions.
1.8 LED Interface
The LED interface can be operated in a serial mode or a parallel mode. In the serial mode, the LED interface
uses 3 pins for carrying 8 port status signals. In the parallel mode, the interface can drive LEDs by 8 status pins.
The LED port is shared with bootstrap pins. In order to avoid mis-reading a buffer must be used to isolate the
LED circuitry from the bootstrap pins during bootstrap cycle (the bootstraps are sampled at the rising edge of
the #Reset).
相關PDF資料 |
PDF描述 |
|---|---|
| MVTX2804AG | 8-Port 1000 Mbps Ethernet Distributed Switch |
| MVV200 | Analog IC |
| MW005A | DC-to-DC Voltage Converter |
| MW005AJ | DC-to-DC Voltage Converter |
| MW005AJ4 | DC-to-DC Voltage Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MVTX2804AG | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:8-Port 1000 Mbps Ethernet Distributed Switch |
| MVTX2804AG2 | 制造商:Microsemi Corporation 功能描述: |
| MVU10-10FBK | 功能描述:端子 D-10-1103K BS-33-10-P 85299 RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp |
| MVU10-10FBX | 功能描述:端子 BLOCK FORK VNYL INS BTL BS-33-10-P RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp |
| MVU10-10FBX-BOTTLE | 功能描述:CONN FORK BLOCK INSUL 50PC RoHS:是 類別:連接器，互連式 >> 端子 - 鏟形 系列:Scotchlok™ 標準包裝:1 系列:Scotchlok™ 端子類型:彈簧，壓接式 接線柱/接片尺寸:10 接線柱 寬度 - 外邊:0.320"（8.13mm） 長度 - 總體:1.030"（26.16mm） 安裝類型:自由懸掛 端子:壓接 線規:10-12 AWG 絕緣體:絕緣 特點:- 顏色:黃 包裝:散裝 觸點表面涂層:錫 觸點材料:銅，ETP 絕緣體直徑:0.250"（6.35mm） 材料 - 絕緣體:聚酰胺（PA），尼龍 長度 - 環心道末端:0.280"（7.11mm） 長度 - 末端:0.550"（13.97mm） 內部舌簧打開:- 相關產品:TR-490-ND - HAND CRIMP TOOL RACHET 10-22 AWGTH-450-ND - TOOL HAND CRIMP 6-26AWGTR-482-ND - TOOL RATCHETING 10-22AWG CRIMP920099-R-ND - TOOL 10-22AWG SCOTCHLOK CRIMP 其它名稱:000511285879115112858791180611464373 |
發布緊急采購，3分鐘左右您將得到回復。