- 您現在的位置：買賣IC網 > PDF目錄383644 > MT9074AP (Mitel Networks Corporation) T1/E1/J1 Single Chip Transceiver PDF資料下載
參數資料
| 型號： | MT9074AP |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | T1/E1/J1 Single Chip Transceiver |
| 中文描述： | T1/E1/J1收發單芯片收發器 |
| 文件頁數： | 3/122頁 |
| 文件大?。?/td> | 372K |
| 代理商： | MT9074AP |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁
Advance Information
MT9074
3
Pin Description
Pin #
Name
Description
68 Pin
PLCC
100 Pin
MQFP
1
66
OSC1
Oscillator Input.
This pin is either connected via a 20.000 MHz crystal to OSC2
where a crystal is used, or is directly driven when a 20.000 MHz. oscillator is
employed
.
2
67
OSC2
Oscillator Output.
Connect a 20.0 MHz crystal between OSC1 and OSC2. Not
suitable for driving other devices.
3
68
V
SS
V
DD
CSTo
Negative Power Supply (Input).
Digital ground.
4
69
Positive Power Supply (Input).
Digital supply (+5V
±
5%).
5
70
Control ST-BUS Output.
CSTo carries serial streams for CAS and CCS
respectively a 2.048 Mbit/s ST-BUS status stream which contains the 30 receive
signalling nibbles (ABCDZZZZ or ZZZZABCD). The most significant nibbles of
each ST-BUS time slot are valid and the least significant nibbles of each ST-BUS
time slot are tristated when control bit MSN (page 01H, address 1AH, bit 1) is set
to 1. If MSN=0, the position of the valid and tristated nibbles are reversed.
6
71
CSTi
Control ST-BUS Input.
CSTi carries serial streams for CAS and CCS respectively
a 2.048 Mbit/s ST-BUS control stream which contains the 30 transmit signalling
nibbles (ABCDXXXX or XXXXABCD) when RPSIG=0. When RPSIG=1 this pin
has no function. The most significant nibbles of each ST-BUS time slot are valid
and the least significant nibbles of each ST-BUS time slot are ignored when control
bit MSN (page 01H, address 1AH, bit 1) is set to 1. If MSN=0, the position of the
valid and ignored nibbles is reversed.
7
72
DSTo
Data ST-BUS Output.
A 2.048 Mbit/s serial stream which contains the 24/30
PCM(T1/E1) or data channels received on the PCM 24/30 (T1/E1) line.
8
73
DSTi
Data ST-BUS Input.
A 2.048 Mbit/s serial stream which contains the 24/30 (T1/
E1)PCM or data channels to be transmitted on the PCM 24/30 (T1/E1)line.
9
74
DS/RD
Data/Read Strobe (Input)
.
In Motorola mode (DS), this input is the active low data strobe of the
microprocessor interface.
In Intel mode (RD), this input is the active low read strobe of the microprocessor
interface.
10
83
CS
Chip Select (Input)
. This active low input enables the non-multiplexed parallel
microprocessor interface of the MT9074. When CS is set to high, the
microprocessor interface is idle and all bus I/O pins will be in a high impedance
state.
11
84
RESET
RESET (Input).
This active low input puts the MT9074 in a reset condition. RESET
should be set to high for normal operation. The MT9074 should be reset after
power-up. The RESET pin must be held low for a minimum of 1
μ
sec. to reset the
device properly.
12
85
IRQ
Interrupt Request (Output)
. A low on this output pin indicates that an interrupt
request is presented. IRQ is an open drain output that should be connected to V
DD
through a pull-up resistor. An active low CS signal is not required for this pin to
function.
13 -
16
86-89
D0 - D3
Data 0 to Data 3 (Three-state I/O).
These signals combined with D4-D7 form the
bidirectional data bus of the microprocessor interface (D0 is the least significant
bit).
相關PDF資料 |
PDF描述 |
|---|---|
| MT9074 | T1/E1/J1 Single Chip Transceiver(T1/E1/J1單片收發器) |
| MT9075B | E1 Single Chip Transceiver |
| MT9075B | E1 Single Chip Transceiver(E1單片收發器) |
| MT9075 | E1 Single Chip Transceiver |
| MT9075A | E1 Single Chip Transceiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT9074AP1 | 制造商:Microsemi Corporation 功能描述:T1/E1/J1 SGLE CHIP XSCR 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Rail/Tube 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TXRX SGL T1/E1 68PLCC 制造商:Microsemi Corporation 功能描述:IC TXRX SGL T1/E1 68PLCC |
| MT9074APR | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:T1/E1/J1 Single Chip Transceiver |
| MT9074APR1 | 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Tape and Reel 制造商:Zarlink Semiconductor Inc 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Tape and Reel |
| MT9075 | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:E1 Single Chip Transceiver |
| MT9075A | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:E1 Single Chip Transceiver |
發布緊急采購，3分鐘左右您將得到回復。